泄壓塞 的英文怎麼說

中文拼音 [xièyāsè]
泄壓塞 英文
pressure relief plug
  • 泄 : Ⅰ動詞1 （液體、氣體排出） let out; discharge; release 2 （泄露） let out （a secret）; leak （new...
  • 壓 : 壓構詞成分。
  1. Due to the size of the defect, a fragment of bone is introduced to support the mucosal graft. strength of the repair is verified by increasing intercranial pressure with the valsalva maneuver, and it is seen to be watertight. rapid - setting fibrin glue is applied, and a second layer of mucosa is applied over this

    由於瘺孔較大，置入一些骨的碎片以支持填塞物，通過valsalva法咽鼓管吹氣法增加顱內壓可以觀察修補的牢固性，可以看到沒有泄漏，利用可以快速固定的纖維蛋白膠進行固定，其上鋪上一層粘膜，然後再用膠水進行固定。
  2. Blowby is basically the leakage of compressed air-fuel mixture and burned gases past the piston rings into the crankase.

    竄氣，基本上是被壓縮的空燃混合氣和燃燒后的氣體的泄漏，它通過活塞環進入曲軸箱。
  3. According to the control rod hydraulic drive mechanism ( crhdm ) and the characteristics of its hydraulic cylinder seal structure, the leaking ways of the hydraulic cylinder piston ring seal were analysed, its theoretical calculation model was built and its flow resistance formula based on the calculation model of differential pressure at the hydraulic cylinder piston ring seal was deduced

    摘要根據控制棒水壓驅動機構水壓缸活塞環密封結構的特點，分析了水壓缸活塞環的泄漏途徑，建立了活塞環密封泄漏流阻的理論計算模型，並結合水壓缸活塞環密封處的壓差計算模型，推導出水壓缸密封結構的流阻計算公式。
  4. In the third chapter, the mathematical models of project system have been established, and simulation has been done on the simulink enviroment of matlab software kits. the simulation focus on the effects of main parameters on the dynamic characteristics of speed control system, and the main parameters include viscosity damp coefficient and friction torque of electrical motor shaft, internal leakage coefficient of pump / motor of hydraulic circuits, gas volume of pressure accumulator, viscosity damp coefficient of cylinder piston and different running building floors, etc. at last, theoretical research effects of the flow and pressure pulsation of pump / motor on car speed and oil volume leakage theory are discussed. the fourth chapter of this thesis concerns the research on the key items about hydraulic power control system according to the ens 1 - 2 and other hydraulic elevator standards

    論文第三章針對組成系統的各個模塊進行了機理建模，並且通過matlab軟體中的simulink圖形化模擬環境進行了本課題系統的模擬研究，主要針對影響系統特性的主要參數變化，動態分析系統的輸出特性，在上下行工況中，分析了電機軸系粘性阻尼系數、軸系摩擦力矩、主迴路蓄能器迴路液壓泵馬達內泄漏系數、蓄能器氣體容積、液壓缸柱塞粘性阻尼摩擦系數以及不同運行樓層工況等參數對系統特性的影響；最後對軸向柱塞泵馬達的流量壓力脈動對電梯轎廂速度的影響和蓄能器內油液體積損失機理進行了理論研究。
  5. As a main participator in the design for and research on engineering the control system, in the project of eliminating ash with water in jianbi power plant, the author emphasized on the intelligent fault diagnosis for the complex hydraulic system by the background of that project in this paper

    本論文以作者參與的諫壁發電廠濕除灰控制系統的設計研究為工程背景，以柱塞泵為主要實踐對象，研究復雜液壓系統泄漏故障的智能診斷問題。
分享友人
分享到 Line

分享到臉書