流出孔 的英文怎麼說

中文拼音 [liúchūkǒng]
流出孔 英文
tahole
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 流出 : outflow; effusion; runout; vegetate; runoff; profluvium; discharge
  1. House : jack waters his bean stalk every day for a week. he ' s oozing bean curd out of his pores for a month

    傑克一周內每天都給他的仙豆澆水， （那麼）他的毛孔連續一個月都會流出豆腐來。
  2. The valve shown has a pilot and a bleed orifice.

    該閥具有控制孔和流出孔。
  3. The water drained out of the hole in the pail.

    水從桶的孔里流出來。
  4. It is the porosity due to interconnected pores that can be filled with and emptied of water.

    這種孔隙率是水可流出和流入的連通空隙。
  5. Bleach ball valves must be permanently marked externally with : the word bleach ; two opposing directional arrows, one inscribed with flow and the other with vent ; and nsf ( symbol of the national sanitation foundation international, indicating approval for use with potable water )

    漂白劑球閥必須在外部永久性標志：漂白劑；兩個反向箭頭，一個標志流向，另一個標志排出孔；以及nsf （美國全國衛生設備基金會國際的標記，表示已認證可用於飲用水） 。
  6. Jet impingement cooling is an advantage method in heat transfer enhancement owing to its extremely high local heat transfer coefficient and simple structure. as regard as the combustor flame tube cooling structure is concerned, the impingement - converse convection - film composite cooling is an effective method, in this composite cooling structure, the impingement cooling problem could be modeled as impingement inside semi - confined channel

    對于沖擊-逆向對流-氣膜復合冷卻的火焰筒結構而言，火焰筒壁面冷氣側的沖擊冷卻實質上是半封閉通道的沖擊冷卻，即沖擊射流從沖擊孔板噴出，沖擊到換熱靶面后形成壁面射流沿通道單方向流出。
  7. Oil filler plug : it is necessary to fill no. 30 machine oil or no. 20 gear oil before using aerator, until oil reaches oil plug hole on the side and overflows

    注油油塞：增氧機使用前，必須先注入30號機械油或20號齒輪油，注油量達到側面油塞孔有油流出為止。
  8. Secretion from the ear - this may be due to ottitis media or externa

    有分泌物從耳孔流出可能是中耳炎或外耳炎
  9. Secretion from the ear - - - - - - this may be due to ottitis media or externa

    有分泌物從耳孔流出可能是中耳炎或外耳炎
  10. Drooping of eyelids leading to poor contact between the openings of the tear ducts and the eyeballs. as a result, tears cannot be drained into the ducts but spills out of the eyes

    I淚孔因眼皮鬆弛而不能緊貼于眼球，眼淚不能順利地流進淚管里而溢流出眼外
  11. In the swirl, air stream at the periphery tend to have higher temperature compared to that in the center. by means of a separating plate, the airflow is separated into streams of hot and cold air. each stream of air then emerges from a particular end of the tube, named the cold and hot end accordingly

    氣體在熱端管的流動過程中，外層氣流溫度升高，內層返流溫度降低，高溫氣流從熱端閥流出，低溫氣體通過冷孔板流出，從而將進渦流管的氣流分離為冷熱兩股溫度不同的氣流。
  12. To facilitate drainage of groundwater and to maintain water flow, permeable rocks will be used for recompaction. filter layer and weepholes will also be installed. these will guarantee the normal flow of groundwater

    為促進排水及保持正常水流，工程將使用具滲透性的石塊作重新壓實，同時安裝過濾層及疏水孔，以確保地下水仍可如常流出。
  13. On the basic of analyzing the spatial distribution of the hydrogeologic stratum, it abstracts the concept module of the void hydrogeologic profile, and sets down the rule on making up the stratum section, it also analyses the data structure and the steps of automatic generating the hydrogeologic profile, and discusses the appliancation of component gis on the the automatic generate method

    在分析孔隙水文地質層的空間分佈規律的基礎上，抽象出孔隙水文地質剖面的概念模型，制定了地層剖面構建規則。同時，本文也分析了自動構建水文地質剖面圖的數據結構及其構建剖面的具體流程，並探討了組件式gis技術在自動繪制水文地質剖面圖中的應用。
  14. This paper presents a review of the moisture transfer theories in porous media during drying processes in the last century. then an innovative pore network model in drying based invasion percolation theory and pore network theory essentially different from the classical continuum model is developed. moisture transfer characteristics in porous media during drying process are studied under isothermal and absence of gravity

    本論文首先回顧了近一個世紀以來多孔介質在乾燥過程中內部濕分遷移理論，指出孔道網路理論在多孔介質乾燥研究中所具有的獨到優勢，繼而藉助侵入滲流理論所取得的成果，結合孔道網路理論，分析了乾燥本身的濕分遷移特徵，模擬研究了多孔介質在等溫條件下不考慮重力時的乾燥過程。
  15. Blood oozing from nostrils

    鼻孔緩緩流出血液。
  16. The method was proposed to compute the rock modulus when one kind of pore fluid changed to another, and to identify the pore fluids by the use of poroelastic modulus

    提出孔隙流體變化時巖石有效模量的計算，及利用孔隙彈性模量辨別儲層中不同流體類型的計算方法。
  17. Comparing with non - rotating abrasive jet, the hole diameter and the volume of rock - breaking are many times larger than the former by use of rotary abrasive jet on the same condition

    與非旋轉磨料射流相比，同樣條件下旋轉磨料射流鉆孔直徑和破巖體積都比前者高出多倍。
  18. Nh4c and o - p concentrations were 35 and 7 times higher, respectively, in the pore water than in the overlying marsh, suggesting a permanent flux of nutrients from the sediments

    孔隙水中的nh4c和o - p濃度比上層濕地水的濃度分別高出35倍和7倍，這表明營養物質穩定地從沉澱物中流出。
  19. Primitively, the taylor tape is shaped when the polymer solution conies out from the sprinkler, then the taylor tape is elongated with the spray of instabilities, and the jets form solidified nanofibers gradually

    高聚物溶液從噴射孔流出首先要生成幾ylor圓錐，然後r幾ylor圓錐伸長，並伴隨著射流的不穩定運動，接著射流開始向固化纖維轉化。
  20. If the electrons were simply leaking from one place to another, like water going through a hole, the behavior would be completely different.

    如果電子僅僅象水從小孔中流出那樣從一處漏到另一處，那麼行徑就完全不同了。
分享友人
分享到 Line

分享到臉書