流動相梯度 的英文怎麼說

中文拼音 [liúdòngxiāngtīdù]
流動相梯度 英文
eluent gradient
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 相 : 相Ⅰ名詞1 （相貌; 外貌） looks; appearance 2 （坐、立等的姿態） bearing; posture 3 [物理學] （相位...
  • 梯 : Ⅰ名詞1 （梯子; 樓梯） ladder; stairs; steps; staircase 2 （姓氏） a surname Ⅱ形容詞（形狀像樓梯的...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 流動 : 1. （液體或氣體移動） flow; run; circulate 2. （經常變換位置） going from place to place; on the move; mobile
  1. By performing fourier transformation, the relationship between the turbulent intensity of the particle and that of the carrier fluid was obtained which makes clear that particle size, specific gravity, velocity gradient, and the characteristic frequency of energy - containing eddies are four basic influencing parameters. it is proven theoretically that under certain conditions, the stream - wise and transverse particle turbulent intensities exceed those of the carrier fluid. based on the equations of two - phase flow, the presence of fine sediment suspension is shown to attenuate the turbulent intensity of the water

    通過對細小顆粒在剪切流場中運動方程的fourier分析，得到了顆粒脈動強度和流體脈動強度之間的定量關系，表明顆粒粒徑、顆粒密度、流速梯度以及紊動場含能旋渦的特徵頻率是影響顆粒脈動強度的主要因素，首次從理論上證明了在一定條件下，顆粒在縱、垂向的脈動強度均會超過相應的流體脈動強度，為已有的實測資料提供了合理的解釋。
  2. The numerical algorithm of solving the adjoint equations for different design cases have been developed by using finite volume methodology which is usually used to solve the flow governed equation. it includes the some important aspects, such as flux formulation, wall and far - field boundary treatment methodology, dissipative term formulation, etc. after the solution of the adjoint equations is obtained, the derivatives of the cost function with respect to all the design variables can be evaluated with the same operation. this can yields a significant saving over the other gradient - based techniques when there are many design variables

    （ 3 ）進行了應用控制理論和三維歐拉方程的機翼氣動反設計研究，以及有升力約束情形下機翼跨音速減阻問題研究，分別推導了相應的共軛方程及邊界條件數學表達形式，研究與發展了三維共軛方程的有限體積數值求解方法，及相應梯度公式的數值求解方法，通過對計算網格生成、流場計算、共軛方程數值求解、梯度求解和優化演算法等多方面的有效結合，成功發展了三維機翼的氣動反設計和跨音速減阻優化設計程序，成功地進行了多個設計算例研究。
  3. This disquisition aimed at plc reactive dispatch curve controller, associating the entire exploiting process, expounded in guiding ideology, control standard, function and structure design, software system design, analog experiment, fixing and debugging and so on, also part of flow schematic diagram ( the ladder chart was n ' t drawn because of too many network and length limit ). this design involves many subject such as power systenu automatic control microcomputer control and electroa during the design, we have read a great deal of concerned data, base on the sufficient investigation analysis and research, associating the practicality of huanren power plant, we introduced and exploited plc reactive dispatch curve controller in the first time

    本文針對plc無功調度曲線控制器，結合整個研製過程，在設計指導思想、控制準則、性能設計、裝置構成設計、軟體系統設計等方面進行了闡述，並給出了部分程序流程簡圖（由於梯形圖網路數太多，受篇幅限制沒有給出） 。本設計涉及到電力系統、自動控制、微機控制、電子等多學科知識，在設計過程中，我們查閱了大量相關的資料，在充分調查、分析、研究的基礎上，結合桓仁發電廠實際情況，首次提出並研製出了plc無功調度曲線控制器。
  4. The saffman force does not affect the axial velocity of the flow, while it change the concentration of the particle. the gas - particle two - phase flows in the present of temperature were also numerical simulation

    討論了絕熱、有溫差和添加熱泳力三種情況下的兩相流場，分析了溫度梯度、湍動能、軸向速度和顆粒濃度的變化。
  5. The purpose of this dissertation is to study the lagrangian method and conservative rezonning algorithm. finite volume scheme is used for lagrangian equations of hydrodynamics. because of the pressure gradients " influence upon velocities and energy, computational scheme is proposed for momentum equation on two control volumes in order to suspend the time when the mesh becomes distorted

