測角光度計 的英文怎麼說

中文拼音 [cèjiǎoguāngdùjì]
測角光度計 英文
goniophotometer
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 角 : 角Ⅰ名詞1 （牛、羊、 鹿等頭上長出的堅硬的東西） horn 2 （古時軍中吹的樂器） bugle; horn 3 （形狀像...
  • 光 : Ⅰ名詞1 （照耀在物體上、使人能看見物體的一種物質） light; ray 2 （景物） scenery 3 （光彩; 榮譽） ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  1. In this thesis, the development of emulsion polymerization theory and related new technologies are comprehensively reviewed, and the synthetic technologies of acrylate latex modified by organosilicon both at home and abroad are also reviewed. based on the current development and research in this field, attentions of this study are focused on three ways for preparing novel acrylate latexes modified by organosilicons, that is, 1 ) the acrylate monomers are copolymerized with unsaturated silicons by emulsion copolymerization ; 2 ) a new latex with microphase separation morphology is synthesized, which shows a core - shell structure character ; 3 ) soap - free polymerization is explored for preparing a higher - performance latex using an unsaturated silicon monomer, different acrylates and a reactive emulsifier. by using techniques of delaying addition of organosilicon monomer and a hydrolysis inhibitor, the hydrolysis and condensation of 3 - ( trimethoxysilyl ) propyl methacrylate during polymerization can be effectively prevented, as a result, organosilicon content in the macromolecular chain is increased

    同時採用有機硅單體延遲滴加及添加水解抑制劑等技術，有效防止了-甲基丙烯酰氧基丙基三甲氧基硅烷在乳液聚合過程中的過渡水解及縮合反應，提高了聚合物大分子鏈中有機硅鏈節的含量；利用紅外光譜與差示掃描量熱儀對產物分子結構進行了表徵，並通過對共聚產物力學和吸水率的測試，證實了本研究所制備的有機硅改性丙烯酸酯共聚物具有比純丙烯酸酯聚合物更優良的力學及耐水性能；從分子設計角度出發，利用醇解反應合成出水解、縮合反應速率較慢的兩種新型不飽和有機硅單體： ?甲基丙烯酰氧基丙基三乙氧基硅烷和?甲基丙烯酰氧基丙基三異丙氧基硅烷；利用核磁共振對新型硅烷單體結構進行了證實；研究表明利用新型硅烷單體可以制備出高硅烷含量的有機硅改性丙烯酸酯乳液，且其聚合產物具有較高的力學及耐水性能。
  2. The study of comparison of corneal diopter measured by corneal keratometer and corneal topographer

    角膜曲率計與角膜地形圖儀測量角膜屈光度的對比研究
  3. The laser radar sub - system determines the heights of the tsp according to the slant height and the oblique angle measured by the laser range finder and the electronic theodolite simultaneously. by lucubrating the motion law of tsp, we decided to compute decent velocities with least - squares procedure & two ranks curve fitting

    地面激光雷達跟蹤測量分系統根據測量到的斜距離和俯仰角確定末敏彈傘彈系統的高度，在深入研究末敏彈穩態掃描過程的運動規律后，通過最小二乘法的二階分段曲線擬合，計算出落速。
  4. ( 2 ) on - line spectral response measurement is used to make a research on the activation process. the on - line measurement results have been analyzed and the influence excised by cs, o activation on the photoemission property of gaas wafers has been revealed. the properties of domestic and foreign nea phocathodes are compared, and the reasons causing the gap between domestic and foreign phocathodes are discussed

    （ 2 ）利用光譜響應在線測試技術研究nea光電陰極的激活工藝，通過對在線測試的光譜響應曲線進行分析、比較和計算，剖析了激活工藝給陰極光電發射性能帶來的影響，並從性能評估的角度，比較了國內外nea光電陰極的性能，分析了它們之間存在差距的原因。
  5. Based on the model of resource survey spaceborne laser altimeter, the noncooperative regulable attenuation module, including angular measure setting, beam splitter, energy meter, attenuator and simulant target, was designed and founded

    結合激光高度計原理樣機，設計並建立了非合作目標可調衰減法模塊，該模塊包括角度測量裝置、分束片、能量計、衰減器以及模擬目標物。
  6. Standard test methods for measurement of gloss of high - gloss surfaces by abridged goniophotometry

    用簡化濾色測角光度計測定高上光表面光澤度的標準試驗方法
  7. This paper designs an optical system based on above to measure the small angle of the laser beam. a non - polarized beam splitter ( npbs ) is used to split the incident beam into two branches, and a rhombic prism agglutinated by two right - angle prisms is placed to realize total internal reflection twice in each branch. it not only improves the measurement sensitivity and linearity, but also increases antinoise ability by the differential optics

    本文正是基於這一原理設計了測量光束微小偏轉角的光路系統，用消偏振分光棱鏡將入射光分為兩路，並在兩路分別用兩個直角棱鏡組成的斜方棱鏡來實現兩次全內反射，不但提高了測量靈敏度和線性，還利用差分光路的特點提高了抗干擾能力。
  8. The evaluation of uncertainty in improving precision by adjusting the spectrometer twice

    分光計二次調整法提高三棱鏡頂角測量精度
  9. The chief results and conclusion thus arrived at are as folloes : ( 1 ) the morphology and electrical properties of indium - tin - oxide ( ito ) films which were treated respectively by ethanol, naoh, sulfuric and oxygen plasma, were studied from microscopic view by atomic force microscopy, x - ray photoelectron spectroscopy and goniometer

