液相操作 的英文怎麼說

中文拼音 [yèxiāngcāozuò]
液相操作 英文
liquid phase operation
  • 液 : 名詞（液體） liquid; fluid; juice
  • 相 : 相Ⅰ名詞1 （相貌; 外貌） looks; appearance 2 （坐、立等的姿態） bearing; posture 3 [物理學] （相位...
  • 操 : Ⅰ動詞1 （抓在手裡; 拿; 掌握） hold; grasp 2 （做; 從事） act; do; operate 3 （用某種語言、方言說...
  • 操作 : 1 （按照一定的程序和技術要求進行活動） operate; manipulate; handle 2 （所進行的若干連續生產活動的...
  1. Various sensors that are besotted in the 3d world through vrml can effectively sense all kinds of operators " behaviors ; java byte codes that are besotted in the interface between vrml and java through the " script " node can finish difficult tasks. so the alteration can be concluded as follows : operators touch parts of the shelf, and the java byte codes execute the relative function, finally results are reported to the operators. ( 3 ) through detailed studying the working function of the throttling experiment, i constructed a mathematical model of the experiment and simulated the model

    Vrml可以在瀏覽器環境中為3d實驗臺模型添加多種感知器，能夠良好地感知操作者的各種意圖；在vrml和java技術的介面中，可以利用java程序代碼來完成一些復雜的任務，從而實現了實驗的交互：實驗者感知實驗臺的各種儀器，程序完成相應的任務，然後返回相應的結果； 3 ）仔細研究了節流調速實驗的液壓迴路原理，對實驗過程建立了相關數學模型，進行模擬分析並獲得了模擬結果，實現了基於模型驅動方法的虛擬實驗； 4 ）實驗臺遠程訪問的實現。
  2. In addition, the hf in the downcomer of ctst plate is 110 ~ 150mm lower than that of fl valve plate. it was showed that making a comparison of two plates, the downcomer of ctst tray can cope with more operation loads with the same size downcomers

    這說明相同大小的降液管， ctst塔板上的降液管可處理的操作負荷比浮閥塔板的要大；即若在相同的操作負荷下，在設計降液管時， ctst塔板的降液管尺寸可比浮閥塔板的小。
  3. The modified expoxy resins, i. e. those with plasticizers added to improve workability, were found to be incompatible with the fluoro carbon flotation fluids.

    改性的環氧樹脂，即加入了可塑劑已改善操作性能的樹脂，與氟碳化合物的浮液是不相容的。
  4. Under suitable conditions, dark brown short rhombohedron crystals could be obtained from nifb mofe protein. both of the longest sides of the biggest crystal were o. lmm. the possibility and time of the formation of crystals, and number, size, quality, and shape of crystals obviously depended not only on the kinds and concentrations of the components in the crystalline solution, but also on the methods for crystallization and technical bias, etc

    對nifb ~ - mofe蛋白的結晶及晶體生長進行了的研究，初步探討了結晶溶液各組分的種類和濃度、結晶方法和實驗操作等與能否出現晶體及晶體的數目、大小、質量、形狀和出晶時間等的相互關系。
  5. Compared with the conventional chemical etching, laser assisted wet chemical etching can eliminate the effect of crystal orientation efficiently and fabricate more diversified etched pattern ; compared with the laser assisted gas chemical etching, the required condition for laser wet etching can be realized more easily and the operation can be simplified ; compared with the ion etching, it has advantages of no ion damage to substrate, avoiding over - etching and cost - effective

    半導體的激光誘導液相腐蝕與普通化學腐蝕相比，可以有效地消除晶體取向影響，製作出更加多樣化的腐蝕圖形;與激光誘導氣相腐蝕相比，其工藝條件更加容易實現，操作更加簡單;與干法離子刻蝕相比，對基片無離子損傷，過度腐蝕容易控制，成本低。
  6. Xenon computed tomography not only takes a picture of the brain, as does a traditional ct scan, but also allows doctors to measure exactly how much blood is flowing to different parts of the brain

