汽閥控制器 的英文怎麼說
中文拼音 [qìfákòngzhìqì]
汽閥控制器
英文
steam-valve controller- 汽 : 名詞1. (由液體或某些固體變成的氣體) vapour2. (水蒸氣) steam
- 閥 : 名詞1 (指在某方面有支配勢力的人物或家族) established house or power group; a powerful person or...
- 控 : 動詞1 (告發;控告) accuse; charge 2 (控制) control; dominate 3 (使容器口兒朝下 讓裏面的液體慢...
- 制 : Ⅰ動詞1 (製造) make; manufacture 2 (擬訂; 規定) draw up; establish 3 (用強力約束; 限定; 管束...
- 器 : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
- 控制器 : controller; regulator; monitor; pilot; keyer; manipulator; control unit; control device; [自動化]...
- 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
-
The company takes advantage of advanced dcs control system, high efficient float valve tray technology, high efficient energy - saving exchange techniques, fcc catalytic cracking double riser, two - generator regeneration process, polypropylene with loop reactor process and refining and blending process of high - number gasoline, etc. to ensure providing the users with high - tech qualified products
公司採用先進的dcs控制系統,高效的浮閥塔盤技術,高效節能交換技術, fcc催化裂化雙提升管、兩器再生工藝,環管聚丙烯工藝,高排號汽油精製調和工藝等,確保高科技合格產品送至用戶手中。For example, the general system loop for a steam autoclave under computer control could consist of temperature / pressure sensors connected to a microprocessor which transmits commands to steam / vacuum control valves
例如,計算機控制的蒸汽高壓滅菌器的常規系統迴路包括,連接到微處理器的溫度/壓力傳感器,來把命令傳遞給蒸汽/真空控制閥。3 beautiful cars control zhejiang systematic limited company is the core company that 3 flowers control a group automobile industry, be located in development of hangzhou economy technology garden of 3 gardeners course of study, cover an area of nearly 200 thousand m2, it is one takes the lead in rolling out aluminous reservoir in home, air conditioning of main production car expands a powerful person, reservoir the large - scale joint ventures of component of air conditioning of car of breed of hundreds kinds of two old series, norms, have of all kinds stuff now 800 more than person, year productivity amounts to 7 million, sale amounted to 160 million rmb 2006
浙江三花汽車控制系統有限公司是三花控股集團汽車產業的核心企業,坐落在杭州經濟技術開發區三花工業園,佔地近20萬m2 ,是一家在國內率先推出鋁儲液器,主要生產汽車空調膨脹閥、儲液器兩大系列、數百種規格品種汽車空調部件的大型合資企業,現擁有各類員工800餘人,年生產能力達700萬套, 2006年銷售額達1 . 6億人民幣。This company have been engaging manily in saling some n & h technology facilities which was provided by foreign corporation to the plant in some sector such as sinopec, petrochina, cnooc and power generation etc., and was a unique representative in china of some famous trademark including steam turbine, compressor, valve, pressure transmitor, flow - meter, level - meter and control system etc
我公司主要從事國外進口機械、電氣、儀表等高新技術設備在國內石化、石油、海油、電力等行業的銷售推廣等業務,並且是一些知名品牌的汽輪機、壓縮機、閥門、壓力變送器、流量計、液位計、控制系統在中國的唯一指定代理。The condensation heat - exchange characteristic of a separate - type heat - pipe was studied on a 1 : 1 model. the heat pipe is heated by electricity, and working fluid is distilled water, and it is cooled by air. the experimental results show that, ( 1 ) when charging liquid ratio is 45 %, condensation heat - exchange coefficient reaches to maxium ; ( 2 ) when there is not non - condensing gas, the coeffcient decreases a little with the increase of vapour pressure, and it decreases by 9. 5 % when the pressure increases from 0. 16mpa to 0. 36mpa ; ( 3 ) when there is non - condensing gas, the coefficient decreases a little, but when the gas is discharged by an exhaust value, it can be improved, when the volume content of the gas is 2. 5 %, it can increased by 22 % ; ( 4 ) the effect of the non - condensing gas on the coefficient decreases with the increase of the pressure, and when the volume content of the gas is 5 % and the pressure increases from 0. 16mpa to 0. 36mpa, the coefficient increases by 6 %. the relative curves are given between condensation heat - exchange coefficient and air flowrate, charging liquid ratio and vapour pressure
建立了空氣冷卻實驗臺,熱管的加熱方式為電加熱,工質為蒸餾水.在1 1模型上對分離式熱管管內凝結換熱特性、不凝性氣體對凝結換熱的影響及不凝性氣體的擴散規律進行了試驗,得出分離式熱管有一最佳充液率,其值為45 %左右;凝結換熱系數隨著蒸汽壓力的增加略有降低,在實驗的壓力范圍內,降低了9 . 5 % ;不凝性氣體對分離式熱管的凝結換熱僅影響冷凝段下部較小部分,通過排氣閥排出不凝性氣體可有效地改善冷凝段下部的凝結換熱;隨著壓力的增加,不凝性氣體對分離式熱管冷凝段的影響減少.這些結論可用於分離式熱管換熱器的工程設計和控制Abstract : the condensation heat - exchange characteristic of a separate - type heat - pipe was studied on a 1 : 1 model. the heat pipe is heated by electricity, and working fluid is distilled water, and it is cooled by air. the experimental results show that, ( 1 ) when charging liquid ratio is 45 %, condensation heat - exchange coefficient reaches to maxium ; ( 2 ) when there is not non - condensing gas, the coeffcient decreases a little with the increase of vapour pressure, and it decreases by 9. 5 % when the pressure increases from 0. 16mpa to 0. 36mpa ; ( 3 ) when there is non - condensing gas, the coefficient decreases a little, but when the gas is discharged by an exhaust value, it can be improved, when the volume content of the gas is 2. 5 %, it can increased by 22 % ; ( 4 ) the effect of the non - condensing gas on the coefficient decreases with the increase of the pressure, and when the volume content of the gas is 5 % and the pressure increases from 0. 16mpa to 0. 36mpa, the coefficient increases by 6 %. the relative curves are given between condensation heat - exchange coefficient and air flowrate, charging liquid ratio and vapour pressure
文摘:建立了空氣冷卻實驗臺,熱管的加熱方式為電加熱,工質為蒸餾水.在1 1模型上對分離式熱管管內凝結換熱特性、不凝性氣體對凝結換熱的影響及不凝性氣體的擴散規律進行了試驗,得出分離式熱管有一最佳充液率,其值為45 %左右;凝結換熱系數隨著蒸汽壓力的增加略有降低,在實驗的壓力范圍內,降低了9 . 5 % ;不凝性氣體對分離式熱管的凝結換熱僅影響冷凝段下部較小部分,通過排氣閥排出不凝性氣體可有效地改善冷凝段下部的凝結換熱;隨著壓力的增加,不凝性氣體對分離式熱管冷凝段的影響減少.這些結論可用於分離式熱管換熱器的工程設計和控制This equipment is for general assembly of clutch pressure plate assembly and calibration of diaphragm finger ; the whole machine is driven by compressed air and air cylinder is controlled by electromagnetic valve by finishing multiple functions ; this equipment divides into two basic types for light - duty and heavy - duty, it also can be made into light & heavy duty equipment according to user ' s request
本設備用於汽車離合器壓盤總成的總裝和膜片分離指的校正;設備動力用壓縮空氣,執行元件用電磁閥控制氣缸以完成多項功能;本設備分輕型及重型兩種基本型號,也可按照用戶要求,將輕型與重型做成雙工位設備。分享友人