汽蝕磨損 的英文怎麼說
中文拼音 [qìshímósǔn]
汽蝕磨損
英文
cavitation wear- 汽 : 名詞1. （由液體或某些固體變成的氣體） vapour2. （水蒸氣） steam
- 蝕 : Ⅰ動詞1. （損失; 虧耗） lose 2. （腐蝕） erode; corrode Ⅱ名詞（天體現象） eclipse
- 磨 : 磨動詞1 （摩擦） rub; wear 2 （研磨） grind; mull; polish 3 （折磨） grind down; wear down [out]:...
- 損 : Ⅰ動詞1 （減少） decrease; lose 2 （損害） harm; damage 3 [方言] （用尖刻的話挖苦人） speak sarcas...
- 磨損 : wear and tear; abrasive wear; abrase; abrade; detrition; wear; scuff; wear out; fray; battering; ...
-
Cavitations in foreign hydraulic turbines appear in clear water condition, so its destructive extent is not far more serious than in yellow river in our country. stronger stiffness and more agility are required for special - purpose robot for hydraulic turbine repair used in our country, especially robot for polishing after weld. foreign robot for hydraulic turbine repair could not satisfy our working require, so we develop special - purpose robot system that is used to polish and weld repair cavitated flow path surfaces of hydraulic turbines on all locations
國外水電站的水輪機汽蝕是在清水條件下產生的，其破壞程度遠不及我國黃河等水域嚴重，用於我國水輪機修復工作的專用機器人，特別是補焊后承擔打磨的機器人，要求有更強的剛度和更大的靈活性，國外水輪機修復機器人滿足不了我國水輪機修復工作要求，因此我們開發了用於在機坑內對水輪機空蝕磨損破壞表面進行修復的「水輪機修復專用機器人」 。Until now, there have been a few reports on the damage of the water pumps caused by sand and water cavitation. by use of the test loop for solid and liquid two phases, under the condition of 3 % head drop, the damage location and relative degree of the sand and water cavitaiton occurred on the impeller were tested and researched. the result was, them, compared with the results under the condition that water cavitation occurred and no cavitation but only wear occurred. the differencts were analyzed. the analysis result can be used as the basis of the further research and the improvement of the impeller shape
目前含沙水汽蝕對水泵損傷方面的報導甚少，本文利用固液兩相流試驗臺，對離心泵閉式葉輪在含沙水汽蝕時（ 3揚程下降點）的損傷部位和相對程度進行了試驗研究，並將此結果與清水介質發生汽蝕時的損傷情況[ 13 ]及含沙水無汽蝕情況下的磨損情況[ 7 ]相比較，對其差異進行了分析，為今後進一步探討葉輪損傷機理和葉型改進提供了實驗依據。The materials give excellent resistance to extremes of temperature, abrasion, exposure to oils, grease, water, steam and common industrial solvents and chemicals
能在極高/低溫度（ - 40 ~ 115 ）的環境中工作，耐磨損，能暴露于油、潤滑脂、水、水蒸汽及一般溶解腐蝕性化學物質中工作。
分享友人