測溫劑 的英文怎麼說
中文拼音 [cèwēnjì]
測溫劑
英文
tempil-
Flame temperature measurements can be used as a guide in discussing energetics of a homogeneous propellant.
火焰溫度的測定可作為討論均質推進劑能量特性的指導。In order to improve the performance of the maleic anhydride - co - acrylamine copolymer water - reducing agent, the copolymer is monoesterified with the polyethylene glycols. the fluidity of the esterified copolymer has been increased 60 %, and it has good retarding performance
通過對不同條件下得到的共聚物的酯化產物的性能的測試得到初始中和度、引發劑用量、反應物濃度、反應溫度與酯化產物性能的關系。The anion surfactant nals was the most efficient in the process and was selected as collector by orthogonal method. the interfacial tension and cmc of nals ( cmc 6. 5 10 - 3m ) in the solution was measured by hanging ring test, the function relationship between interfacial tensions and nals concentration was : = - 0. 9523 in 2c - 24. 534 in c - 81. 411. the relation of interfacial adsorption equilibrium in the solution system was respectively tested and calculated with gibbs equation and dynamic method. the conclusion showed that ( 1 ) the experiment result of dynamic method with was highly in coordination with the value which from theoretical calculation. ( 2 ) the surfactant molecule was in arrangement of monomolecular layer at the gas - liquid interface
用吊環法測定了十二烷基硫酸鈉水溶液不同濃度與其界面張力的關系，擬合得到的回歸方程為= - 0 . 9523ln ~ 2c - 24 . 534lnc - 81 . 411 ，同時還測得其臨界膠束濃度值（ cmc為6 . 5 10 ~ （ - 3 ） m ） ，運用吉布斯等溫方程和動態法分別計算和測定了該溶液系統的界面吸附平衡關系，結論表明： （ 1 ）動態法測定結果基本吻合吉布斯方程的理論計算； （ 2 ）表面活性劑分子在氣?液兩相界面是以單分子層形式定向有序排列的。The imported transparent glaze fired at lower temperature was analysed semi - quantitatively by adopting emission spectroscope. the stripping of lead and cadmium from this transparent glaze fired at lower temperature in ceramic product was determined by atomic absorption spectroscope. the effect of chemical composition on the stripping of lead and cadmium was analysed. upon the author s opinion, the overproof lead stripping from the imported transparent glaze fired at lower temperature can only be settled by adopting lead - free glaze instead of adopting low - lead prescription. the author succeeded in developing an excellent lead - free transparent glaze fired at the lower temperature of 1000 1050. the success is based on an inquiry into the feasibility of using such new agents of fusion as li2o and sro in replacement of pbo ; and on a study of the effects of the contents of sio2 ， al2o3 ， b2o3and other metallic oxides on such performances of glaze as coefficient of linear expansion, fusion temperature and transparency. it is also based on an analysis of coefficient of linear expansion of blank and glaze on an analysis of coefficient of linear expansion of blank and glaze on their correlation ; and on a study of technology for preparing glaze
採用發射光譜儀對進口低溫透明釉進行半定量分析，並用原子吸收光譜儀測定其陶瓷製品的鉛、鎘的溶出量，分析化學成分對鉛、鎘溶出量的影響.結果表明，進口低溫透明釉採用低鉛配方不能解決鉛溶出量的超標問題，只有採用無鉛釉才能解決.探討用氧化鋰和氧化鍶等新型熔劑完全代替氧化鉛的工藝，研究釉料中氧化硅、氧化鋁、氧化硼和各種金屬氧化物的含量，對釉的線膨脹系數、熔融溫度和透明度等性能的影響.分析坯料、釉料的線膨脹系數及其相互關系和釉料制備的工藝，研製出優質的1000 1050低溫無鉛透明釉Determination of ignition temperature of pyrotechnic composition - dta - tg analysis
煙火藥劑著火溫度的測定差熱-熱重分析法In order to make clear the regulation of the combustion and the heat - transport process of fire - retardant treated wood, the combustion of untreated, fire - retardant solution soaked, and fire - proof paint coated white pine ( pinus bungeana ) and northeast china ash ( fraxinus mandshurica ) wood as well as the rising process of temperature at different sites in wood were measured in this study, taking a multi - function fire - proof experiment oven to simulate the typical process of fire
摘要為了弄清楚阻燃處理木材的燃燒及其熱傳導規律，該研究採用多功能耐火實驗爐模擬典型火災的發生過程，測定了未處理、阻燃劑水溶液浸漬處理、塗刷防火塗料白皮松和水曲柳木材的燃燒及木材內不同位置的升溫過程。Adhesives for load - bearing timber structures - test methods - determination of the effect of acid damage to wood fibres by temperature and humidity cycling on the transverse tensile strength
承重木結構用膠粘劑.試驗方法.通過溫度和濕度循環試驗測定木纖維酸性腐蝕對橫向拉伸強度的影響Water adhesives. aminoplastic. determination of conventional gel time at different temperatures
水性粘合劑.氨基塑料.不同溫度下膠凝時間的常規測定Testing of lubricants ; procedure for measurement of low temperature apparent viscosity by means of the brookfield viscometer liquid bath method
潤滑劑試驗用brookfield粘度計測定低溫表觀粘度The study was performed to isolate biosurfactant - producing bacteria from composting at different temperature, 45 and 55, biosurfactant ' s producing was determined by measuring the surface tension of fermentation