    由計算機操作的氙氣層面x線照相術不僅可以象傳統的ct掃描儀那樣拍攝下大腦的圖像，還可以使醫生精確地測量出到底有多少血液流回大腦的不同部位。
  7. The effect of gas rates, liquid flow - rates, downcomer width, weir height and the addition of surface active agent on the liquid mean residence time, t, effective diffusion coefficient, de, and froth height, hf were studied. results obtained showed that for two systems, the t in the downcomer of ctst plate is 20 - 50 % smaller than that of fl valve plate, and the de is 40 - 70 % smaller than that of fl valve plate

    通過對氣速、液體流量、降液管寬度、堰高和表面活性劑加入的影響進行分析得出下面結論：在相同的操作條件下，對于兩種物系， ctst塔板降液管的液體停留時間比f1浮閥塔板的約小20 50 ，有效擴散系數比f1浮閥塔板的小40 70 ，泡沫高度低110 150mm 。
  8. Compared with routine hydraulic - mechanic transmission, it has many merits, such as excellent performance, compact structure, convenient handling and low price and so on. therefore, it has been used widely. in our country, as one of the key projects, it has been developed and researched

    與常規的液力機械傳動相比，汽車金屬帶式無級變速傳動具有性能優良、結構簡單緊湊、操作方便、造價低等優點，因而在國外轎車上獲得了大量應用，我國也將轎車金屬帶式無級變速器的開發和研製列入國家重大科技攻關計劃。
  9. Three models are proposed as follows by applying the model of " mixed flow " : the stress of increasing fluid on fouling, collision between solid particles and fouling, and solid particles movement velocity ; the effects of operating parameters, properties of particles, and the volume fraction of particles on stress in solid - liquid two phase flow, collision stress between solid particles and fouling, maximal contacting area between solid particles and fouling and maximal contacting time between solid particles and fouling are investigated systematically by calculating and theoretical analysis

    利用「混流」模型，建立了兩相流體的剪應力模型、固體顆粒與垢層的碰撞模型和固體顆粒的運動速度模型；通過計算和理論分析，系統地考察了操作參數、顆粒物性、顆粒體積分率等對固液兩相流剪應力、顆粒對垢層的碰撞力、顆粒與垢層的最大接觸時間和最大接觸面積的影響。
  10. The development of mass transfer in the system of vapor - liquid - liquid three - phase distillation from trays was introduced, the effects of the hydrodynamic conditions e. g. vapor velocity and ratio of liquid to vapor loading and physical properties of liquid phase, including surface tension, interfacial tension, viscosity or dispersion viscosity, density, relative volatility etc. and the volume ratio of oil to water on mass transfer were discussed systematically, the influence of the second liquid on mass transfer efficiency was also investigated, a gnat deal of viewpoints and suggestions having been put forward in this paper are significant important for optimizing design of distillation tower

    摘要介紹了氣液液三相精餾塔板傳質性能研究的進展情況，討論了氣速、液氣比等操作條件，表面張力、界面張力、液體的粘度或分散粘度、密度和相對揮發度等物系性質以及油水體積比等多種參數對傳質效率的影響，探討了第二液相的存在對傳質的影響，文中的許多觀點獲和建議對于優化精餾塔的設計具有重要的指導意義。
  11. Design verifications shall be done for any new components or design by review of alternative calculations and relevant test operations such as hydrostatic and functional tests

    任何新零件的設計確認都將進行變換方法計算和相關的測試操作，如液壓試驗和功能測試。
  12. Worthy products where a delicate filtering process and a careful handling of the crystals are required. products with fine grain size where the presence of the heel cake residual layer remaining on the cloth after scraping on

