測波裝置 的英文怎麼說

中文拼音 [cèbōzhuāngzhì]
測波裝置 英文
wave-measuring device
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 波 : Ⅰ名詞1 （波浪） wave 2 [物理學] （振動傳播的過程） wave 3 （意外變化） an unexpected turn of even...
  • 裝 : Ⅰ名詞1 （服裝） dress; outfit; attire; clothing 2 （演員的化裝品） stage makeup and costume Ⅱ動詞...
  • 置 : 動詞1. （擱; 放） place; put; lay 2. （設立; 布置） set up; establish; arrange; fix up 3. （購置） buy; purchase
  • 裝置 : 1 （機器設備的配件）installation; device; apparatus; equipment; arrangement; gear; appliance; rig...
  1. Research and design of operating depth measurement apparatus for farm implement

    超聲波農機作業深度測量裝置設計與試驗
  2. For liquid xe aerosol spray target, important lpp characteristics, such as laser - to - euv conversion efficiency, euv radiation absorption, debris production by target material erosion or deposition, are studied in detail, a 13. 4nm conversion efficiency of 0. 75 % into 2 % bandwidth and 2 steradian emission solid angle is achieved at 0. 5mm laser - nozzle distance

    在實驗上，建成了一套高光譜解析度和高靈敏度的軟x射線脈沖輻射測量裝置。測量了co _ 2 、 o _ 2 、 cf _ 4 、 kr和xe液體微滴噴射靶lpp光源在6 20nm波段的軟x射線輻射光譜。
  3. We have developed a high precision wavemeter with an accuracy of 2 10 ^ ( - 8 ) in measuring vacuum wavelength, and a frequency measurement instrument by femtosecond modelocked laser with an accuracy of commercial cs standard

    為了適應研究工作的需要，研製了高精度激光波長計，測量真空波長的準確度可達2 10 ^ （ - 8 ）的量級，同時研製了飛秒鎖模激光的測頻裝置，目前的測量精度可與小銫鐘的精度相同。
  4. In this new method, the conventional espi system can be used to obtain the high quantitative phase results without using the phase shifting or the carrier device

    這種方法只需要普通的電子散斑干涉系統，就可以達到高精度的測量，而無需相移或載波裝置。
  5. This paper analyses the harm of power system harmonics. it also points out the significance of harmonics measuring and the developing condition of harmonics measuring device, and points out the significance of the research of this paper

    論文分析了電力系統諧波產生的原因及其危害，指出諧波測量的重要意義及諧波測量裝置的發展狀況，說明本論文研究的重要意義。
  6. Design and implement of the host computer software in power - line high frequency carrier wave channels test device

    電力線高頻載波通道測試裝置上位機軟體設計與實現
  7. At last, an intelligentized testing instrument for electric wire high frequency carrier wave channels is developed

    在此基礎上，研製開發出了一套智能化電力線高頻載波通道測試裝置。
  8. This paper uses an optically modulated scatterer system to measure microwave field with minimal disturbance. this method is especially adapt to measure magnitude and phase of microwave field close to conductor and microwave field with complex path between source and field. so it can be used to measure radiation antenna ’ s near - field and microwave into slots

    光調制散射器的測量方法最大限度地減少了測量裝置對被測場的擾動，特別適合於測量導體附近和具有復雜路徑場的幅值和相位分佈，可以用於對輻射天線近場的測試以及孔縫耦合中場的測量，可為天線的設計，微波孔縫耦合效應的研究提供較精確的實驗數據。
  9. In this article, a new design scheme of the fault locator for hv transmission lines is presented, which can realize both travelling waves location and fault analytical location

    本文設計了一套高壓輸電線路新型故障測距裝置，同時為行波法和故障分析法的實現提供了硬體支持。
  10. It is necessary to study the mechanism of harmonics generation, make sure the content and distribute of harmonics current in order to alleviate their harm to traction power system ' s component, equipments of protect and measure as well as other customer ' s electronics equipments

    為了從根本上抑制電力牽引負荷諧波帶來的影響，削弱諧波對牽引供電系統主元件、保護測控裝置和其他用戶電子設備的影響，有必要研究電氣化鐵道牽引諧波產生的機理，確定饋線電流諧波的含量與分佈狀況。
  11. The article describes an noncontact measuring instrument developed by use of ultrasonic and controlled by a chip computer, with which bitumen level in storage tank can easily be measured

