沉陷速率 的英文怎麼說

中文拼音 [chénxiànsùlǜ]
沉陷速率 英文
rate of sinking
  • 沉 : Ⅰ動詞1 （沉沒; 墜落） sink 2 （沉下 多指抽象事物） keep down; lower 3 [方言] （停止） rest Ⅱ形容...
  • 陷 : Ⅰ名詞1 （陷阱） pitfall; trap2 （缺點） defect; deficiency Ⅱ動詞1 （掉進） get stuck or bogged do...
  • 速 : Ⅰ形容詞（迅速; 快） fast; rapid; quick; speedy Ⅱ名詞1 （速度） speed; velocity 2 （姓氏） a surna...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 沉陷 : 1. （下陷） sink; cave in 2. （沉降） sinkage; downpunching; depression; subsidence; [建築] settlement
  • 速率 : speed; rate; tempo
  1. The paper has chosen shen95 block of liaohe basin and ascertained the evolutive velocity of structural unit of deposital system

    本論文選取遼河盆地大民屯凹陷北部沙河街組，在磁性地層研究的基礎上，確定沉積體系構成單元的演化速率。
  2. The basin - formed mechanism, evolution model and petroliferous geological features of compresso - shear basins in the world are analyzed, by which six aspects of the features are summarized as follows : 1 ) in the compresso - shear process, the sedimentary speed of basin is high, forming thicker coarse - grained clastic rocks which normally shape good petroleum reservoir ; 2 ) the source rocks of basin tend to coming from the organic matter - enriched rocks formed in pre - compresso - shear stages, except that in intense compresso - shear process, deep water - semi deep water source rocks are possibly developed in pre - compresso - shear stages, e4xcept that in intense compresso - shear process, deep water - semi deep water source rocks are possibly developed in frontal of deep depression ( fore deep ) of thrust belt ; 3 ) the en echelon folds ( including anticline and fault - nose structure ) are generally as good oil traps ; 4 ) the compresso - shear process is helpful to hydrocarbon accumulation ; 5 ) it may promote the maturity and hydrocarbon - generating process of organic matte, and 6 ) the thrust belts in the surrounding areas of compresso - shear basin are favorable are favorable domains for petroleum concentration

    摘要通過對世界上壓扭性盆地的成盆機制、演化模式和油氣地質特點分析，總結壓扭性盆地具有6個方面的石油地質特徵：壓扭作用期間盆地的沉積速率較高，一般形成較厚的粗碎屑沉積，它們常構成很好的油氣儲集層：盆地的烴源巖往住來自於前壓扭期砂成的富含有機質的巖石，但在強烈的壓扭作用期間，在沖斷帶的前緣深坳陷（前淵）中有可能發育深水半深水相的烴源巖；壓扭（張扭）作用期間形成的雁行式褶皺（包括背斜和斷鼻等）往住是很好的油氣圈閉；壓扭作用易於成藏；壓扭作用可以促進有機質的成熟生烴作用；壓扭性盆地的周邊沖斷帶是油氣賦存的有利部位。
  3. Compared to the basins in east guangxi, the basin of north guangxi is characterized by lower depositional and tectonic subsidence rate during rifting, longer thermal subsidence, later inflexion point from rifting to foreland buckling, as well as later inflexion point separating stable stage from active stage during foreland - buckling

    但與桂東大瑤山地區相比，桂北興安地區在裂陷階段的沉積速率和構造沉降速率明顯偏低；熱沉降階段的持續時間偏長；裂陷階段與前陸撓曲階段的分界拐點偏晚；前陸撓曲階段，由構造寧靜期的緩慢沉降向構造活動期的快速沉降轉化的分界拐點也偏晚。
  4. Based on the deposital velocity of the magnetic strata unit, the paper has worked out the velocity of the genetic unit of the basin utilizing the vertically evolutive map

    以磁性地層單元內的沉積速率為基礎，結合靜43 - 67井的垂向沉積相演化圖，計算出斷陷湖盆成因相的沉積速率。
  5. It was shown that salt expansion value of low liquid - limit clay was accumulated before the sixth freezing and thawing cycles, but the increment of salt expansion was reduced gradually with increasing cycles ; the salt expansion accumulation of low liquid - limit clay could be separated into three phases ; the deformation of clayey sand was mostly frost heave and subsidence under cycles, and collapsibility value of clayey sand was accumulated with increasing cycles ; the variation of salt expansion ratio and collapsibility ratio was a parabolic function of freezing and thawing cycles

    試驗結果表明：低液限粘土前五次凍融循環過程中鹽脹具有較好累加性，隨著凍融循環次數的增加，鹽脹量增長速度逐漸降低；含砂低液限粘土的鹽脹過程可以被分為三個階段；粘土質砂在凍融循環過程中的變形主要為凍脹和沉降變形，具有較好的溶陷累加性；低液限粘土、含砂低液限粘土的鹽脹率和粘土質砂的溶陷率與凍融周期之間的關系符合二次拋物線變化規律。
  6. At lower growth temperature, the lower extracting rate of carbon atoms from catalyst particles due to the lower activity of the catalysts resulted in more defects formed in carbon nanotubes. moreover, the lower transportation rate of carbon atoms in catalyst particles also made lots of carbon atoms deposited on the surfaces of grown carbon nanotubes, or on carbon wrapped catalyst particles, even to form amorphous carbon layers

    在較低溫度時，由於催化劑的活性較低，導致石墨面在生長過程中引入的缺陷較多；另一方面，碳原子在催化劑顆粒內遷移速率較低，使得多餘的游離態碳原子（或原子團）可能在納米碳管表面以非晶形式沉積，或者包覆催化劑使其「中毒」失去催化活性，或者直接形成非晶的碳納米顆粒。
分享友人
分享到 Line

分享到臉書