流量曲線 的英文怎麼說

中文拼音 [liúliángqūxiàn]
流量曲線 英文
curve of discharges
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 曲 : 曲名詞1 （一種韻文形式） qu a type of verse for singing which emerged in the southern song and ji...
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 流量 : rate of flow; flow; runoff; discharge; throughput; （flow） rate; quantity （of flow）; flux
  • 曲線 : [數學] curve; bight; bought; profile; net曲線板 french curve; irregular curve; curve board; splin...
  1. In this paper, using the program ( epagpll ), the bored testing pile group of the chinese architecture science and research institute at luokou area are analysised. the comparisons among analytical results of four constitutive models of soil are made, and the deformation of piles and soil, the soil resistance of the piles, the friction beneath cap, the aclinic displacement of the ground soil before piles and the failure pattern of pile group are discussed in detail

    本文利用所編的程序，對上海地區豎向荷載作用下的單樁的流變效應進行了分析，並通過樁體位移?時間關系曲線，確定軟土地基上豎直受力樁的承載力，分析了豎直受力樁的最終沉降量的大小，並結合《上海地區地基基礎》地方規范就程序計算結果進行了對比。
  2. The first part is introduction, presenting this paper ' s structure, research background and so on ; the second part introduces some issues relating closely to risk, the tangency point between indifference utility curve and efficient frontier is the optimal portfolio ; the third part explores risk evaluation, this part begins with some risk factors affecting security ' s price and return, then analyzes the methods evaluating degree of risk, finally, introduces a more popular method of risk evaluation - - var ; the forth part expounds risk management, this part studies some risk control strategies correspond to specific risk mentioned above ; the last part put forward some advice contrapose issues existed in risk management in china

    第一部分為緒論，介紹本文的相關背景；第二部分是與風險相關的幾個問題，等效用曲線與有效邊界的切點是投資者選擇的最佳投資組合；第三部分是風險衡量，該部分首先分析了證券與股票所面臨的風險，然後對債券和股票分別介紹，最後介紹了目前比較流行的風險衡量方法? ? var方法；第四部分為企業風險管理，這里針對上文所述的風險提出相應的風險控制策略；第五部分針對目前我國風險管理中存在的問題提出了幾點建議。
  3. Considering the electrovalence, the curve of water consumption and the reliability of water supply, this paper respectively sets up the model based on the maximal flux and the model based on the expectation flux. it takes yearly expenditure converting value and yearly cistern converting value as target function and takes continuity equation, velocity of flow and compression resistance of cast iron pipeline as restrictions and sets up the pga model on optimal design of water supply networks

    考慮到峰谷電價、用水量變化曲線及用水可靠性因素的影響，分別建立了以最高時流量設計管網的模型和以期望時流量設計管網的模型，以年費用折算值加上清水池年造價折算值為目標函數，以連續性方程、管中流速和鑄鐵管耐壓值等為約束條件，進行并行遺傳演算法對給水管網優化設計的實現。
  4. There appears obvious apoptotic peak on dna content curve of facs analysis. and as the time of bfgf treatment increases, percent of apoptotic cells increases. 3

    在流式細胞術dna含量曲線上顯示出明顯的亞二倍體峰（凋亡細胞峰入並且隨著bfgf作用時間的延長， u2 os細胞凋亡百分比逐漸增加。
  5. The thesis built the relation between containing water and the properties of trail dam ' s soil by geomechanical properties of trail dam ' s soil ; analysed the seep rule of water in the trail dam ' s field and the change of soakage line. the thesis applied the limited element to analyze the trail dam of baogang by the engineering item in production. it calculates the dynamic and static response about the dam using the numerical simulation method

    本文通過大量的尾礦土物理力學性質試驗資料，建立了含水量與尾礦土性質之間關系曲線；分析了水在尾礦壩區的滲流規律和不同標高時浸潤線的變化情況，為分析尾礦壩的穩定性提供依據；結合生產上的工程項目，從包鋼尾礦壩的穩定性研究入手，應用有限元法，通過數值模擬分析了水對尾礦壩的靜力、動力穩定性影響。
  6. The resistivity - temperature curve can be predicted by using this mathematical model, which was in good agreement with the experimental data when the cb volume fraction is close to the critical volume fraction

    利用這個數學模型，還對兩種ptc材料的阻溫曲線進行了預測，與實測結果比較發現，當炭黑含量在滲流閾值附近時，預測值與實測數據吻合很好。
  7. In different in terne die travel, the metal flow characterize in warm extrusion forming processes and the affection for the flow of metal stage which made by the difference between the blank bottom altitude and the axial direction limiting size in warm extrusion forming technique have been analysed we have gotten the equivalent strain field and the velocity field and other field variable that the blank in different in terne die travel and the die travel - load curve. at the same time, we have analyzed the contributing factor for the oil pump stator forming process optimized and achieve thereasonable die parameter for the war m extrusion forming finally, the optimized technics parameters were used into pilot production, then the qualified oil pump stator forging were produced, the analog results were compared with those of pilot production

    論文具體分析研究了不同成形工藝過程中金屬流動的特點，並對不同凸模行程下溫擠成形過程中的金屬流動特點、坯料連皮厚度（底部高度）與溫擠壓成形工藝中的軸向界限尺寸的差值對金屬變形階段的影響進行了分析，獲得了坯料在不同凸模行程下的等效應變場、速度場等場變量及凸模行程-載荷曲線，同時對油泵定子成形過程的影響因素等進行了分析，優化並獲得了合理的溫擠成形工藝及模具參數。最後，利用模擬優化獲得的各項工藝參數進行生產實驗，得到實際生產出的合格油泵定子件，並將模擬結果與生產實驗結果進行比較。
  8. Three kinds of results are obtained by simulation calculating the two models : the composed vector diagrams of the axial velocity ( v ) and the radial velocity ( vr ) at the different times in the symmetry section ; diagrams of curves of the velocity vector ( v ^ ) and ( vr ) at the different times in the different sections ; diagrams of the secondary flow vectors at the different times in the different sections

