渦流能 的英文怎麼說

中文拼音 [guōliúnéng]
渦流能 英文
eddy energy
  • 渦 : 渦名詞1. （漩渦） eddy; whirlpool; vortex 2. （酒窩） dimple
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 能 : 能名詞（姓氏） a surname
  1. Zmd catena of self inhale magnetic force pumps adopt structure of electrical engine direct link form, by centernog prop up, the structure is tightly, teardown and maintenance is convenient, adopt high - powered magnetism stuff nd fe boron to make inside and outside magnet. isolationsheath assembled make of import nonmetallic material, avoid magnetism backset ullage of the run - of - mill pumps have drastically

    Zmd系列自吸磁力泵採用電機直聯式結構，由中間支架支撐，結構緊湊，拆卸維護方便，採用高性能磁性材料「釹鐵硼」製造內外磁體，隔離套採用進口非金屬材料，徹底消除了一般磁力泵具有的磁渦流損耗，可輸送高濃度，密度大於1 . 84 t m
  2. Engine load simulated control system was consisted of two unattached parts of work resistance simulated control subsystem and electric bow wave dynamometer control subsystem. with the mathematic models of engine load simulation controller, which transferred the work resistance ' s change to engine load change immediately, the system can met the need of the simulation control system

    發動機負荷模擬加載控制系統包括彼此獨立的作業阻力模擬控制子系統和電渦流測功機控制子系統兩部分，應用發動機負荷模擬控制器數學模型，使作業阻力的變化及時轉換為發動機負荷的變化，能夠滿足模擬系統的控制要求。
  3. The types of the detection equipments and apparatus are over 100, such as x - ray detector, r - ray detector, digital ultrasonic flaw detector, eddy current flaw detector, eddy current flaw detector, magnetic memory metal diagnostic instrument, acoustic emission testing an analyzing system, three - dimensional ultrasonic testing system, microcomuterhydraulic pressureniversal testing machine, metalloscope, portable direct - read spectrograph, have achieved the national advanced technology

    擁有各種檢測設備100多套，如射線探傷機、數字式超聲波探傷儀、渦流探傷儀、磁記憶金屬診斷儀、聲發射檢測及分析系統、三維超聲波檢測系統、便攜式直讀光譜儀、微機式液壓萬能試驗機、金相顯微鏡等，達到國內先進水平。
  4. Among the five kinds of nde ways ( rt, ut, et, pt, mt ), ultrasonic testing technology develops very fast because of its merits such as good orientation, strong penetration ability, higher energy and no harm to human health

    在五大常規無損檢測方法中（射線、超聲、渦流、滲透、磁粉） ，超聲波無損檢測因其方向性好、穿透能力強、能量高以及對人體無害等優點而得到了迅速發展。
  5. The exterior and the install sizes all in the light of iso international criterion to design and make, the whole structure adopt after pull pattern of electrical engine direct link my companys patent, by centernog prop up, the structure is tightly, teardown and maintenance is convenient the bound of capability is broad the alnico of passing wrestdistance uses of advanced thulium material permanent magnet nd fe boron to make inside and outside magnet ; uses of the most streampadd nonmetallic material pad f46 inside to be made - up isolationsheath assembled and its provided with high strength dynam capability

    ，整體結構採用電機直聯的后拉式我公司專利，由中間支架支撐，結構緊湊，拆卸維護方便，性能范圍寬傳遞扭矩的磁鋼選用先進的稀土材料永磁體「釹鐵硼」製造內外磁體，使用最新型非金屬材料內襯f46製成的隔離套組合具有高強度的力學性能，徹底消除了一般磁力泵具有的磁渦流損耗，提高了整機的效率。
  6. On the basis of axial vortex theory, the aerodynamic performance of tilt - rotor model has been built, and using it to analyze the aerodynamic performance of xv - 15, comparing to the actual data to prove the model ’ s validity, finally studied the variety of aerodynamic performance relative to the variable rotor diameter

    以軸向渦流理論為基礎，建立了適合於傾轉旋翼機氣動分析模型，以xv - 15傾轉旋翼機作為算例，通過結果的對比，表明本文的氣動模型能較好的分析傾轉旋翼機的氣動性能，並在氣動性能的基礎上分析了直徑變化對傾轉旋翼機氣動性能的影響。
  7. The flow visualization indicates the primary cause of the phenomena to be a combination of mass transport and vortical structures induced by strong paraelectric and peristaltic electrohydrodynamic ( ehd ) body forces on the flow. the main jobs of this paper can be generalized as follow : 1

    流動顯示結果表明了該實驗現象的初步原因，由於在自洽電磁場中等離子體的電流體（ ehd ）順電力與蠕動力誘導了渦和能量輸運所致。
  8. Proceed from the angle of energy and taking considerations on interference factor and drag of airfoil profile, a kind of new typed calculation method on the design of vane air foil was put forward according to the vortex aerodynamics model of the rotor of wind turbines with horizontal axis

    摘要根據水平軸風力機轉子的渦流氣動模型，從能量的角度入手，考慮干涉因子和翼型阻力，提出了葉片翼型設計的一種新型計算方法。
  9. In cold gas fraction is one of the most important parameters at influencing the performance of vortex tube

    對渦流管性能受冷氣流分量的影響進行了實驗研究。冷氣流分量是影響渦流管性能的因素之一。
  10. Adjusting the cold gas fraction can control the performance target of vortex tube with fixed other parameters, which offers some referring data for practice applications of vortex tube

