油壓第器 的英文怎麼說

中文拼音 [yóu]
油壓第器 英文
oilpressureregulator
  • : Ⅰ名詞1 (脂肪; 油脂) oil; fat; grease 2 (姓氏) a surname Ⅱ動詞1 (用桐油、油漆等塗抹) apply t...
  • : 壓構詞成分。
  • : Ⅰ助詞(用在整數的數詞前 表示次序) auxiliary word for ordinal numbers Ⅱ名詞1 [書面語] (科第) gr...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 油壓 : [機械工程] oil pressure
  1. Power transformer and reactor fittings - part 2 : gas and oil actuated relay for liquid immersed transformers and reactors with conservator

    功率變和電抗配件.2部分:帶存箱的液浸式變和電抗用氣動和動繼電
  2. Power transformer and reactor fittings - part 2 : gas and oil actuated relay for liquid immersed transformers and reactors with conservator ; german version en 50216 - 2 : 2002

    電力變和電抗配件.2部分:帶枕的液體浸沒式
  3. Full - flow lubricating oil filters for internal combustion engines - method of test for static burst pressure

    內燃機用全流式潤滑過濾.6部分:靜態爆裂力的試驗方法
  4. Methods of test for full - flow lubricating oil filters for internal combustion engines. part 6 : static burst pressure test

    內燃機用全流量潤滑過濾的試驗方法.6部分:靜態爆裂力試驗
  5. Guide for diagnostic field testing of electric power apparatus - part 1 : oil filled power transformers, regulators, and reactors

    電力設備的診斷現場試驗指南.1部分:充電力變調節和電抗
  6. Guide for diagnostic field testing of electrical power apparatus - part 1 : oil filled power transformers, regulators, and reactors

    電力裝置鑒別現場試驗指南.1部分:浸式電力變,調節和電抗
  7. Thirdly, pre - euro diesel vehicles of vehicle weight over 4 tonnes and with body types of concrete mixer, gully emptier, lorry crane or pressure tanker, except those issued with a cross - boundary road permit, will have to be installed with emission reduction devices

    三項措施是規定重逾四公噸的歐盟前期重型柴車輛(跨境長怠速車輛除外)而其登記車身類型為混凝土車、溝渠清潔車、機動式起重吊車或縮缸車,必須安裝減少排放物件。
  8. Fuel filters, strainers and sedimentors for compression - ignition engines - methods of test

    縮點火發動機燃粗濾和沉澱.1部分:試驗方法
  9. Basic safety publication ; environmental testing ; part 2 : tests methods ; test a : cold

    內燃機全流式機濾清試驗方法5部分:冷起動模擬和液脈沖耐久試驗
  10. The second chapter simply introduces the development of alternate asynchronous inverter technology and retrospects some types of energy - saving systems for hydraulic elevators. then the working principles of the project are discussed and analyzed at four different working status, i. e. light load upwards, heavy load upwards, light load downwards and heavy load downwards. and the chapter focus on the introduction of structure design of pump station, calculation and type selection of pump / motor reversible units, research on oil leakage principles of accumulator circuit, design of accumulator - pump / motor pressure - energy transformer and integrated valve blocks, etc. the last but not the least, the electrical wiring of vector inverter control cabin and design of computer control and data acquisition system are introduced

    論文二章首先簡單介紹了交流異步電動機變頻調速技術的發展概況,在回顧電梯液控制系統節能技術的基礎上,介紹了本課題研製的「採用蓄能的液電梯變頻節能控制系統研究」的基本原理,分析了動力系統在電梯轎廂輕載上下行、重載上下行等四種典型工況下的基本工作狀態和工作方式;詳細地介紹了本課題節能系統液動力泵站的結構設計和參數設計,重點研究了液動力泵站的結構設計、液泵馬達可逆性問題及其選型設計計算、蓄能迴路泄漏損失機理的研究及其補償裝置的設計、蓄能-泵馬達力能量轉換裝置的設計、多功能集成控制閥組的設計等內容;最後簡單介紹了本課題矢量控制變頻控制櫃的外部附件電氣接線、計算機控制及數據採集系統的硬體設計等內容。
  11. The fast - ignition technique is more like a petrol engine : first the fuel is compressed and only then is it ignited by a second laser pulse ? acting as a spark plug ? that is fired through a hole in the pellet

    快速點燃法更象汽發動機:首先縮燃料,此後才通過燃料球上的一個小孔,用二的激光脈沖發射發射激光? ?起點火的作用? ?將其點燃。
  12. Fuel filters for compression ignition engines ; form b ; head connections

    縮點火機b型燃過濾.3部分:機頭連接件
  13. Basic safety publication ; environmental testing ; part 2 : tests methods ; test b : dry heat

    內燃機全流式機濾清試驗方法6部分:靜耐破度試驗
  14. Full - flow lubricating oil filters for internal combustion engines - methods of test for resistance to high differential pressure and to elevated temperature

    內燃機滿流式潤滑過濾.3部分:耐高差和耐高溫性能試驗方法
  15. Methods of test for full - flow lubricating oil filters for internal combustion engines. part 3 : resistance to high pressure drop and to elevated temperature

    內燃機用全流量潤滑過濾的試驗方法.3部分:耐高降和耐高溫性能
  16. Lamp caps and holders together with gauges for the control and safety ; part 2 : lampholders iec 61 - 2 : 1969 supplements 2e : 1977 to 2k : 1992, modified

    內燃機全流式機濾清試驗方法3部分:耐高差和耐高溫特性
  17. Methods of test for full - flow lubricating oil filters for internal combustion engines - part 3 : resistance to high differential pressure and to elevated temperature

    內燃機全流式機濾清試驗方法3部分:耐高差和耐高溫特性
  18. Fuel filters for automotive compression ignition engines ; part 1 : test methods

    汽車燃式發動機的燃濾清.1部分:試驗方法
  19. Safety of power transformers, power supply units and similar devices - part 2 - 3 : particular requirements for ignition transformers for gas and oil burners

    電力變供電設備及類似設備的安全.2 - 3部分:燃氣及燃燃燒用點火變的特殊要求
  20. Methods of test for full - flow lubricating oil filters for internal combustion engines - part 1 : differential pressure flow characteristics

    內燃機全流式機濾清試驗方法1部分:差-流量特性
分享友人