浸膜法 的英文怎麼說

中文拼音 [jìn]
浸膜法 英文
dipping film method
  • : Ⅰ動詞1 (泡在液體里) soak; steep; immerse 2 (液體滲入) soak; saturate; steep Ⅱ副詞[書面語] (...
  • : 名詞1. [生物學] (像薄皮的組織) membrane 2. (像膜的薄皮) film; thin coating
  • : Ⅰ名詞1 (由國家制定或認可的行為規則的總稱) law 2 (方法; 方式) way; method; mode; means 3 (標...
  1. Method : experimental rat gastric ulcer models including waterlogging stress - restraint ulcer, pyloric ligation induced ulcer, indomethacin induced gastric mucosa injury and absolute alcohol induced gastric mucosa ulcer were used in this experiment

    :用水應激型、幽門結扎型、消炎痛致胃粘損傷型及無水乙醇致胃粘損傷潰瘍模型方試驗。
  2. The present work indicates the organic nf membranes and the inorganic nf membranes all have shortages, so develop composite nf membranes that have low cost, mechanically strong and thermally / chemically - resistant, easy to cleanout and good performances is a very important task. in this paper, the preparation of inorganic - organic composite nf membranes were presented. this composite comprise a porous sio2 / al2o3 support substrate, the pore diameters of which ranging from 10 to 15 nm, this inorganic support substrate having a polymer membrane which comprises an polyvinyl alcohol ( pva ) or polyamide ( pa ) densely deposited on at least one of the face surfaces thereof, the structural porosity of such pva and pa membrane ranging from 3 to 5 nm

    本論文以開發無機?有機復合納濾為出發點,首先在al _ 2o _ 3多孔微濾上利用溶膠?凝膠制備sio _ 2 al _ 2o _ 3無機復合超濾作為無機?有機復合納濾的基;選用聚乙烯醇和聚酰胺為表面功能層材料,分別探討了以羥基丁二酸和磺基水楊酸為混合交聯劑,採用制備了聚乙烯醇sio _ 2 ? al _ 2o _ 3復合納濾;以均苯二甲酰氯、哌嗪和二胺為單體,採用界面聚合制備了聚酰胺sio _ 2 ? al _ 2o _ 3復合納濾,並對影響性能的諸多因素進行系統研究。
  3. In this paper, the aqueous sol of sno2 ultrafme particles were prepared by the colloid chemistry method. here we found that the partical properties of sno2 was concerned with experimental parameters such as type of peptization acid, sn4 + concentration, peptization time, peptization temperature, ageing time et al

    本文採用膠體化學制備了sno _ 2納米粒子水溶膠,細致研究了膠溶酸類型、 sn ~ ( 4 + )濃度、膠溶溫度、膠溶時間、陳化時間等對納米粒子性質的影響,並利用漬提拉制備了sno _ 2超微粒子薄
  4. Methods : tofurther investigate the methods for bladder cancer treatment, twenty patients with bladder cancer were treated bypartial cystectomy combined with chemotherapy using submucosa injection arterial infusion from an implantedcatheter in the internal iliac artery

    :應用膀胱部分切除手術加粘下局部潤注射絲裂黴素和髂內動脈插管定期灌注順鉑和阿黴素治療膀胱癌20例。
  5. In this paper, the al3 + - doped zno thin films were prepared on na - ca - si glass substrate ( microscope slides ) by sol - gel process from 2 - methoxyethanol solution prepared by zinc acetate as premonitor, monoethanolamine as stabilizator and aluminum chloride reaction. homogenous, transparent, polycrystalline zno thin film was formed finally by diping coating conducted for film - plate on substrate, drying, pre - heat - treatment, anealing

    所用的溶膠是以乙二醇甲醚為溶劑,醋酸鋅為前驅體,乙醇胺為穩定劑反應制得,用漬提拉在基體上鍍,經烘烤、預燒、退火,最後形成均勻、透明的多晶zno薄
  6. According to the feature that deformation resulted from water absorption and mildew appear mainly on the rabbet surface of ccf, this paper adopts rsst to spray a special waterproof sealant on rabbet surface of ccf, so that the sealant can get into fiberboard to certain extent by means of capillarity and penetration, blockage the holes between fibers and capillary, cut up passage of water and change the properties of soakage and sorption to water in capillarity and fiber. at the same time, solidified sealant can form a compact waterproof pellicle on rabbet surface so as to prevent water and humidity from fiber ' s expansion and mildewing

    針對吸水變形、霉變主要發生在地板企口表面的特徵,採用企口表面全封閉,在復合強化地板企口表面噴塗特殊的防水封閉劑,使其依靠毛細管作用及滲透作用進入板內一定深度,堵塞木纖維之間的空隙及毛細孔通道,截斷水分傳遞的渠道,並改變毛細孔壁及纖維的表面性質以不利於水的潤與吸附,同時其固化后能在企口表面形成一層緻密的憎水薄,防止水分、濕氣從企口侵入板內引起木纖維膨脹變形、發霉等現象。
  7. Method : three kinds of mice ulcer models induced by binding and water immersion - restraint stress ( wrs ), alcohol and reserpine respectively ; the extent of gastric mucosal injury was evaluated grossly and histologically