    介紹了一種利用超聲波原理開發的由單片機控制的非接觸式測量裝置，通過該裝置可較方便地測量瀝青貯罐的液位。
  12. When the analyzer was located in four angles, a photoelectric detector was used to gather the energy of laser, so we can calculate the retardation of wave plate with the phase shifting

    測量裝置採用了步進電機帶動檢偏器旋轉，運用光柵編碼器測角裝置測量檢偏器的轉動角度，使用光電探測器採集檢偏器在四個方位角度的光強值，根據移相演算法得出波片的相位延遲角。
  13. There are two kinds of ways to measure the railway vehicle wheel tread irreguiarities. one is the static measurement that uses the mechanical ruler, electro - testing apparatus and device equipped with ccd. another is the dgnamic measurement that mainly depends on the technology of ultrasonic and ccd

    鐵路貨車車輛輪對踏面擦傷的測量方式可以分為靜態檢測和動態檢測：靜態檢測主要採用機械測量尺、電子測量儀和基於ccd技術的測量裝置；動態測量主要採用超聲波和ccd技術。
  14. We have built a special experimental set - up to measure brdf at the infrared wavelength and visible wavelength. the spatial brdf distributions of 2 optical surfaces and 5 absorption coat samples

    本文在長波紅外波段和可見波段，在實驗室建立了材料表面brdf的專門測試裝置，測得了可見和長波紅外波段兩個光學鏡面和5片「黑色」吸收塗層的brdf的空間分佈值。
  15. The resonant box effect is the most important. in chapter five, we use the experimental setup constructed and the cavity decay time method to measure the total loss of a passive resonant cavity, and analyse the experimental data in very detail. we conclude that, in present experimental conditions it is the uniformity and stability of laser mirror to confine the precision and repeatability of experimental results

    第五章在建立起了連續光波時間衰減法測量裝置的基礎上，進行了無源諧振腔總損耗的測量，仔細分析了實驗過程中的誤差因素，並指出在目前的實驗條件下限制測量精度和重復性的主要原因是激光鏡片的均勻性和穩定性不理想。
  16. This paper designs a device of testing the arc shield voltage in the vacuum interrupter, and makes a study of the arcing and after - arcing recovery characteristics of the arc shield by measuring the arc current, the arc voltage, the recovery voltage and the arc shield voltage

    本文設計了真空滅弧室屏蔽罩電壓測量裝置，並對真空滅弧室在燃弧和弧后介質強度恢復過程兩個階段的電弧電流、電弧電壓、恢復電壓和屏蔽罩電壓進行了全面、系統的波形測試，研究了真空滅弧室蒸汽屏蔽罩在燃弧和弧后介質強度恢復過程的特性。
  17. By using high - speed data acquisitioning unit designed specially to capture travelling waves of transient current, using global positioning system ( gps ) to supply high precise time tagging for both ends, using wavelet transform theories to identify the head of the travelling waves, the fault locator can realize high precise double - ended travelling waves location

    該測距裝置採用專門設計的高速采樣單元捕獲暫態電流行波信號，用全球定位系統（ gps ）為線路兩端提供精度高達1 s的統一時標，用小波變換理論識別暫態電流行波波頭信息，從而可以實現高精度的雙端行波法測距（ 150m ） 。
  18. Single crystal wafers applied for surface acoustic wave device - specification and measuring method

    表面聲波裝置用單晶薄片.規范和測量方法
  19. Single crystal wafers for surface acoustic wave device applications - specifications and measuring methods iec 62276 : 2005 ; german version en 62276 : 2005

    用於表面聲波裝置的單晶矽片.規范和測量方法
  20. There are two kinds of way to measure the wheelset geometric parameters. one is the static measurement which uses the mechanical ruler, electro - testing apparatus and device equipped with ccd. another is the dynamic measurement which mainly depends on the technology of ultrasonic and ccd

    輪對幾何參數的測量方式可分為靜態檢測和動態檢測：靜態檢測主要採用機械測量尺、電子測量儀和基於ccd技術的測量裝置；動態檢測主要採用超聲波和ccd技術。
分享友人
分享到 Line

分享到臉書