液滴尺寸 的英文怎麼說

中文拼音 [yèdīchǐcùn]
液滴尺寸 英文
drop size
  • 液 : 名詞（液體） liquid; fluid; juice
  • 滴 : Ⅰ動詞（液體一點一點地向下落） drip Ⅱ名詞（一點一點地向下落的液體） drop; droplet Ⅲ量詞（用於滴下的液體的數量） drop
  • 尺 : 尺名詞[音樂] （中國民族音樂音階上的一級 樂譜上用做記音符號 參看「工尺」） a note of the scale in ...
  • 寸 : Ⅰ量詞（長度單位） cun a unit of length （=1/3 decimetre）Ⅱ形容詞（極短或極小） very little; very ...
  1. Similar comments apply for extinction due to the droplet size becoming insufficient.

    對于因液滴尺寸不斷減小而引起的熄火也可作類似的說明。
  2. This approach also gives undue importance to the small drop sizes, since it is assumed that they are never burned but always exist as in steady state.

    這個方法假設小尺寸液滴處于穩態下並不燃燒，因而對其重要性估計得過高。
  3. Standard test method for determining liquid drop size characteristics in a spray using optical nonimaging light - scattering instruments

    用光學無圖信號光散射儀確定噴射時液滴尺寸特性的標準試驗方法
  4. The stabilizing effects of increasing drop size were already discussed and will be further documented in the remainder of this selection.

    關于增加液滴尺寸所起的穩定作用已經討論過，並將在本節做進一步的證明。
  5. The test results showed that increasing droplet size was associated with better stability.

    試驗結果表明，增加液滴尺寸將使穩定性提高。
  6. Abstract : a continuity wave model is put forward for the dispersion processof liquid - liquid two - phase system, by coupling mass and momentum conservation equations of two - fluid model. the conditions that result in a dispersion choke and the weak instability of a dispersion process are derived from the model. the phenomena of catastrophic inversion and transitional inversion are explained. the effect of drop size distribution on the maximum volume concentration of a emulsion is predicted using the model. according to the theory herein, emulsion inversion is the regime transition of liquid - liquid system due to the instablity of a dispersion process. the effect of drop size distribution on the maximum volume concentration of a liquid - liquid emulsion only occurs in a certain range of weber numbers

    文摘:以雙流體模型為基礎，通過質量守恆方程和動量守恆方程的耦合，提出了液-液兩相系中彌散傳質的連續波模型.由該模型得到彌散傳質過程阻塞和彌散傳質過程弱不穩定性產生的條件，計算了液滴尺寸及其分佈對乳化液極大堆砌分數的影響，解釋了劇變型乳化逆變和漸變型乳化逆變現象.研究結果表明，乳化逆變是由於彌散傳質過程的不穩定性而引起的懸浮體型態的改變，隨液滴尺寸多分散性的增大，極大堆砌分數增大；隨液滴平均尺寸的增大，多分散性對極大堆砌分數的影響減弱；當韋伯數足夠大時，液滴尺寸及其分佈對乳化液極大堆砌分數無影響
  7. This type of dryer was fitful for liquid drying in concurrent, counter - current or mixed air - flow. the dryer can produce powders, granules, hollow spherical particles and agglomerates products. the spraying capacity and particle size were changed by altering the parts assembled in the nozzle

    壓力噴霧乾燥裝置其霧化器的結構適用易調，可通過改變噴嘴的內部結構得到所需要的噴液量和霧滴尺寸，目前該型式乾燥機已推廣應用於食品、化工、醫藥、建材、環保等行業。
  8. The numerical simulation is carried out and the sauter mean diameter and the axial and radial size distribution of droplet of round jets and annular jets were obtained. numerical results are in good agreement with experimental data

    針對hy911圓柱形射流和環形射流，計算出霧化液滴sauter平均直徑以及軸向和徑向液滴尺寸分佈，計算結果與實驗數據吻合較好。
  9. This thesis presents basic researches on spraying and atomization process of the liquid propellant - key issue of regenerative liquid propellant gun interior ballistic process. the distributing properties of droplet sizes in atomization field of liquid propellant hy911 were experimentally, theoretically and numerically investigated

    本文以再生式液體發射藥火炮（ rlpg ）為工程背景，圍繞rlpg內彈道循環的關鍵問題?液體藥噴射及霧化過程開展基礎研究，針對國產hy911液體發射藥，系統地進行了噴霧場液滴尺寸分佈的測試、理論建模與數值模擬。
  10. Standard test method for evaluation of drop size by weight of solutions and suspensions

    通過溶液和懸浮物的重量評價滴點尺寸的標準試驗方法
  11. Test method for determining liquid drop size characteristics in a spray using optical non - imaging light - scattering instruments

    光學無成像光閃射儀測定水霧中液滴尺寸特徵的方法
  12. Measurement on mean size of liquid droplets of fae dispersed by explosives

    爆炸拋撒后雲霧液滴尺寸的測量
  13. A simple model for primary breakup of energetic liquid jets was established using unstable wave theory. based on the jet - embedding method, the jet - core shape, the distribution of jet velocity and the primary distribution of liquid drops were computed

    使用不穩定波理論，建立了射流初始破碎的簡化模型，採用射流嵌入法（ je ）進行了數值計算，得到了hy911射流核形狀、速度分佈以及液滴尺寸的初始分佈。
  14. A model in which second atomization and collision among droplets was considered, for the droplet size distribution of energetic liquid jet was established on the basis of primary breakup model

    在此基礎上，考慮二次霧化以及液滴之間的碰撞，建立了含能液體噴霧場液滴尺寸分佈的數學模型，並進行了數值模擬。
  15. The paper gets some information about the outlines, velocity, areas, and change of gas films and internal contracts of balls in different sizes by using subtract operation, binary image, fill holes of images, and so on

    通過利用差影演算法減少背景噪聲、圖像的二值化處理和填充處理、氣泡特徵分析、氣泡中心坐標的確定等得到兩相流中氣泡、液滴和顆粒的尺寸和運動速度以及氣膜分佈等兩相流重要參數。
  16. Efficiencies are obtained by numerically solving the trajectory equations as the operation conditions and configurations of hydrocyclones are varied

    若給定旋流器幾何尺寸、操作參數及旋流器進口的油滴粒徑分佈，就可以預測液-液旋流器的分離效率。
  17. A technique invented by weitz and his colleagues produces equal - sized droplets of liquid crystal, each about a dozen microns across ( a micron is one thousandth of a millimeter )

    韋茨和他的同事們發明了一種產生相同尺寸液晶微滴的技術，每一滴大約12微米（一微米等於千分之一毫米） 。
  18. " in our case, because we make all the drops the same size, we ' re able to steer light in specific directions, " link says

    林克說： 「在我們的工作中，由於我們使所有液滴尺寸相同，我們就能控制光線射向特定的方向。 」
分享友人
分享到 Line

分享到臉書