泵回氣體 的英文怎麼說
中文拼音 [bènghuíqìtǐ]
泵回氣體
英文
blowback gas-
On the base of the analysis on the advanced technology of hard ferrite in foreign country, the main procedures of preparing hard ferrite pre - sintering material are determined as follows : first, the ferrite oxides coming from the main cold rolling line and strontium carbonate are conveyed to storage tank by gas power and weighed automatically according to the demands of constituent composition. and then they are mixed and grinded by using method of wet treatment. finally the mixtures is transported to the devices of storage by transporting pump
在分析國外先進的永磁鐵氧體生產工藝的基礎上，確定了生產高檔永磁鐵氧體預燒料的主要過程：首先，利用攀鋼冷軋鐵紅為主要原料，將氧化鐵紅及碳酸鍶採用氣力輸送至貯料料倉，經自動稱量裝置，按工藝配方稱量後分別由氧化鐵紅及碳酸鍶發送罐氣力輸送進入預混攪拌筒加水攪拌，然後再送入混磨機濕法混磨；最後，混合物經輸送泵輸送至料漿存儲裝置，經定量進料泵定量輸送至回轉窯進行濕法預燒，預燒料經緩冷至室溫后，再球磨。Combined with the actual condition of the plant simulator, this paper analyzes the native and abroad development of the simulation device. the main content is followed : introducing the characteristics and managing specialties of the simulator project in detail ; introducing the simulation object, describing the hardware, software structure and functions of the simulation object ; describing the exploitation process and mathematic model of the main steam, reheater, by - pass system, regenerative heater extraction, deareator, pipes, network system and pumps
本文分析了國內外模擬培訓裝置的發展狀態，並結合本廠模擬機開發的實際情況，其主要工作如下：詳細介紹了模擬機開發項目的特占和管理特殊性；介紹了模擬對象和所開發模擬機的硬體結構、軟體結構，以及它的功能；詳細介紹了作者參加開發的汽機系統的主蒸汽、再熱蒸汽和旁路系統，回熱抽氣和除氧系統，以及管道、管網和泵等模型的開發過程和數學模型。The second chapter simply introduces the development of alternate asynchronous inverter technology and retrospects some types of energy - saving systems for hydraulic elevators. then the working principles of the project are discussed and analyzed at four different working status, i. e. light load upwards, heavy load upwards, light load downwards and heavy load downwards. and the chapter focus on the introduction of structure design of pump station, calculation and type selection of pump / motor reversible units, research on oil leakage principles of accumulator circuit, design of accumulator - pump / motor pressure - energy transformer and integrated valve blocks, etc. the last but not the least, the electrical wiring of vector inverter control cabin and design of computer control and data acquisition system are introduced
論文第二章首先簡單介紹了交流異步電動機變頻調速技術的發展概況，在回顧電梯液壓控制系統節能技術的基礎上，介紹了本課題研製的「採用蓄能器的液壓電梯變頻節能控制系統研究」的基本原理，分析了動力系統在電梯轎廂輕載上下行、重載上下行等四種典型工況下的基本工作狀態和工作方式；詳細地介紹了本課題節能系統液壓動力泵站的結構設計和參數設計，重點研究了液壓動力泵站的結構設計、液壓泵馬達可逆性問題及其選型設計計算、蓄能器迴路泄漏油損失機理的研究及其補償裝置的設計、蓄能器-泵馬達壓力能量轉換裝置的設計、多功能集成控制閥組的設計等內容；最後簡單介紹了本課題矢量控制變頻控制櫃的外部附件電氣接線、計算機控制及數據採集系統的硬體設計等內容。Streaming from the hot end to the cold end of the regenerator was found which would waste much useful heating energy. modified structure of the jet pump could control this sort of streaming efficiently
實驗中還觀察到了直流現象，氣體從回熱器熱端向冷端運動，造成大量的能量浪費，通過改進噴射泵結構可以有效抑制直流。Operation, leaves the air by centrifugal force intermediate role to the brink of incompetence impeller movement into bengti circular cavity at, and then returned to impeller, re - starting from the leaves of the cycle in the same way again
運轉時葉片中間的空氣受到了離心力的作用，向葉輪的邊緣無能運動，進入泵體的環形空腔，然後又返回葉輪，重新從葉片的起點以同樣的方式再進行循環。The dried material is put into the middle of shell, mixing by the rake teeth and the material shaft works back and forth. the indirect heating, equal agitation of rake teeth and grinding of breaking stick makes water in material evaporation. under the effect of vacuum system, the water in the dried material and apparent water are discharged and the vapor water is discharged from outlet of vacuum pump passing dry dust collector, wet dust collector and condenser
被乾燥物料從殼體上方正中間加入，在不斷正反轉動的耙的攪拌下，物料軸向來回走動，與殼體內壁接觸的表面不斷更新，受到蒸汽的間接加熱，耙的均勻攪拌，粉碎棒的粉碎，使物料內的水份氣化，在真空系統的作用下，使被乾燥物料內部水份和表面水份更有利的排出，氣化的水份經乾式除塵器濕式除塵器冷凝器，從真空泵出口處放空。分享友人