測熱的 的英文怎麼說

中文拼音 [cèrède]
測熱的 英文
calorimetric
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 的 : 4次方是 The fourth power of 2 is direction
  1. Test method for calorimetric determination of hemispherical emittance and the ratio of solar absorptance to hemispherical emittance using solar simulation

    用太陽模擬裝置作陽光吸收與半球發光量的比率及半球發光量的熱量計測定的試驗方法
  2. V2o5 and vo2 thin films are a kind of outstanding chromogenics, and have a large potential for various applications, such as display devices, light storage devices, optical switch, bolometer, smart - windows and so on

    主要應用於顯示器件、光學開關、光存儲、激光保護、輻射測熱裝置等，特別是在智能窗材料方面的應用已成為研究的熱點。
  3. An initial measurement is carried out and the result shows that the bolometer is still sensitive to the infrared signal even the intensity of the signal source is very weak, if the bolometer is in a proper temperature

    初步的測量表明，在最佳工作溫度點附近，器件對信號具有靈敏的響應。這就為器件的進一步測量和製作奠定了基礎，也為熱探測、熱成像等工作的進行提供了可能。
  4. Practical applications for heat flow measurements in ocean floors are the location of hot brines.

    洋底熱流量測量的實際目的是圈定熱鹵水的位置。
  5. Power for the thermal cycler shall be provided with a manostat or a ups to avoid the influence on pcr amplification arose by fluctuation of voltage

    熱循環儀的電源應專用，並配備一個穩壓電源或ups ，以防止由於電壓的波動對擴增測定的影響。
  6. Thermal damage in insb detector induced by cw laser

    型探測器的熱損傷
  7. This dissert aims at developing the high - speed temperature - measuring instrument for the application of high energy density heating

    本課題針對高能量密度加熱過程中高速測溫的需要進行專用測溫儀的研製。
  8. Tensile properties and impact properties measurements were done at room temperature. the volume resistivity of rectangular samples was measured using a zc36 electrometer and a high 240a voltage supply, for samples with a low resistivity level a dt - 9205b digital multimeter was used, silver paint was applied to ensure complete contact between sample and electrodes, namely, to eliminate the contact resistance. the phase morphology of blends was also studied using a jeol jsm - 5900lv scanning electron microscope ( sem )

    體積電阻率的測定：當r _ v 10 ~ 8時，製成100 100 4mm板材，用zc36型高阻儀測量；當r _ v 10 ~ 8時，用dt - 9205b型數字式萬用表測試試樣的體積電阻，為了減小接觸電阻對測試的影響，採用銀導電膠將銅片粘接在試樣的兩個端面上，靜置24小時，待銀導電膠凝固，試謝長瓊:熱拉仲對pet / pe / cb復合導電體系形態和性能的影響樣的電阻穩定后再測量。
  9. Standard practice for determining the steady state thermal transmittance of fenestration systems

    主窗設計系統固態導熱系數測定的標準規程
  10. Also the theoretical basis of the method have been checked through simple deducing simulation and the influences of various physical parameters on the method have been studied. it is shown that the method is theoretically reliable for the production oil wells without very high production rate and is more suitable in field production for oil wells ( i ) in area with bigger geothermal gradient ; ( ii ) producing fluids ( oil and water ) with distinguish thermal characteristics ; ( iii ) producing oil with lower heat capacity or water with higher heat capacity ; ( iv ) with good surface measurement accuracy, as well as the method h as certain requirements on the accuracy of the temperature and flowmeter logs sensors

    就該產出剖面方法的理論基礎進行了簡單的正演模擬和可能影響該方法的各項物理參數進行了全面的考察，結果表明，該方法對于非高產的生產油井來說在理論上是可靠的，在實際生產中適合於（ 1 ） 、油井所在地區地溫梯度較大的油井； （ 2 ） 、油水熱特性差別較大的油井； （ 3 ） 、油比熱容值偏低水比熱容值偏高的油井； （ 4 ） 、井口計量精度較高的油井，並且對井溫測井和流量測井的傳感性精度有一定的要求。
  11. The pyrogen test is a method to test the existence of pyrogens by using rabbits

    熱源質檢測是通過用兔子來檢測熱源質存在的方法。
  12. The energy smart setting shall monitor element usage and adjust the tank temperature for usage pattern detected

    節能智能設置將監控加熱元件的使用情況，並根據監測到的用戶的使用習慣調節熱水水溫。
  13. Improving the specific heat measurement of solid state materials

    固體比熱測量的實驗改進
  14. Furnace and thermal processes - equipment with a temperature gauge used for processing wafers. a constant temperature is required for the process

    爐管和熱處理-溫度測量的工藝設備，具有恆定的處理溫度。
  15. By develop the new type thermostat module which is specialized in the thermoelectrical hgcdte infrared sensor, i have studied some advanced temperature control technique and mapped out a scheme of fuzzy pid control

    本課題通過開發專用於熱電製冷型hgcdte紅外探測器的新型溫度控制器模塊，深入研究了當前比較先進的控溫方法，設計了模糊pid控制的總體方案。
  16. It is hard to get the important parameters such as link delay and loss rate directly, because the internet has becomes massive, distributed and heterogeneous. network tomography is now a hotspot for inference the internal link delay and loss rate with the end - to - end measurement data. we call current network tomography as unconstraint network tomography for its not adding any constraint condition and all of them nearly are based on some likelihood algorithm

    由於網路日益向著大型化、異構化、分佈化發展，通過直接進行網路測量的方法，來獲得網路內部鏈路的時延和丟包率參數就變得越來越困難，網路層析成像方法作為一種通過端到端的測量數據來推斷網路鏈路性能參數的技術正成為研究的熱點之一。
  17. We made use of wheatstone bridge to control ratio of heating power between the samples, thus, it enable to control and measure the differential heating power accurately. consequently, it improves sensitivity of the system. the resolution of the measurement can reach from 1 : 1000 to 1 : 10000 or better in comparison with the traditional differential technique

    我們測量了聚苯胺及其摻雜鹽酸后在1 . 8k至45k的熱容，利用聲子分形子模型來處理非晶態對比熱的貢獻，對獲得的數據進行處理，發現eb和es的比熱數據均不符合德拜理論，超出德拜模型的比熱來源於非晶態的貢獻。
  18. The predicted stability limits often differ appreciably in magnitude from those observed in hot firings.

    預計的穩定性極限往往在數值上與熱試中測得的明顯不同。
  19. Application of fluorescence assay method on rapidly detection of food

    套式逆轉錄聚合酶鏈反應在黃熱病毒快速檢測中的應用
  20. Thermal exchange is key factor to influence caloric determination, and it will cause temperature dissipation in caloric measuring system during the course of measurement

    測量過程中由於內外桶溫差而導致的熱交換，是影響準確測熱的關鍵，必須對此散失的熱量進行校正。
分享友人
分享到 Line

分享到臉書