混膠狀 的英文怎麼說

中文拼音 [húnjiāozhuàng]
混膠狀 英文
metamict
  • 混 : 混形容詞1. （渾濁） muddy; turbid2. （糊塗; 不明事理） foolish; stupid
  • 膠 : Ⅰ名詞1 （某些具有黏性的物質） glue; gum 2 （橡膠） rubber 3 （姓氏） a surname Ⅱ動詞（用膠粘） st...
  • 狀 : Ⅰ名詞1 （形狀） form; shape 2 （情況） state; condition; situation; circumstances 3 （陳述事件或...
  • 膠狀 : colloid; colloidal膠狀結構 colloid form structure; 膠狀巖 porodine; 膠狀油 gelled fuel （凝固汽油...
  1. Among the fibers are minute air spaces containing a glue-like mixture called ground substance.

    纖維之間有微小空隙，內含膠狀混合物，叫做基質。
  2. It can implement emulsion breaking, dehydration and remove water, soap, acid, color and metal particulate in emulsive turbine oil and low - viscosity lubricating oil as well as filtration of hydraulic transmission oil and antiwear hydraulic oil in machinery, turbine oil of electric equipment

    能對嚴重進水混濁乳化的透平油低粘度潤滑油進行破乳脫水，除去油中水分皂類膠質酸質色素及金屬微粒等機械雜質，使乳化狀油液變清澈。
  3. By analyzing and experimentally verifying the model, new ways of improving mixer performance were put forward. ( 1 ) heat water should be used in the mixer ' s temperature control to make the mixer work with optimal parameters. ( 2 ) the surface materials of the mixing chamber and rotors should be chosen rationally to change material surface energy and increase friction on them. ( 3 ) when the compound was processed under higher pressure of floating weight, shallow groovers or stripes parallel to the axle of the rotor should be made on the mixing chamber internal wall to increase the real contact area and improve mixing effect

    通過對模型的分析和實驗驗證，提出了提高密煉機混煉效果的新途徑： （ 1 ）密煉機溫度控制採用溫水冷卻，使密煉機處于最佳工作狀態； （ 2 ）通過合理選擇密煉室和轉子表面材料以改變材料表面能來增大膠料與它們之間的摩擦力； （ 3 ）在上頂栓壓力較大的條件下，在密煉室內壁與轉子軸線同方向加工淺的光滑槽可明顯改善混煉效果。
  4. The tragacanth gum is added to aid in keeping the entire mixture in solution.

    加入黃蓍膠有助於保持全部混合物呈溶液狀。
  5. Inorganic anti - cracking reinforced chemical additive, called wj, generates some tittle expansive crystals in hydration process in concrete to reduce the porosity and improve the distribution of pore size. the expansive power is process in common to tumefaction that petty crystalloid aft suck water and pressure to concrete pores that aft crystal gather volume. its adding weight was 8 % - - 12 % in cement, its restrained expansive ratio was about 0. 02 % - - 0. 06 %, and relevantil brought self - stress 0. 2mpa ?. 6mpa

    無機增強抗裂材料wj摻入普通混凝土中，在水化硬化過程中生成一定量的微膨脹結晶體，降低空隙率，改善混凝土中孔結構分佈。其膨脹驅動力是凝膠尺寸的晶體鈣礬石吸水腫脹和結晶狀鈣礬石對孔隙產生膨脹壓的共同作用。當wj摻量為8一12兒在鋼筋和鄰位的限制下，使混凝土產生0
  6. Can the state of mixing of black carbon aerosols explain the mystery of ‘ excess ' atmospheric absorption

    解釋『過度』大氣吸收的秘密能說明碳黑氣溶膠混合狀態嗎？
  7. The flocculation morphology is an advanced subject that researchs flocculation processes from the reality sha pe and size of the colloid and the flocculating agent in the water, according to the reality structure of flocks