    （ 1 ）利用原子力顯微鏡、接觸角測試儀、紫外分光光度計從微觀角度研究了乙醇、氫氧化鈉、濃硫酸、氧等離子體處理對ito薄膜的表面性能和光電性能的影響。
  10. The article analyses wide angle laser signal receiving system and the receive sensitivity of system, and studies the problems on circuits designing of laser receiving system

    對廣角激光信號接收系統和系統的探測靈敏度進行了分析，研究了激光接收系統電路設計問題。
  11. Aluminium and aluminium alloys - anodizing - part 13 : measurement of reflectance characteristics of aluminium surfaces using a goniophotometer or an abridged goniophotometer

    鋁和鋁合金.陽極化.第13部分:用測角光度計或濾色測角光度計測量鋁表面的反射特性
  12. Aluminium and aluminium alloys - anodizing - part 13 : measurement for reflectance characteristics of aluminium surfaces using a goniophotometer or an abridged goniophotometer ; german version en 12373 - 13 : 2000

    鋁及鋁合金.陽極化處理.第13部分:使用測角光度計或濾
  13. The principal axis torsion angle, produced by torque, is converted to two channel square waves with phase difference through grating sensor. then the degree of torsion angle is measured by data collection card. finally the value of torque and the other parameters of the axis can be calculated by upper pc

    將主軸受扭矩作用而產生的扭轉角，通過光柵傳感器轉換為兩路有相位差的方波信號，再通過數據採集系統檢測出扭轉角的度數，最後由上位pc機計算出扭矩的大小和主軸的各種參量。
  14. Fiber optic gyro ( fog ) inertial system provides angular velocity and acceleration measurement of measurement body along three axes, based on the attitude matrix refreshed by outputs angular velocity to transform the acceleration from the body frame to the earth frame, finally through acceleration integral we can get the position of the measurement body in the space. fog is popular in the navigation field for many advantages, such as wide dynamic range, high resolution and all solid components

    該測量方法利用捷聯式光纖陀螺輸出的角速度和加速度信息，測出運載體沿三個方向的加速度分量；再利用光纖陀螺輸出的角速率信號，不斷更新測量體的姿態轉換矩陣，將加速度分量用轉換矩陣更換到地理坐標系；最後經過計算機對轉換后的加速度信號積分運算分別可得到運載體在三維空間中的位置。
  15. The main idea of this research can be summed up as following words, reflecting light or scattering light upon the surface of measured object formats an image on the photo surface of psd by a optical system, because of the good relationship between the offset of image point in psd and the offset of object thickness, a mathematical model can be founded according to this relationship. it can measure the shift of object thickness through these analyses of movement of image point position in psd, and this device can be tested its reliability with many practical specimens

    光學式非接觸厚度-微位移測量儀是在激光三角測量法的基礎上實現的，在本研究方案中，根據象點在psd上的移動量建立與被測物厚度-微位移變化之間的數學模型，通過對象點位置變化的計算，實現被測物厚度-微位移變化量的測量。本文重點闡述了光學式非接觸厚度-微位移測量儀的工作原理，並對測量儀的工作過程進行了分析；對影響測量精度的因素做了討論。
  16. Aluminium and aluminium alloys - anodizing - measurement of reflectance characteristics of aluminium surfaces using a goniophotometer or an abridged goniophotometer

    鋁和鋁合金.陽極氧化.用角度光度計或濾色角度光度計測量鋁表面反射特性
  17. Compared with the ordinary optimization algorithm of calibration, this algorithm is simple, less computational and high accuracy. finally, the paper put forward the ranging method based on similar triangle principle. it gives two ranging models according cooperation object vertical in the optical axis or not vertical in the optical axis and does experiment

    最後，本文提出了一種基於相似三角形原理的測距方法，根據合作目標與攝像機主光軸垂直與不垂直兩種情況，給出了兩種測距模型，建立實驗系統並進行了實驗，通過近距離段與遠距離段的測距結果與誤差分析驗證了此方法的有效性，能夠準確的確定合作目標的位置，計算簡單，測量精度高，具有重要的理論意義和工程使用價值。
  18. The influence of using different methods to measure corneal refractive powers in determining the power of intraocular lens

    不同儀器測量角膜曲率計算人工晶體屈光度的可行性分析
  19. The system is composed of inverse - fourier - transform system, optic fiber sensor and high sensitivity ccd. its software system of signal acquisition and data processing used the platform of virtual instrument labview. we tested system stability and investigated latex particle size from 32nm to 123nm, several phenomenon below have been found : ( 1 ) the experiment result is consistent with the theoretical arithmetic result of the relation between particle size and normalization light scattering energy at the position of 7 ? and 35 ? angle

    組建了包括反傅立葉變換系統、光纖傳感器以及高靈敏度ccd的大角度側向光散射信號探測系統，設計了基於虛擬儀器labview平臺的信號採集和數據處理軟體，對系統穩定性和顆粒尺寸從32納米- 123納米的微乳液顆粒球進行了測試研究，發現以下現象： （ 1 ）在與光軸成7和35夾角的位置，歸一化的散射光能量與粒徑大小關系的實驗結果跟理論分析規律完全一致。
  20. In chapter three, the importance of maintaining the equal optical path between measuring beam and reference beam in measuring horizontal and vertical vibration table are analyzed, and the factors having effect on contrast degree of interference fringe are introduced. for improving the accuracy of laser - vibration - measuring - system, the phase - modulation - multi - period - average method and the vibration isolated of system are analyzed

    第三章分析了光路設計中的等光程問題的重要性，以及影響干涉條紋對比度的相關因素；並從提高測量精度的角度分析了調相多周期平均法和系統的隔振。
分享友人
分享到 Line

分享到臉書