    我們對兩種不同直徑的s型血管進行了有限元模擬計算，得到三種結果：在對稱面內不同時刻的軸向速度v _和徑向速度v _ r的合成矢量；在不同截面不同時刻的速度分量v _和v _ r的曲線圖；在不同截面不同時刻的二次流的矢量圖。
  9. According to the distribution peculiarity of the two characteristic moments, the accessibility of water quality in taizhou source of yangtze river has been analyzed based on the maximal contamination zone of entire tide and the relationship between the length of contamination zone and the pollutant load. simultaneously, every project has been analyzed and compared by using the model in wuli lake water environmental renovation for getting some theoretic gist and technical supports for the engineering

    在此基礎上進行泰州江段水流水質數值模擬，建立排污混合帶范圍與排污量關系曲線，並對泰州江段供水水源地水質可達性進行了分析；將模型應用於五里湖水環境治理工程中，預測各引水方案下湖體水質狀況並進行各方案分析，從而為工程實施提供一定的理論依據和技術支持。
  10. According to the abundance well logging, mud logging and core analysis data, gaotaizi reservoir has been classified into four sand group with the principle of cycle comparison and classified control. based on the detailed study of lithologic character, sedimentary structure, paleontologic fossils, depositional sequence, rock association and logging data, the microfacies of the studied area are divided into such seven types : subaqueous distributary channel microfacies ; river mouth bar microfacies ; subaqueous interdistributary channel microfacies ; subaqueous crevasse channel microfacies ; subaqueous natural barrier microfacies ; distal bar microfacies ; delta front sheet sand microfacies. the characteristic of each sedimentary microfacies are described detailedly

    通過研究大量測井、錄井資料和巖芯資料，依據「旋迴對比，分級控制」的原則，把研究區高臺子油層劃分為g 、 g 、 g 、 g四個砂層組。通過對研究區巖性、沉積構造、古生物、沉積序列、巖石組合及測井曲線特徵進行研究的基礎上，認為研究區高臺子油層屬於三角洲前緣亞相沉積，並將研究區沉積微相劃分為：水下分流河道、河口壩、水下分流河道間、水下決口扇、水下天然堤、遠砂壩、席狀砂等七種微相類型。
  11. First super - low specific - speed centrifugal pump has a long and narrow flow passage for its high head and low capacity, and the power absorbed by disc friction is too high, so the efficiency is very low ; secondly the diffusion of flow passage is so high, that the reserved flow often emerges at the inlet and outlet of impeller. therefore the h ~ q characteristic curve is often hump - shaped, and at the low - capacity operating condition the instability often occurs ; thirdly the centrifugal pump at high - capacity operating condition is easy to overload because the n ~ q curve appears a rising trend

    首先由於它的揚程較高、流量較小，所以它的流道狹長，圓盤摩擦損失較大，效率相對較低；其次由於它的流道擴散較嚴重，易在葉片進口產生迴流和在出口產生脫流，揚程流量特性曲線易出現駝峰，在小流量工況下易產生不穩定現象；第三，由於其功率流量曲線呈現上升趨勢，在大流量區運行時電機易過載。
  12. In addition, the characteristics of critical current of hts tapes in ac applied field and that of voltage - current curve when transport ac currents were studied. the problem on the criterion of ac current carrying capacity of hts tape was discussed, and some suggestion on the criterion of ac current carrying capacity were proposed

    另外，對高溫超導帶材在交流背景磁場下的直流臨界電流特性，及超導體傳輸交流時的流?壓曲線特性進行了實驗研究，並對高溫超導帶材的交流最大載流能力的測量判據問題進行了探討，給出最大交流載流電流測量判據的建議。
  13. Discharge curve of sanitary wares determined by dynamic volumetric method

    用動態體積法測定衛生潔具排水流量曲線
  14. The mathematical model of the pump control motor system was set up by analyzing the closed system, and a dynamic simulation was performed at the same time

    通過對火炮電控靜壓驅動系統的實測試驗，獲得了輸出壓力-流量曲線，驗證了恆功率特性。
  15. Viscosimetry - measurement of viscosities and flow curves by means of rotation viscosimeters - part 2 : viscosimeter calibration and determination of the uncertainty of measurement

    粘度測定法.用旋轉粘度計測量粘度和流量曲線.第2部分
  16. Determine gpm flow by use of valve cv curve starting page 5

    要確定每分鐘多少加侖流量，則要採用從第5頁開始的閥門流量曲線。
  17. Read horizontally to flow rate curve and vertically downward to flow rate gpm

    讀出水平線上的流量曲線和垂直線下方的的流量（加侖/分鐘） 。
  18. The concordance between the output pressure - flow curve and the target constant power curve was validated through tests on cannon hydrostatic driving system, revealing that the self - regulation function of cannon driving system comes true

    通過火炮靜液壓驅動系統的實測實驗，驗證了輸出壓力流量曲線與目標恆功率曲線基本一致，實現了對火炮驅動系統的自動調解。
  19. While the content of hv increase, the flow curve move down and viscosity reduce

    隨hv含量的上升，流變曲線下移，粘度變小。
  20. Flow volume curve analytic computer

    肺流量曲線分析計算器
分享友人
分享到 Line

分享到臉書