    混凝形態學就是從水中膠體顆粒和所加混凝劑在水中的真實形狀和大小，以及由它們形成的絮凝體真實結構出發來研究整個混凝過程的一門較高層次的學科。
  8. The ratio of tetraethyloxysilane ( teos ) : ethanol : distilled water is 1 : 3 : 4. n - n " dimethyl formamide ( dmf ) was used as solvent and drying control chemical additive ( dcca ) in a proportion of 0. 3 dmf / ethanol volume ratio. drops of hf / hc1 mixture acid was added to promote hydrolysis ( ph = 2 )

    溶劑的選擇對基質凝膠孔的形狀基本沒有影響，但對其孔徑分佈有較大影響:在hf / hci混合酸催化情況下， dmf溶劑的樣品孔徑最小， dmf /乙醇混合溶劑的其次，乙醇溶劑的樣品孔徑最大。
  9. The study results indicated that, arranged in the order of magnitude, the degrees of the effects on the cementing strengths of the two interfaces were the system, emulsion, main emulsifier, fluid loss control agent and white oil respectively ; the cementing strength would be doubled and redoubled after being cleaned by preflush, especially by the system, emulsion and fluid loss control agent ; and, along with the increase in the mix slurry ratio, the initial and final set times of slurry would be obviously lengthened and the compressive strength of bond cement would be remarkably reduced or the slurry wouldn ' t be even set

    研究表明：對兩界面膠結強度的影響由大到小依次是體系、乳狀液、主乳化劑、降濾失劑、白油；前置液清洗后，膠結強度成倍提高，尤其對體系、乳狀液和降濾失劑清洗效果最佳；隨混漿比的增大，水泥漿初凝和終凝時間明顯延長，水泥石抗壓強度明顯下降，甚至不凝。
  10. Carbon fiber t300 was chosen as a co - hybrid fiber, and two different kinds uhmwpe fiber / t300 hybrid composites are prepared in both inner - laminar and inter - laminar styles. the inter - laminar hybrid composites exhibited better adhesion than the inner - laminar ones. for the optimized system dc88 / t300 / ve, the ilss reached 42. 5mpa

    在混雜實驗部分，研究了纖維狀況（纖維種類、處理與未處理） 、混雜方式、含膠量等對混雜結果的影響；藉助于sem以及建立的混雜模型對混雜機理進行了分析；對混雜復合材料進行了密度和耐濕熱性測試。
  11. In order to avoid the influence of trace metal to the stability of ferrate ( vi ), carbon fiber was more suitable, but it led to the problem of being prepared of the cathode, of emerging of the electrode ' s ear and of connecting between the base and shell

    所以直流電解法是制備電池級kzfoo4較為理想的方法。六、將電池級固體kzfzo4與膠狀石墨的混合物塗覆于玻炭電極、或填充于泡沫鎳基體上，在0 ? 0
  12. Comparing with the granitoid from jiaodong guojialing in mineralogy, the minerals in the granitoid in nimu - qushui granitoid crystallized in the environment of oxidization, the granitoid has a characteristic of rich volatile components and a high content of alkali, the rock - forming minerals and accessory minerals have a characteristic of i - type granite, and the granite shows a characteristic in favor of an and cu ore formation

    通過與膠東郭家嶺地區的花崗巖類的礦物學進行對比，可知本區花崗巖類礦物結晶時處于氧化狀態，具有富含揮發分的特徵，堿質含量高，造巖礦物及副礦物表現出型花崗巖特徵，具有殼幔混源物質，表現出有利於金、銅礦形成的花崗巖類的礦物特徵。
  13. The output signal of pda is affected by the suspended particle concentration, particle size, and the type and dosage of coagulant as well. by analysing the fi curve, it is found that the characteristic parameters of fi curve closely relate to aggregates size and turbidity removal the aggregates size and turbidity removal achieve the maximum when the amplitude of fluctuation is the maximum. the mean diameter and fractal dimension increase with agitation time, and finally reach a steady - state

