流態激光器 的英文怎麼說

中文拼音 [liútàijīguāngqì]
流態激光器 英文
flow-state laser
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 激 : Ⅰ動詞1 （水因受到阻礙或震蕩而向上涌） swash; surge; dash 2 （冷水突然刺激身體使得病） fall ill fr...
  • 光 : Ⅰ名詞1 （照耀在物體上、使人能看見物體的一種物質） light; ray 2 （景物） scenery 3 （光彩; 榮譽） ...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 激光器 : [光學] （光激射器） laser （縮自 light amplification by stimulated emission of radiation）; optic...
  • 激光 : [物理學] laser 激光靶 laser target; 激光報警器 laser avoidance device; 激光玻璃纖維 laser fibre; ...
  1. For micro - cavity semiconductor laser, station model is proposed in this paper and its steady - state and instantaneous characteristics when the coupling efficiency of spontaneous emission into a lasing mode is equal to 1 are analysised. for current noise, sp noise, noise, p noise, as well as current modulation, sp modulation, modulation and p modulation, using small - signal approximation, we derive the laser ' s corresponding transfer functions. and we calculate their signal - to - noise ratio ( snr ) gain in various parameters through frequency domain analysis in the premiss of large input snr

    本文對于微腔半導體激光器，提出站模型，能夠較直觀簡潔地分析微腔半導體激光器的穩態和瞬態特性，利用此模型對具有重要實用價值的= 1的微腔半導體激光器進行了討論；對于電流i噪聲、自發發射壽命_ （ sp ）噪聲、自發發射因子噪聲、光子壽命_ p噪聲，以及電流調制、 _ （ sp ）調制、調制、 _ p調制，在小信號近似下，得到了相應的激光器的傳遞函數；在大信噪比的前提下，對激光器進行了頻域分析，分別計算了它們在不同參數下的信噪比增益，分析了其抗噪聲性能。
  2. In this thesis, we demonstrate the study of si - based light emitting materials and its importance in si - based photonics integration. we discussed mainly the gain, differential gain, threshold current of si - based quantum - dot laser and the dependence of threshold current on temperature from discrete energy level of three - dimension confined quantum - dot and state density distribution of 5 - function

    本文闡述了si基光發射材料的研究進展及它在硅基光電子集成中的重要地位，從三維受限量子點的分立能級和函數狀的態密度分佈入手，著重討論了si基量子點激光器的增益、微分增益、閾值電流及閾值電流的溫度特性。
  3. Water shutoff agent dsz - a is composed of inorganic particle. its specialities are low cost, easily flow, high strength and long valid period. the agent suits non - selective water shutoff in sand formation. dsz - a not only can plug high water - bearing formation, but also can plug case leakage. dsz - a has been applied on site and gotten good effect. it is a agent which has wide prospect

    井下護泵除砂裝置主要用於產液氣量高，出砂能力大，利用常規裝置、常規方法很難治理的井.它的設計是建立在丟手封隔器卡封的基礎上，將液體攜砂能力由地層進入泵管轉變為先過濾（雙層激光割縫篩管部分） ，再在除砂器內靜態沉澱、由單流閥排入井底等一系列除砂護泵優點.本文著重介紹了井下護泵除砂裝置的工作原理與應用情況
  4. In this thesis, by changing the position of laser, increasing the operation velocity and adding the experimental materiel, the images data under the different operational condition are gotten. visual analysis of the different area of flow field is done, using a serial of images about the typical sate of flow field

    試驗過程中，通過改變激光器照射截面，提高操作風速，變化物料高度，獲得不同工況下的圖像數據，並針對不同的流動區域，將獲得的典型流動狀態的連續圖像進行了可視化分析。
  5. On the basis of this, the effective reflective index with the variation of the carrier density is discussed. this paper also analyzed the random facet phase and the length of the cavity ' s influence on threshold characteristic. especially, the wavelength tuning characteristics have been investigated in detail when one segment works as absorbed region