    因密閉操作和無機械卸料機構刮削擠壓濾餅的獨特卸料方式，使該機在需要保護固相結晶顆粒的形狀和純度以及固相物料具有觸變性的固液分離場合具有極強的應用價值。
  13. Solid - phase extraction is a new separating extraction method based on liquid chromatography theory since 70s, which is simple and quick, and the rate of medicine extraction is high

    固相萃取是70年代以來在液相色譜原理基礎上發展起來的具有操作簡便快速、萃取率高等優點的分離提取方法。
  14. In air - water system, the influence of gas superficial velocity on hydrodynamic parameters and volumetric mass transfer coefficient ( k, a ) is investigated. in order to simulate microorganism, a series doses of solid particle are added into water. in such an air - water - solid particle system, the influence of solid concentration on hydrodynamic parameters and volumetric mass transfer coefficient are studied

    在空氣-水體系研究了表觀氣速對流體動力學參數和傳質動力學參數的影響；以固體顆粒模擬生物相、以柔性填料模擬生物填料床在空氣-水-固體顆粒和空氣-水-填料體系中研究固含率對流體動力學參數和傳質動力學參數的影響；以cmc溶液模擬實際操作中的液相介質研究液相粘度對上述參數的影響； 4
  15. During the designing of the electricity control system, the thesis used the mode that made up of monitor system and control system, formatted a network that is combined by far concentrates control system and nearly control system. the monitor system chooses the functional monitoring software - the king monitor and the man - machine interface, which operated conveniently. and the control system chooses dependably programmable logic controller and advance profibus fieldbus to completely control the spot equipments. author hopes the thesis ' s researches can do a little for the development of the water power control technique, and the combination of the hydraulic technique and the advanced technique, author also hoping heartily the control technique of the our country develop quickly

    上位機選用功能強大的工控組態軟體? ?組態王和操作方便靈活的觸摸屏。下位機則採用可靠性高的可編程式控制制器和先進的profibus現場總線完成對現場設備的控制。作者希望通過該課題的研究，能夠對水電行業控制技術的發展，對液壓技術與當今先進技術更好的相結合，起到一定的促進作用，也衷心地希望我國的控制技術取得飛速的發展。
  16. The paper introduced the kind of fault for the hydraulic operating mechanisms of the lw6 series circuit breakers, analyzed its engendered caurse, and put forward the corresponding debugging and preventive

    摘要介紹了lw6系列高壓斷路器液壓操作機構的故障種類，分析了產生的原因，提出了相應的故障處理及預防措施。
  17. Standard practice for testing flame ionization detectors used in gas or supercritical fluid chromatography

    氣相色譜法或超臨界液相色譜法中使用的檢驗火焰電離探測器的標準操作規程
  18. Standard practice for use of reversed - phase high performance liquid chromatographic systems

    高性能液相色譜反向使用的標準操作規程
  19. In this paper, we applied the vapor - liquid - solid three - phase circulating fluidized bed evaporator to condense glucose solution considering its advantage. in the experiment, we changed the parameters such as evaporation temperature, difference in temperature of the fluid heating and heated, liquid flux, liquid thickness and the ratio of inert particles to analyze and study this kind of equipment ' s heat transfer properties in different operational conditions

    通過改變蒸發溫度、傳熱溫差、料液流量、料液濃度以及惰性粒子的體積分率等參數，研究了其在不同操作條件下的傳熱性能，並給出了汽-液-固三相循環流化床蒸發器沸騰傳熱的數學模型，模型預測值與實驗值吻合較好。
  20. The influence operating conditions on the hydrodynamics and mass transfer performance of alr, including superficial gas velocity, the properties and level of liquid phase, the properties and content of solid phase, as well as electrolyte and magnetic field, are discussed

    闡述了操作條件對氣升式反應器的流體力學和傳質性能的影響規律，包括表觀氣速、液相性質及液位高度、固相性質及固含率以及其他因素，如電解液和磁場等。
分享友人
分享到 Line

分享到臉書