    通過對混凝過程的在線監測和對pda輸出信號fi曲線的數學解析表明： fi曲線綜合反映了懸濁液中膠體顆粒濃度和顆粒粒徑，混凝劑種類和投量很大程度上影響了fi曲線形狀， fi曲線的特徵值與絮凝體平均粒徑和濁度去除率之間具有良好的相關關系，在振幅最大處，濁度去除率達到最高，絮體平均粒徑最大，該條件下對應的投藥量為最佳投藥量。
  14. In the presence of sodium hydrate, the polymerization of mixture cresol ( cm ) with formaldehyde resulted in the formation of low - density, monolithic, free - crack cmf organic and carbon aerogels

    以混甲酚（ c _ m ） 、甲醛為原料， naoh為催化劑成功合成了低密度、塊狀無裂紋c _ mf有機氣凝膠及炭氣凝膠。
  15. The equipment is featured by uniform mixture and continuous stability of extruded glue, good spreading effect and high production efficiency

    採用國內獨一無二的針狀單向閥確保混合體不會迴流。出膠連續均勻，塗膠效果好，生產效率高。
  16. A low detonation velocity explosive with medium density ( lg / cm3 ) and proper power ( > 320ml ). which made from obsolete propellant by controlling the granularity and adding the inhibitor, is studied in this thesis ; the distribution of water in the powdery propellant is described, the effect of detonation velocity from different granularity of powdery propellant is studied and the simulated mathematical model on leakage of water in low detonation velocity explosive is also showed furthermore, the method involved in controlling the leak of water in explosive is provided. meanwhile the effect of inhibitor is experimented some of formulations and processes of low detonation velocity explosive are given in details

    廢棄發射藥可直接用來製造凝膠炸藥，在發射藥顆粒的空隙中加入氧化劑和高分子的混合溶液，經過一段時間后氧化劑溶液變成凝膠狀態即可制得灌注炸藥，該灌注炸藥具有密度較高（ 1 . 4g / cm ~ 3 ） 、抗水、爆速較高的特點；文中對灌注液所涉及的材料、工藝流程進行了研究；分析了灌注炸藥的力學性能；利用灌注炸藥的高爆速及發射藥的低爆速組成一定形狀可用來形成特殊的爆轟波，利用matlab程序設計出了平面波發生器並對影響因素進行了討論。
  17. The first two chapter is about some basic acknowledgement of particle physic pertinent to our studying and summaries the researching state of jap decay in finding glueball, hybrids, multiple - quake state and the pwa method. the third chapter goes into particulars of how to use feyman rules to write out invariant amplitudes

    第一章和第二章分別簡略介紹與粒子物理和j粒子物理相關基礎知識，並敘述了粒子物理利用j豐富的衰變道尋找膠球、混雜態和多夸克態的研究狀況。
  18. But the surface characteristics is minor. when rigidity of granulated crumb rubber is increased, the performance of mixture is improved including compaction performance, volume performance and enduring performance. the ratio of coarse aggregates, granulated crumb rubber and coarse granulated crumb rubber are confirmed using the central composite design and response surface methodology

    研究結果表明，橡膠顆粒的形狀特性和力學特性對混合料的性能影響較大，隨細長扁平顆粒含量的減小，硬度的增大，混合料的壓實特性、體積特性和使用的耐久性增強;橡膠顆粒的表面特性的差異對混合料性能有一定影響，但其影響並不顯著。
  19. They are shape characteristics, surface characteristics and physical and mechanical characteristics. the technical index are confirmed through performance test. the results indicate the shape characteristics and the physical and mechanical characteristics are important to performance of mixture

    從橡膠顆粒的形狀特性、表面特性和力學特性角度入手，分析了橡膠顆粒的技術性質對橡膠顆粒瀝青混合料壓實特性、體積特性、彈性變形特性和耐久性能等的影響，並最終確定出瀝青混合料用橡膠顆粒的技術指標要求。
分享友人
分享到 Line

分享到臉書