    本文的目的是研究lagrange方法及重映演算法，主要內容可分為以下幾個方面：首先從積分形式的二維lagrange流體力學方程組出發，用有限體積格式進行計算，考慮壓力梯度分佈對速度和能量改變的影響，構造了在兩個控制體上的動量方程的計算格式，使得速度的改變受其周圍八個壓力的影響，在一定程度上推遲了網格相交的進程。
  6. Seepage influences on the temperature distribution by means of heat transfer and communication, temperature influences on seepage field by changing the hydraulic conductivity and inducing fluid flow because of the temperature potential, thus finally approaching the stable seepage and temperature fields

    滲流通過參與熱量傳遞與交換影響溫度分佈，溫度通過改變介質滲透系數和溫度勢梯度引起水流運動來影響滲流場，兩者相互作用最終達到穩定的滲流場和溫度場。
  7. ( 2 ) on the basis of continuity equation, momentum conservation equation, energy conservation equation, and substantial equation, coupled thm governing equations are derivated with giving up the assumption of local thermal equilibrium, adopting thermal elasto - plastic constitutive relation, taking the effect of temperature gradient on groundwater seepage ( analogous to soret diffusion ) and the effect of viscous dissipation of groundwater on temperature field of rock mass into account

    （ 2 ）根據連續性方程、線動量平衡方程和能量守恆方程以及相應的物性方程推導了飽和巖體溫度場-滲流場-變形場三場耦合作用控制方程組。在推導控制方程組時舍棄了「局部熱平衡」假設，採用了熱彈塑性本構關系，考慮了溫度梯度對地下水滲流的影響（類soret效應）以及地下水的粘性耗散對巖體溫度場的影響。
  8. The effects of interfacial resistance, superheating, free convection due to both temperature and concentration gradients, mass diffusion and thermal diffusion, and variable properties in both the liquid and gas - vapor regions were considered

    分析中，考慮了相間阻力、液膜波動、蒸汽過熱度、因溫度和濃度梯度引起的自然對流、質擴散和熱擴散以及物性的變化。
  9. At the same time, tip leakage induced by pressure gradient and relative motion between the blade tip and the shroud wall is found to have a major influence on detailed flow properties in tip region of rotor passage

    同時，由於轉子葉片壓力面和吸力面之間壓力梯度以及葉頂與機匣之問的相對運動產生的間隙流對轉子通道內的細微流動結構有較大的影響。
  10. The fem results indicated that as to the rough surfaces in sliding contact, the value of the contact pressure was very high which coursed a high value of the heat flow rate, meanwhile the sliding time was not enough for the frictional heat to transfer, thus the highest value of the body temperature occurred just on the sliding surfaces, which possessed a sharp thermal gradient in direction perpendicular to the sliding surface. so the great thermal stress was caused just by the sharp gradient and the thermal elastic distortion with which the contact pressure changed occurred simultaneously, thus this change of the contact pressure would affect the temperature distribution in return

    對于相對滑動的粗糙表面，因實際接觸面積小而導致接觸壓力很大，這樣使得熱流密度會很大，同時由於滑動時間很短，熱來不及傳導，最高溫度發生在摩擦表面，在垂直於摩擦面的方向有很大的溫度梯度，使得熱應力很大，且最大應力發生在表面，同時產生熱彈性變形，這種變形使得接觸區域內的壓力分佈發生變化，這種變化又反過來影響了接觸區域的溫度分佈。
  11. Simulation results for non - isothermal flow pass plate have been shown. the spatial correlations in a fluid subjected to an external temperature gradient have been computed by using cellular automata simulations of a simple lattice - gas model with temperature. but, this theory is found limitedly applied to mechanics

    並給出了平板非等溫流體繞流流動現象的模擬結果；通過採用一個含有溫度的簡化格子氣模型，用細胞自動機方法，模擬計算了服從于外部溫度梯度的二維流體中的平衡與非平衡空間相關函數，數值結果表明：該方法的計算結果和由漲落流體動力學理論的預言在是性上是完全符合的； bernsdorf等人用ca討論在復雜障礙物情況時的流體流動問題。
  12. A number of overall correlations have been developed for the prediction of the pressure gradient in the vertical flow of gas-liquid mixtures.

    為了預測氣液混合物垂直流動的壓力梯度，已經得出了許多整體相關規律。
  13. The experiment of single - phase flow through low permeability core shows that during fluid flow there exists start - up pressure gradient

    摘要低滲透巖心單相滲流實驗表明，流體滲流時存在啟動壓力梯度。
分享友人
分享到 Line

分享到臉書