汽輪發電機 的英文怎麼說

中文拼音 [qìlúnfādiànjī]
汽輪發電機 英文
steam turbogenerator; steam turbine generator; turbogenerator
  • 汽 : 名詞1. （由液體或某些固體變成的氣體） vapour2. （水蒸氣） steam
  • 輪 : Ⅰ名1 （輪子） wheel 2 （像輪子的東西） wheel like object; ring; disc 3 （輪船） steamer; steamboa...
  • 發 : 名詞（頭發） hair
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 機 : machineengine
  1. Evolutionary process and investigation survey of material for antimagnetic retaining ring forging for steam turbing generator

    汽輪發電機組無磁性護環鍛件材料的演變過程和研究概況
  2. An adaptive wavelet network classifier for vibration fault diagnosis of steam turbine - generation is proposed based on theory of adap tive wavelet network ( awn )

    基於自適應小波網路理論，構造了一個應用於汽輪發電機組振動故障診斷與識別的自適應小波網路分類器。
  3. This thesis studies the law of affecting de - noise result and the selection of the threshold and the wavelet function, the combination of wavelet and fft in the fault diagnosis of turbine - generator sets : by the de - noise anslysis of blocks and sin signals, concludes : to blocks signals, usually adopts soft threshold ; the law of affecting de - noise result is when use wavelet auto - de - noise, with the increasing of decomposed level, the de - noise result becomes worse while the level blow the 3, when the level above 3 and when uses wavelet packet, it is the other way round ; the best de - noise methods of the signal is that uses " dbl " wavelet function, three level, soft and " rigrsure " threshold

    本文研究了分解層數對消噪結果影響的規律和閾值、小波函數的選取，結合小波分析與fft分析診斷汽輪發電機組的故障。通過對brocks和sin兩信號的分析，得出：對blocks信號進行分析一般採用軟閾值；分解層數對消噪結果影響的規律為用小波自動降噪在分解層數小於3時，隨著分解層數的增加，消噪結果變好，反之，則變差，用小波包降噪時隨著分解層數的增加，消噪效果變好；適宜選用dbl小波軟rigrsure閾值自動消噪。
  4. 2 ) the program is fit for different turbogenerators. so it can be used for a wide range. 3 ) the block structure is used in the program

    4 .研究開發了適用不同型號汽輪發電機的可就不同穩態問題進行計算研究的有限元軟體。
  5. As one kind of key equipment in piping work of large - scale turbo - generator set in power plant, the machine is especially applicable to various welding bevels, flat end and angle of outer & inner diameter of ascending pipe, elbow pipe, bend, flange and etc., which greatly meets demands in pipe processing of construction site and manufacturers

    本機床是電站大型汽輪發電機組的管道施工的關鍵設備，對直管、彎管、彎頭、法蘭等管體的各種型式焊接坡口，端平面，內外徑過緩斜度及直口，能滿足施工現場和製造廠家對各種管件的加工要求。
  6. Reasons and precaution measures about lubricating oil emulsification of steam turbine generator unit

    汽輪發電機組潤滑油乳化的原因及預防措施
  7. Specification for a. c. exciter rectifier excitation system for large turbine generators

    大型汽輪發電機交流勵磁機勵磁系統技術條件
  8. This paper analyse the feasibility and necessity of examine and repair about the qiangui co. ltd of generate electricity base on the frmework of guizhou wire network and the run state and exerience of the factory. at the same time, in the base of the lucubrate and analyse of stats examine in domestic and abroad, this paper has analyse the abrupt librate of steamer generator by online data check in pancountry power plant. it acquire obvious effect and prove the applicability and feasibility about the examine in power plant by take correspond measures to ensure the normal operate of the set

    本文根據貴州電網的結構形式以及黔桂發電有限責任公司機組的運行狀況和經驗，進行了黔桂發電有限責任公司實行狀態檢修的可行性和必要性分析，同時在深入研究分析國內外狀態檢修技術基礎上，對盤縣發電廠汽輪發電機組突發振動事例用在線檢測數據進行分析、採取相應措施處理，使機組正常運行，取得了明顯的成效，同時也證明點檢與狀態檢修在火電廠的適用性和可行性。
  9. Magnetoelectricity gear method is a general torsional oscillation measurement method. it has disadvantages on less measure point and improved - needed dynamic characteristic. in the paper a new method of measuring torsional oscillation of the turbine - generator shaft was proposed on the basis of high speed ccd ( charge coupled device ) photography

    現行的扭振測量方法以磁電式齒輪測量法為主，這種方法存在測點少，動態特性有待提高的缺點，就此本文提出了一種基於高速ccd （ chargecoupleddevice ）攝像技術的汽輪發電機組軸系扭振測量的新方法。
  10. Inlet phase operation of 300 mw turbine - generators

    汽輪發電機進相運行試驗
  11. Overspeed trip systems for steam turbine - generator units

    汽輪發電機組用超速自動分離系統
  12. At the sometime, a set of backpressure turbine generator of 15mw with the inlet steam pressure of 110kg cm

    的抽凝式汽輪發電機組，一臺
  13. Fault treatment in vibration of turbo - generator unit

    汽輪發電機組振動故障處理
  14. A nonlinear unified controller design for heavy - duty turbogenerator

    大型汽輪發電機非線性綜合控制器設計
  15. Application of fuzzy clustering theory for diagnosing the vibration faults of turbogenerator units

    聚類模糊原理在汽輪發電機組振動故障中的應用
  16. The osilating monitoring and diagnosis system by using turbogenerator unit is introduced

    摘要介紹了藉助汽輪發電機組進行振動監測和故障診斷的系統。
  17. Application of fuzzy clustering analysis for the diagnosis of vibration faults of turbogenerator units

    模糊聚類分析在汽輪發電機組振動故障診斷中的應用
  18. This paper expounds the structural design and operating mode of the sealing oil system of a turbogenerator with a detailed description of its simulation - based mathematical model set up for the system

    描述了汽輪發電機密封油系統的結構及其操作方式，並重點建立了該系統的模擬數學模型。
  19. This paper briefly introduces the raw material and manufacturing process used for rotor slot insulation home - production for air cooled turbo generator with abb technology of switzerland

    簡要介紹了我公司引進瑞士abb公司的空冷汽輪發電機轉子槽絕緣製造國產化所採用的材料及生產工藝。
  20. Abstract : this paper briefly introduces the raw material and manufacturing process used for rotor slot insulation home - production for air cooled turbo generator with abb technology of switzerland

    文摘:簡要介紹了我公司引進瑞士abb公司的空冷汽輪發電機轉子槽絕緣製造國產化所採用的材料及生產工藝。
分享友人
分享到 Line

分享到臉書