泵抽井 的英文怎麼說

中文拼音 [bèngchōujǐng]
泵抽井 英文
pumping well
  • 泵 : 名詞（吸入和排出流體的機械） pump
  • 抽 : 動詞1 （把夾在中間的東西拉出; 提取） take out （from in between） 2 （從全部里取出一部分; 騰出） ...
  • 井 : Ⅰ名詞1 （從地面往下鑿成的能取水的深洞） well 2 （形狀像井的東西） sth in the shape of a well 3 （...
  1. Band wheel pumping power

    深井泵抽油的皮帶驅動
  2. Controlling the installing quality of overhang - well - vertical - draw out core pumping set

    大型懸吊井筒抽芯式泵機組安裝質量控制
  3. Through analyzing the structure of open caisson, and according to sinking stress principle, the paper introduced in the open caisson construction process sinking, correcting error, survey control as well as peculiar circumstance processing technical measure, such as in open caisson construction the inner - mold for sanding, framework supporting and steel binding, and concrete casting ; in open caisson sinking - control the sand in edge foot inner - mold, sand - pumping sinking, and pressure hydraulic monitor breaking and pressure - blowing sinking by air pressure blower etc

    摘要根據下沉受力原理，分析了沉井結構，介紹了沉井施工過程中的下沉、糾偏、測量控制以及特殊情況處理的技術措施，如沉井製作中的填沙內模，模板支設和鋼筋綁扎，混凝土澆注；沉井下沉控制中的刃腳內模沙土，抽沙泵抽沙下沉，高壓水槍破壓、空壓機吹壓下沉等。
  4. The model of variability of submergence depth is established based on the law of volume balance, and the changing trends of parameters like submergence depth etc are analyzed. according to the principle of supply and discharge balance, the method to predict oil yield is presented. subject to different objective functions, the corresponding optimum combinations of suction parameters are analyzed, and the importance of choosing objective function to optimum combination of suction parameters is emphasized

    本文研究了油井流入動態關系，根據井筒內液量平衡原理，建立了沉沒度變化的數學模型，分析了沉沒度等參數變化規律；根據油井供、排平衡原則，得出了抽油泵排量系數相對穩定狀態下產量預測的關系；分析了不同目標函數下，油井抽汲參數的組合效果，指出了目標函數選取對參數合理組合的重要性。
  5. Abstract : factors causing the failure of the rod string in a screw pump well include rod with minor od being used ， defects in the rod body produced in manufacturing and service ， excessive torque caused by plugging and reactive torque on the rod string ， and excessive shearing stress on the rod thread

    文摘:造成螺桿泵採油井抽油桿桿柱斷裂、脫扣和擼扣的主要原因有桿體外徑選擇偏小，桿體製造或使用過程中產生缺陷，堵塞扭矩過大，反扭矩大於螺紋聯接扭矩以及抽油桿螺紋牙受剪應力過大等。
  6. Type qj submersible deep - well motor pumps are mainly used to lift under ground water, irrigation and industrial water supply

    Qj深井潛水泵主要用於抽取地下水，農田灌溉，工業給排水。
  7. The ground water exploit mainly relies on deep well diving pump for drawing water, that is to say, the cost depends primarily on electricity consumption

    地下水開采主要依靠深井潛水泵把水抽到地面，也就是說，供水成本主要取決于用電量。
  8. Abstract : a new model of sand - control and wear - resistance pump is developed based on conventional deep well pump through improving some not - suitable construction and processing technology

    文摘:防砂耐磨抽油泵是在傳統管式深井泵的基礎上，對某些不太合理的結構和加工工藝進行了改進和優化。
  9. Diamond press machine, synthetic diamond and its products various pressure containers other produts sucker rods, various derricks, drilling tools, hydraulic jacks, water swivels, hydraulic breakout tools, hydraulic pumping units and so on

    該廠的主要產品有：地質巖芯鉆機工程施工鉆機水文水井鉆機汽車鉆機鉆塔泥漿泵金剛石壓機人造金剛石及製品液動螺桿鉆泵井壁管和抽油桿以及一
  10. The results show that the wellhole and pumping condition, such as depth of the pump, quantity of pumping, all have great influence on the observational result

    結果表明，井孔條件，抽水條件，如水泵深度、抽水量等因素的改變對觀測結果產生較大影響。
  11. According to statistics, since at 6 : 00 on the 30th to 31, 6 pm, vertical pumpinstalled in the mine incidents around the drainage pump a total of 132, 200 cubic meters of water pumping

    據統計，自30日6時至31日6時，安裝在事故礦井周圍的排水水泵共抽排積水13 . 22萬立方米。
  12. The device consists of a single - phase flow test device, which can make a real simulation of the downhole working conditions and the flow of the liquid in the subsurface pump, and a miscible - phase flow test device, which can simulate various oil - gas ratios

    這種裝置由單相流試驗裝置和混相流試驗裝置構成，前者能比較真實地模擬井下的各種工況和抽油泵內液體的流動狀態，後者可模擬不同的油氣比。
  13. The pump state chart is mainly described by using relations between flowing pressure and pump efficacy, this way was authorized in 1989, and was used extensively in daqing oil field

    抽油井泵況圖目前主要採用流壓?泵效的關系加以描述，該方法在1989年得到了認可，並在大慶油田取得了廣泛的應用。
  14. For the full - year - operation prw, seasonal thermal energy storage plays an important role in the heat source of the heat pump

    對于冬夏均運行的抽灌同井，季節性蓄能是熱泵熱源的重要組成部分。
  15. Inflow performance of oil well, as a major external factor of influencing sucker rod pump performance, is studied

    油井流入動態是影響抽油泵性能的外部重要因素。
  16. The inspectors approved the quality review made by local mine quality monitoring stations for above mentioned civil works, and agree to classify the construction of auxiliary slope hoist house and the auxiliary slope portal house to be qualified projects, and the degas pump station, dispatch building and the bath room constructions to be excellent projects

    本組同志認為晉城地方礦區質監站對以上工程質量核驗是實事求是的，比較準確的反映了工程質量的實際情況，同意對副斜井提升機房、副斜井井口房核定為合格工程，對瓦斯抽放泵站和調度樓及浴室工程核定為優良工程。
  17. Besides, it is suggested that the diagnosis and analysis technique of the working conditions of the subsurface pump be further developed and improved to ensure the effective and reliable operation of oil pumping equipment

    此外，建議進一步發展和完善玻璃鋼抽油桿柱超深抽採油的井下泵工況診斷與分析技術，確保抽油設備高效可靠地運行。
  18. The statistics on the measured data in a oil - field shows the submergence depth and discharge coefficient are very low, some key measures for improving discharge coefficient and sucker rod pump performance are presented ; the applications of discharge coefficient to practice are illustrated with examples

    通過對某具體油田區塊測試數據分析，指出該區塊油井存在沉沒度、排量系數低的現象，提出了提高抽油泵排量系數、改善工作性能的措施。舉例說明了排量系數計算在生產管理中的應用。
  19. But, at the present situation, the down hole progressing cavity pump is driven by the motor and reducer placed on the ground via a thin and long rod, and this cause troubles easily because of the rod works in cycling bending and distortion

    目前螺桿泵採油系統採用地面電機和減速裝置通過細長抽油桿驅動井下螺桿泵，這種驅動方式由於抽油桿旋轉時處于長期循環扭曲狀態，系統很容易出現故障。
  20. We have a pump for drawing water from the well

    我們用一個水泵從井裡抽水。
分享友人
分享到 Line

分享到臉書