從不同溫度的堆肥過程中（ 45和55 ）篩選產生物表面活性劑的細菌，生物表面活性劑的產生通過測定其發酵液的張力值來判斷。The dual - bath coagulation method suggested by j. a. va n ' t hof could be used in membranes with high selectivity clearance rate of low - molecular weight substances and moderate water flux theoretically. therefore it may be applied in the field of hemofiltration. to improve and optimize the performance of the pes ultrafiltration membrane applied in the hf, here the flat membranes and hollow fiber ( hf ) membranes are made in certain conditions based on the dual - bath coagulation method where pes is used as the membrane material, dmso as solvent and pvp & peg as additives this paper includes five parts as follow : 1
為了改善和優化聚醚碸超濾膜（單浴法）在血液過濾實際應用中的性能，本論文以j . a . van ' thof等提出的雙凝固浴法為基礎，以聚醚碸（ pes ）為主要成膜材料，以二甲基亞碸為溶劑，並添加一定分子量的致孔劑（ pvp ，聚乙烯吡咯烷酮）以及一定分子量的添加劑（ peg ，聚乙二醇）按照一定配比在一定溫度下製成透明均一的鑄膜液，靜置脫泡后在一定的工藝條件下製成聚醚碸平板膜和中空纖維膜，然後通過測試膜的結構和性能來評估其用於血液過濾中的前景。Methods of test for adhesives - physical tests on hot - melt adhesives - determination of low temperature flexibility or cold crack temperature
粘合劑試驗方法.第h2部分:熱熔粘合劑物理試驗.低溫撓性及冷爆裂溫度測定Adhesives for paper and board, packaging and disposable sanitary products - determination of low temperature flexibility or cold crack temperature
紙，紙板，包裝和一次性衛生產品用膠粘劑.低溫柔韌性和凍裂溫度的測定Abstract : the dynamic interfacial tension at crude oil / water interface was studied by drop volume method at different temperatures and concentration of demulsifier
文摘:採用液體體積法測定了原油/水體系在不同溫度和不同破乳劑濃度下的非平衡態界面張力，並對水相不同離子價態對界面張力的影響進行了研究。After the sample is turned out, its internal and external structures are observed and its bulk density is measured in order to determine how the sintering temperature, the time of thermal preservation, and the quantity of admixture affect the performance of lytag
通過對試樣內、外部結構觀察和容重的測定，研究燒成溫度、保溫時間及外加劑摻量對粉煤灰陶粒性能的影響。Abstract : based on the fundamental principle of hypothesis strain equivalence, itwas investigated a physical concept of high strength concrete at minus temperature ( hscmt ) freezing damage parameter, the elastic modulus of frost concrete with anti freeziug admixture and without antifreezing admixture built and it was analyzed their variate process and the condition adaptated. it is purpose to judge hscmt frost failure process
文摘:從應變等效性假說的基本原理出發，研究了負溫混凝土凍結損傷參數? ?彈性模量法中受凍后測試的損傷混凝土彈性模量的物理概念，從而分析了摻防凍劑混凝土及不摻防凍劑混凝土受凍后的彈性模量變化過程及其選用該參數的適應性條件，為判斷負溫高強混凝土材料凍結失效過程提供保證。We research the causes of concrete cracking, develop the high performance anti - cracking additive, optimize the concrete mix and construction techniques, increase the stability of concrete volume by shrinkage compensation, enhance splitting tensile strength, and can meet demand of high workability of fresh concrete. in the study, a thorough investigation of this problem is made from all points of view, with the aid of various modern measurement & testing technology and different theories & methods in surface physical chemistry, structural chemistry, solid - state chemistry, composite materials, fracture mechanics, etc. our research results have shown that the various shrinkage of concrete cause concrete cracking in building engineering, such as autogenous shrinkage, dry shrinkage, temperature shrinkage, plastic shrinkage, carbonized shrinkage, etc
目前，解決混凝土開裂的方法是綜合的，我們調查研究了混凝土開裂的原因，開發研製了高性能抗裂外加劑，優化混凝土的設計和施工方法，並通過補償收縮達到混凝土體積穩定，提高抗裂強度，滿足混凝土拌和物高工作性能的要求。本研究採用多種測試技術，應用表面物理化學、結構化學、固體化學、復合材料學、斷裂力學等多學科的理論與方法，從不同的角度進行深入的研究和探討。通過調查研究建築工程中出現的混凝土開裂、滲漏問題，發現混凝土在非荷載作用下開裂主要是由混凝土的自收縮、乾燥收縮、溫度收縮、塑性收縮、碳化收縮等各種收縮變形引起的。The soi is of crystal quality and the box is uniform in thickness, with the interfaces of si / sioa / si smooth and sharp. we have systematically studied the dependence of the formed soi structure on the process parameters, such as ion energy, implantation dosage, substrate temperature, as well as the annealing temperature. with xtem, sims, srp, rbs, ir, raman, aes, xps and other characterization tools, it was found that a dose window at fixed energy for water plasma ion implantation to form high quality soi structure similar to the conventional simox process exists
本論文還系統地研究了不同注入劑量、注入能量、注入時基底溫度以及退火溫度對所形成soi結構性能的影響，藉助xtem 、 sims 、 srp 、 rbs 、 ie 、 raman 、 aes 、 xps等測試分析手段，我們發現，與傳統注氧隔離（ simox ）技術類似，存在著「劑量窗口」形成優質的soi材料，但在水等離子體離子注入方式中soi材料結構質量對劑量變化更為敏感，隨著注入劑量的增大， soi材料的埋層厚度增大而表層硅厚度減小。Surface active agents - determination of krafft point and solubility of ionic surface active agents
表面活性劑.測定離子表面活性劑的臨界溶解溫度克拉夫特點和溶解度Standard practice for determination of fusion temperature of dry electrostatic heat - fixing toners
干靜電熱定影的調色劑熔化溫度的測定分享友人