油膜潤滑 的英文怎麼說

中文拼音 [yóumórùngǔ]
油膜潤滑 英文
film lulbrication
  • 油 : Ⅰ名詞1 （脂肪; 油脂） oil; fat; grease 2 （姓氏） a surname Ⅱ動詞1 （用桐油、油漆等塗抹） apply t...
  • 膜 : 名詞1. [生物學] （像薄皮的組織） membrane 2. （像膜的薄皮） film; thin coating
  • 潤 : Ⅰ形容詞（細膩光滑; 滋潤） moist; smooth; sleek Ⅱ動詞1 （加油或水 使不幹枯） moisten; lubricate 2 ...
  • 滑 : Ⅰ形容詞1 （光滑; 滑溜） slippery; smooth 2 （油滑; 狡詐） cunning; crafty; slippery Ⅱ動詞（貼著物...
  • 潤滑 : [機械工程] lubricating; lubrication; lubricate
  1. Abstract : in this paper, an analytical study of the dynamics of the piston in a reciprocating internal combustion engine is conducted. the equations of reynolds and moving of piston are derived. a useful method of solution is obtained. the method is applied to s1100 diesel engine. the results of this study indicate that piston oil film is found to be sensitive to the piston - cylinder bore clearance, the location of the wrist pin and lubricant viscosity

    文摘:對往復式內燃機活塞的動力特性進行了分析研究，導出了活塞潤滑的雷諾方程和活塞運動方程，給出了可供實用的求解方法，並採用這種計算方法對s1100柴油機進行了設計計算與試驗研究.研究結果表明，活塞潤滑油膜歷程與活塞& &缸套的間隙、活塞銷的位置、潤滑油的粘度等因素密切相關
  2. Ma yan ? ying, liu jia ? qi. experimental investigation of oil film of port plate / cylinder block in axial piston pump j. lubrication engineering, 1999, 3 : 3539

    鄭煒， ?有雄，魯寶香.軸向柱塞泵配流副油膜的實驗研究j .潤滑與密封， 1995 ， 5 ： 3739
  3. As a new type gear transmission, double circular arc profile bevel gearing carries out its transmission by means of meshing between convex - concave tooth profile in both of the direction of tooth trace and the direction of tooth depth, so it has advantage of high load capacity, long service life, easy forming hydrodynamic oil film between teeth as well as high quality of running - in etc. therefore, more attention has been paid to its application and research in recent years

    作為一種新型齒輪傳動方式，雙圓弧弧齒錐齒輪傳動不論在齒線方向、還是在齒高方向，均為凸、凹齒廓相嚙合，因而它比一般的弧齒錐齒輪傳動的承載能力高，使用壽命長；並且在嚙合過程中兩齒面間容易形成潤滑油膜，具有良好的跑合性能，所以對它的應用和研究日益受到人們的重視。
  4. This product contains teflon formula, with outstanding permeation effect, can forms a dry - translucent thin film, causes a long - term lubrication effet, is not greasy, but dustproof

    本產品含鐵氟龍配方，具滲透效果並形成乾式半明薄膜，能使物件長期潤滑，但是不會油膩，同時不會粘附灰塵。
  5. Film strength ability of a film of lubricants to resist rupture due to load speed and temperature

    油膜強度潤滑油油膜抵抗因負荷、速度和溫度而造成破裂的能力。
  6. Preparation of silicone polymer membrane for separation of solvents from lube oil

    分離潤滑油中脫蠟溶劑的有機硅膜的制備
  7. Molybdenum disulphide dry lubricants - coating methods

    二硫化鉬基幹膜潤滑油.塗覆法
  8. Then we can estimate the lubrication state between the friction faces. with the old large numbers of testing numbers the wear parameter k of every point on the steady work ' s cam can be decided

    通過計算凸輪表面各位置潤滑油膜厚度，判斷其潤滑狀態，結合以前大量的實驗數據，確定出凸輪各位置在穩態下工作時的磨損系數k值。
  9. Furthermore, it can be used as lubricant for cosmetics, isolating agent and softening agent for rubber, antiquing agent for textile industry, smoothing agent for paint

    可作為塑料製品的潤滑劑和脫模劑；橡膠製品的軟化劑和隔膜劑；在聚酯油漆中廣泛用作防沉和平光劑；在造紙業中用作平面劑和脫毛劑。
  10. 3 ) based on the analysis result of equal contact stress curve and the theory of elasto - hydrodynamic lubrication, the expression of the oil film thickness between roller ( or ball ) and orbit are calculated. the simulation result proved that the thickness of oil film is enough for bearing and lubricating

    （ 3 ）基於等接觸應力曲線的求解結果和彈性流體動力潤滑理論，求得滾動體和軌道曲線間的油膜厚度表達式，並通過模擬分析論證了馬達正常工作時這種油膜能滿足承載能力和潤滑的需要。
  11. Chapter two constructed the mathematical model of robot and its environment solved by the fem analysis. the functions or relations between the robotic parameters and its drive forces, thickness or its velocities were given, and also the functions or relations between the environment and the robot force, friction, robot velocity, minimum thickness of film or sustain force of dynamic films were given

    論文第二章通過建立機器人和環境的數學模型，利用有限元方法求解其中的n - s方程，得出管道中微型機器人的各種設計參數與機器人的驅動力、形成的最小潤滑油膜厚度和機器人的運行速度之間的關系曲線，研究了管道環境與機器人驅動力、摩擦阻力矩、機器人運行速度、形成的最小潤滑油膜厚度、油膜的承載能力之間的關系。
  12. Abstract : this paper derives thecalculating formulas to the contact strength and oil - film thickness of the involute spur gear according to hydrodynamic lubrication principle. through check with test, shows that they may rully replace now available hertz formula and dowsonformula respectively

    文摘:根據流體動力潤滑原理，推導出了漸開線直齒圓柱齒輪接觸強度及油膜厚度的計算公式，通過實驗驗證，說明它們可以完全分別代替現有的赫芝公式及通森公式。
  13. The optimize design of roller radius is discussed based on the touch intensit y and the thickness of lube film in this paper

    從接觸應力和潤滑油膜厚度兩方面入手，進行滾子半徑的綜合設計。
  14. Roller radius sizes of slave mechanism of cam machin e affect the touch - stress of touch region and the thickness of lube film directl y

    凸輪機構從動件滾子半徑的大小直接影響凸輪副接觸處的接觸應力和潤滑油膜厚度並影響凸輪機構的壽命和運動精度。
  15. Abstract : roller radius sizes of slave mechanism of cam machin e affect the touch - stress of touch region and the thickness of lube film directl y

    文摘:凸輪機構從動件滾子半徑的大小直接影響凸輪副接觸處的接觸應力和潤滑油膜厚度並影響凸輪機構的壽命和運動精度。
  16. Hard - chromed piston rod with micro - grooves, increasing the rigidity and reducing friction, keep better lubrication action

    活塞桿微裂紋鍍硬鉻，增因硬度減少磨擦，保持油膜潤滑效果值。
  17. A side effect of wear occurring in the mixed film lubrication regime is the formation of organic residues through interaction between the fluid and the wear process

    混合油膜潤滑模式存在的副作用是液體與磨損過程中會產生有機殘余物。
  18. Thin film lubrication

    薄油膜潤滑
  19. Boundary film lubrication

    邊界油膜潤滑
  20. Numerical calculation for the lubrication pressure of the piston and cylinder tribopairs

    缸體間油膜潤滑壓力的數值計算
分享友人
分享到 Line

分享到臉書