    在其它參數一定的情況下，可以通過調節冷氣流分量來改變渦流管的性能指標。為渦流管的實際應用提供了一定的參考數據。
  11. Eddy - current sensor conversion circuit consist amplification circuit, band - pass filter circuit, demodulation circuit, differentiation phase and data sampling circuit. these circuits are used to convert the test signal of eddy - current sensor to discrete signal tend to process. the microprocessor system that formed of dsp chip is used to data fitting of test system, data displaying and data communicating with personal computer, etc. the interference questions of hardware design and the measure of eliminating interference signal in the subject are introduced in the last of this chapter

    硬體電路的設計主要分三大部分來實現：激勵源電路部分，由分頻電路和頻率合成電路組成，產生頻率穩定的激勵信號以確保檢測任務的正常進行；傳感器變換電路部分，由放大電路、濾波電路、檢波電路、鑒相電路和數據採集電路組成，主要將電渦流傳感器檢測線圈檢測到的信號變換成只含有被測信息的離散信號，易於后續電路處理；由dsp晶元構成的微處理系統，主要完成檢測系統的數據擬合、顯示及與主機通信等功能。
  12. The basic parameters, such as temperature, pressure, turbulence kinetic energy and the turbulent kinetic energy dissipation rate, are also analyzed

    繪制了壓力和溫度曲線，以及壓力、溫度、渦流動能、渦流動能擴散率等值線圖。
  13. Since iron hearts of a very similar role to iron core magnetic - fluid changes will enable the inductance with the electrical frequency change, and therefore affect the dynamics of the electrical performance

    5 .由於爪極鐵心中的渦流作用引起鐵心磁導的變化，也就使電機的電感隨頻率而變化，因此影響電機的動態性能。
  14. The primary of linear induction motor which drives the metro is installed on the chassis bogie, and because it is quite strict with laying down railway rail to use flat linear induction motor to drive metro, its secondary - - - - reaction board ( called induction board ), which is a kind of compound board of aluminum and steel, is fixed on the rail sleeper between the track. it is the airgap which is a gap between the primary and secondary of lim. the electromagnetic airgap is a very important parameter of lim

    利用有限元法對直線感應電動機二維非線性渦流場進行了數值計算，並在此基礎上，運用電磁場有限元分析的專用軟體ansoftmaxwell2d對單邊型直線感應電動機的瞬態特性進行了模擬分析，得到電機運行過程中的電磁推力、法向力、初級電流、氣隙磁密等曲線，通過改變直線電機參數，分析了電機氣隙對其瞬態性能的影響。
  15. Performance improvement of remote field eddy current detection for ferromagnetic tubes corrosion

    鐵磁性管道腐蝕遠場渦流檢測性能的改進
  16. Vortexs are observed after the beams, which greatly influence the inlet air - flow of fan, reduces the air - flux, causes noise and wastes energy

    支承結構造成的流體繞流現象在風機進口處形成渦流，造成風機風量減少，噪聲增加，浪費能源。
  17. Against a prototype which is being produced ， its three dimension end region entity model of stator is established ， and with the aim of simplifying calculation ， the theory of how to simplify entity model is studied ， then the theory is made use of ， and the end region entity model of stator is simplifi - ed ； meshing characteristics of three dimension entity model and shortcomin - gs of end region entity model of stator are studied ， then meshing method of three dimension end region entity model of powerformer stator is studied as well ， and the simplified entity model is meshed with this meshed model ， the distribution of end region magnetic field of stator is analyzed ， and the magnetic field energy and reactance of powerformer end region are calculated and compared with design value because the prototype is being produced ， in this paper ， stator core ， gap and eddy equipment are not taken into consideration ， and this has a little influence on the result ， but through analysis ， the result is proved to be good through the example calculation ， it is known that the method of this paper is useful and through theoretic analysis ， it is proved that end region

    針對一臺生產中的樣機，對其建立了定子端部三維實體模型，而且為了達到簡化計算的目的，研究了如何將其簡化的理論，並應用這些理論對樣機定子端部實體模型進行了簡化；研究了三維實體模型的剖分特點和定子端部實體模型存在的缺點，在此基礎之上，研究了對簡化的powerformer定子端部三維實體模型的剖分方法，並且對簡化的實體模型進行了剖分。應用剖分的三維實體模型，用有限元法分析了powerformer定子端部的磁場分佈，計算了端部區域的磁場儲能，並利用磁場儲能計算了powerformer定子端部漏抗，將計算值與設計值進行了比較、分析。由於樣機處在設計生產階段，本文暫時沒有考慮定子鐵心、氣隙和渦流器件對端部磁場的影響，這對分析結果有一定的影響，但是仍然得到較好結果。
  18. Experimental study on the length of vortex hot tube effect on the performance of vortex tube

    熱端管長度對渦流管性能影響的實驗研究
  19. Compared with traditional electromagnet, this device has many merits. the article discusses methods of magnetization and demagnetization by the pulse of strong current. then the problems about whirlpool and material ' s selecting are discussed

    介紹了永磁起重吸盤的工作原理及相對于傳統電磁鐵的節能、省材、廉價、安全等特點，討論了應用電容儲能經rlc串聯二階電路放電產生的強電流脈沖對永磁體進行充、退磁的方法及渦流問題。
  20. Experimental study shows : it was able to distinguish between rotating stall and the inlet vortex.,

    實驗表明，旋轉失速和進口渦流能夠區分，且區域界限分離明顯。
分享友人
分享到 Line

分享到臉書