    採用束縛水、乙醇、利血平誘導致小鼠急性胃粘損傷,以潰瘍指數及胃粘組織學改變為指標,觀察潰瘍康對不同實驗性胃潰瘍小鼠胃粘損傷的影響。
  8. Cell compatibility of films is researched firstly, which will make a significant contribution to the using fha films in practice from development. cell cycle, measured by flow cytometer and mtt method, and cell growth curve are used to analyze the impact of material and the immersed medium to the multiplication of osteoblast - cell

    通過mtt,流式細胞儀測定細胞周期,以及細胞生長曲線的測定,分析研究了fha薄材料對成骨細胞增殖生長的影響以及材料的提液對細胞增殖的影響,通過細胞相對增殖活性的測定對fha薄進行毒性評級。
  9. Immobilized tio2 films on pp by impregnating method

    在聚丙烯基體上負載二氧化鈦薄
  10. Then the gel film can be prepared by dip - coating or spin - coating technique on the surface of glass and followed by drying in the ethanol vapor

    使用漬提拉或旋轉塗敷,並通過放在乙醇蒸汽中乾燥,可在玻璃表面得到均勻的凝膠
  11. On the basis of study on structure and mass transfer, ideal model of membrane structure was built up, in which skin layer should be as thin as possible ensure resisting water to pass though membrane ; finger pore should be as long as possible in the membrane ; proper pore size ; loose sponge tissue

    首先對利用相轉化制備的微孔形態結構進行研究,確定傳導阻力較小的理想結構模型,緻密層在能阻止微孔被潤的情況下盡可能薄;指狀孔在厚方向所佔比例盡可能大;孔徑大小適宜;海綿狀組織結構疏鬆。
  12. Based on the infrared anomalous dispersion of compact alumina film, the character of alumina sols and the processing for fabricating compact alumina film were studied by using sol - gel method, combining dip - dropping, spin - coating method and electrophoretic deposition techniques

    本文基於緻密氧化鋁的紅外反常色散特性,結合溶膠-凝膠技術,採用漬提拉、旋覆和電泳沉積工藝,對氧化鋁溶膠的性質和緻密氧化鋁的制備工藝進行了研究。
  13. Oxygen diffusion transport and electrochemical reaction in the oxygen cathode of alkaline fuel cell ( afc ) and pemfc have been expressed with the tffa model, including oxygen transferring in gas channel of gas diffusion layer and reaction layer, oxygen dissolution and diffusion in thin - film of reaction layer, oxygen reaction and diffusion in flooded - agglomerate of reaction layer and the conduction of electron and ion. numeric algorithm of the model equations is also obtained

    本文將tffa模型應用於堿性燃料電池( afc )和質子交換燃料電池( pemfc )陰極,推導出陰極各種傳遞和反應過程的描述方程,包括氧氣在氣體擴散層和反應層氣體通道中的擴散,氧氣在反應層薄中的溶解和擴散,氧在反應層漬聚集體中的反應和擴散以及電子和離子的傳導,並給出方程的數值解
  14. This article is about the polymer separator full of holes, we research the performance of the separator, including making two kinds separters that produce wth complete different methods : spreading the separator, pvdf as the basic material, dbp as the plasticizing agent, nm sio2 as the inorganic addition and acetone as the solvent, and make separator on the special machine ; dipping in the separator so that intensify the seprater, its dip liquor is as the liqure as the spreading separator, and dip the base material pp / pe / pp into the liquor for more than 2 hours

    本文對多孔聚合物電解質隔進行了綜合研究。以聚偏氟乙烯( pvdf )為基體,鄰苯二甲酸二丁酯( dbp )為增塑劑,納米sio2為無機添加劑,丙酮為溶劑,在流延機上塗布得到了聚合物電解質隔。以流延制備隔的漿料為處理液,將基體材料pp / pe / pp泡在處理液中2h以上,制備出強化電解質隔
  15. Study on structure and performance of the charge - modified microporous membrane by coating process

    荷電微孔濾基本結構及性能研究
  16. The common method used by domestic and foreign scientists is removing the cobalt from the surface of the substrate by etching substrate using thin acid solution at room temperature. but the internal co will still overflow during mpcvd

    為降低成核及成過程中鈷的副作用,國內外通常採用的方是將硬質合金基體在室溫下用稀酸溶液泡一定時間,從而除去基體表面的鈷。
  17. Anodizing of aluminium and aluminium alloys - assessment of quality of sealed anodic oxide coatings part 2 : phosphoric acid chromic acid test with nitric acid predip

    鋁及鋁合金陽極氧化氧化封孔質量的評定方第2部分:硝酸預的磷鉻酸
  18. Anodizing of aluminium and aluminium alloys - assessment of quality of sealed anodic oxide coatings part 1 : phosphoric acid chromic acid test without nitric acid predip

    鋁及鋁合金陽極氧化氧化封孔質量的評定方第1部分:無硝酸預的磷鉻酸
  19. The hot - melt impregnation process of large tow carbon fiber ( 60k ) prepreg to prepare fishing rods is briefly introduced in this paper ; in addition, several typical factors which affect the quality of the prepreg are also discussed in detail here

    摘要本文簡要介紹了釣魚竿用大絲束( 60k )碳纖維預料熔膠漬工藝,並著重就影響預料質量的幾個主要因素進行了討論。
  20. Membrane filter elements - part 11 : determination of non volatile extractable components by soaking procedure

    式過濾器元件.第11部分:用測定非揮發性可萃
分享友人