    在此基礎上，研究了每一段等效反射率譜曲線隨載流子濃度變化的情況；分析了邊界相位的不確定性以及激光器腔長對閾值特性的影響；重點討論了其中一段工作在吸收狀態下的波長調諧性質。
  6. Compared with green light - emitting device, blue oled has many problems such as brightness, efficiency, stability, and color saturation, in this study we investgaited the blue oleds systemically : 1 ) double heterosturcture oled was charaterized. due to the introducing of electron transport layer alq3 and hole - blocking layer balq3, the energy matching was more reasonable and the carrier injecting was more effective in the double - layer device. the maximum efficiency and luminance of this device attained to 1. 90 lm / w and 10, 000 cd / m2, respectively

    其次，由於一直以來藍光oled器件的研究處于相對落後的狀態，其發光亮度、效率、穩定性和色純度都無法綠光器件相比，所以本論文在以下幾個方面對藍光器件的性能進行了系統的研究: 1 ）研究了雙異質型藍光oled器件，由於本研究引入了空穴阻擋層，使得載流子的復合和激子的擴散被限定在發光層內，器件的發光效率達到了1 . 90lm / w ，最大亮度達到了10000cd / m2 ，比傳統結構器件的效率和亮度提高了約一個數量級; 2 ）制備了結構為ito / npb / balq3 / alq3 / mg : ag的oled器件，研究發現，當改變各有機層厚度時，器件的電致發光光譜發生了從綠光到藍光的移動。
  7. Meanwhile, we have gained some achievement. 1. based on error variety of nonlinear control curves of ld output laser power by optoelectronic feedback measured, we take advantage of window pid control algorithm to gain high stability of laser power and reduce error amends at mostly

    1 、基於光電池檢測ld光功率輸出的非線性控制曲線產生的誤差變化，將特性曲線利用軟體的窗口控制演算法實現區域控制，進而有效的對ld工作電流進行pid穩態控制和光功率參數顯示，且激光器的光功率輸出和激光通過分光鏡後送入光電池放大電壓量和單片機通過計算使到誤差修正量達到最小，從而使光功率控制達到最佳效果的變化關系。
  8. And the use - case diagram, state diagram and class diagram are used in uml diagram, which describe the software model from its function, logic and static structure. and the main arithmetic is shown. during the detail design process the com component technology is applied to envelop the logical part, hence to update and improve the software ; the software system of evaluation of the virtual prototype of the high power tf co2 laser is developed

    本文採用面向對象的軟體工程方法對高功率橫流co _ 2激光器虛擬樣機評價軟體的需求進行了分析，並用uml中的用例圖、狀態圖和類圖分別從功能、邏輯和靜態結構三個方面對軟體模型進行了描述，提出了主要演算法，在詳細設計過程中應用com組件技術對其中邏輯部分進行封裝，以便於升級和改進，開發了高功率橫流co _ 2激光器的虛擬樣機評價的軟體系統。
  9. Then the high potential circuit power supply of ect is reasearched, designed a scheme of power supply by laser, introduced the key part, and reasearchedthe circuit of protecting. the emphases of researchis the scheme of power supply by aspecial ct, but this scheme have two difficult, in the condition of low current inline, the device must work normally

    然後對有源型ect的供能電路進行了研究，設計了激光供能的整體方案，對其中關鍵器件和保護電路進行了介紹和研究。本文重點研究了小ct供能這一在線供能方式，此方式有兩個難點，其一:當線路電流處于小電流狀態時，要保證電源的供應。
  10. The paper describes a cw, non - cooling, digital all - solid - stated ld pumped nd : yvo4 driver which adopts microprocessor control, stability power of laser feedback and laser output power about 10mw. the system is composed of constant current source, soft diagram, protection, pulse schematic and laser power feedback loop. by combining appropriate hardware and software, we achieved, in our driver, a variety of protection features including the ability to suppress transients and reduce noise, relay soft and hardware over - current protection and overvoltage shut - off, we have obtained a continuously adjustable laser power output with high accuracy and stability

    介紹一種採用單片機控制的連續運轉無製冷、數字式光反饋穩功率全固態激光器驅動電源，其輸出激光功率在10mw左右，系統包括恆流源、保護電路、脈沖驅動控制、光反饋穩功率控制等部分，結合硬體及軟體實現了激光二極體的可靠保護以及光功率穩定、準確輸出及在穩光輸出情況下，實現激光器的內外調制，並取得了一些有價值的研究成果。
分享友人
分享到 Line

分享到臉書