測速誤差 的英文怎麼說

中文拼音 [chā]
測速誤差 英文
velocity measure error
  • : 動詞1. (測量) survey; fathom; measure 2. (測度; 推測) conjecture; infer
  • : Ⅰ形容詞(迅速; 快) fast; rapid; quick; speedy Ⅱ名詞1 (速度) speed; velocity 2 (姓氏) a surna...
  • : Ⅰ名詞(錯誤) mistake; error Ⅱ動詞1 (弄錯) mistake; misunderstand 2 (耽誤) miss 3 (使受損害...
  • : 差Ⅰ名詞1 (不相同; 不相合) difference; dissimilarity 2 (差錯) mistake 3 [數學] (差數) differ...
  • 測速 : logging speed
  • 誤差 : error
  1. Aiming at the calibration of traffic radar, this paper analyzed shortcomings of conventional calibration method which be used in radar speed gun calibration regulations ( jjg528 - 2004 ) and put forward two new methods to verify it and developed speed standard instrument

    摘要針對公路交通中雷達儀的檢定問題,分析了《雷達儀檢定規程》 ( jjg528 - 2004 )中規定的檢定方法的不足之處,提出了兩種新的雷達儀檢定方案試數據記錄比對法和試數據實時比對法,並研製了相應的度標準裝置(測速誤差0 . 5 % ) 。
  2. From a numerical simulation on a practical possible mode : uniform acceleration - uniform speed - uniform deceleration, we obtain the relationship between the measurement error and the acceleration value

    以勻加勻減運動為例,分析了與加度之間的關系,模擬結果驗證了該方法的可行性。
  3. Abstract : the hot wire anemometer and the ensemble average method are used to measure and study the dispersion turbulent transient feature in a closed cylindrical explosion bomb. the comparison of the dispersion turbulent parameters from different shapes of closed explosion bombs is presented. the relation between errors and numbers in dispersion turbulent measurement with the ensemble average metod is discussed

    文摘:採用熱線風儀和系綜平均法定和研究了封閉圓柱形粉塵爆炸罐內揚塵湍流的瞬態特性,並與球形爆炸容器內已定的揚塵湍流瞬態特性進行了比較,對系綜平均法用於揚塵湍流的量次數的關系進行了探討。
  4. It is discussed that the present harmonic analyzers do n ' t satisfy the requirements of china standard for harmonic measure of quick disturbance harmonic load. the measurement error brought about by the harmonic analyzers adopting ft or fft algorithm is analyzed. a cycle discrete fourier algorithm that should n ' t be effected by aperiodic component is presented, and the results of simulation show that it has higher accureacy

    本文對電力系統諧波的量方法,數據處理及電力牽引負荷對電力系統的影響進行了研究,論述了目前國內外生產的諧波分析儀用於快波動諧波負荷的量不滿足國標的要求,分析了諧波分析儀普遍採用的ft或fft演算法所產生的,提出了一種不受非周期分量影響的全周波離散傅里葉演算法,模擬結果表明精度好。
  5. The static drift error and dynamic test error of liquid floated reactive rate gyro are analyzed also

    分析了液浮力反饋率陀螺的靜態漂移和動態
  6. Taking intercontinental ballistic missiles as objects under research, and based on the analysis of the influence of accelerometer measurement error and gyroscope excursion error on the apparent acceleration, the error transfer model of the inertial system in a midcourse guidance segment for velocity and location is given, and the pure inertial navigation guidance error is computed with the given imu error coefficient deviations

    摘要針對洲際彈道導彈,在分析加度計和陀螺漂移對導彈視加度影響的基礎上,給出了中制導段慣性系統對度和位置的傳遞模型,對給定的慣組系數偏進行了純慣性導航制導計算。
  7. Then, this paper presents an improved t measuring speed method basing on t measuring speed method, and simultaneously realizes speed and angle measuring with two quadrature encoder pulse circuits of tms320lf2407a. the measuring speed formula is amended based on measuring speed error analysis

    其次,在t法的基礎上提出了一種改進的t法法,並利用tms320lf2407a的兩組正交編碼電路同時實現度與角度量,在分析測速誤差的基礎上,對公式進行修正。
  8. In this paper, by analyzing the measuring of instantaneous speed, it was found that the main error is come from the angular measuring error, and then the method to decrease the error is given and the measurement precision is improved greatly

    摘要通過分析柴油機飛輪瞬時轉,指出角度是飛輪瞬時轉的主要來源,從而提出了減少的方法,提高了瞬時轉量精度。
  9. Concerning the problem of the frequency instability, slight but not negligible, in electric power system, this paper discusses the resultant error in measurement in detail and develops an error - correction interpolated algorithm in frequency domain. taking advantage of the high calculating speed of pc, the measurement error in frequency, amplitude, and phase are well eliminated

    本文針對電網頻率輕微但不可忽視的不穩定造成的問題進行了詳細的討論,形成了一套在頻域實現校正的方法?插值演算法,並利用pc機高的數據處理能力軟體校正了各次諧波的頻率、幅值及相位。
  10. The relative difference between values of dry density measured by wave velocity method and pir replacement method is in the range of 1 %

    根據相關方程由實壓實干密度值,相對試坑置換法的實值,在1 %范圍內。
  11. In pool trial, the author compare the real - time results with the post processing results, which enhance the precision of velocity measurement. and we process the trial data using statistics methods, achieving that velocity measurement error is normal distribution

    在多普勒計程儀水池試驗部分,對實驗數據進行了後置處理,提高了精度,並對數據進行了統計處理,得出測速誤差呈正態分佈的結論。
  12. The main tasks of this thesis are : discussing the dead - reckoning theory of doppler velocity log and compass, decreasing location error methods, emulating several ship tracks ; discussing several aspects influencing the velocity precision of doppler velocity log ; in a pool trial, processing the trial data and achieving some conclusions

    本論文主要研究工作包括:對羅經和多普勒計程儀推算輔助導航系統的工作原理,及減小定位的兩種方法和幾種軌跡進行了研究;對影響多普勒計程儀測速誤差的各個方面進行了綜述;最後對多普勒計程儀水池試驗的數據進行了處理,得出所要結論。
  13. Project and error analysis about one way and single frequency non - coherent carrier wave velocity measurement

    單程單頻非相干載波方案及測速誤差分析
  14. Analysing the error in the bullet velocity measurement under water

    水下槍彈分析
  15. In influencing measuring velocity, the author emphasizes on researching on the compensation for sound velocity ; in the processing of data, gives processing results

    在多普勒測速誤差一章中,重點對聲補償技術進行了研究,並在數據處理部分,給出了處理結果。
  16. Measuring velocity precision is very important. in this thesis, the author researches on the location precision of doppler velocity log and compass, the precision of velocity precision of doppler velocity log

    本論文就是針對這兩方面而做的,主要圍繞著輔助導航系統的定位精度和如何減小多普勒計程儀的測速誤差進行的。
  17. These factors are concluded in this paper. primary parts of these factors are analyzed in detail and corresponding mathematic expressions are given, numerical calculation is also processed. solutions of some factors caused errors are given

    本文總結了引起測速誤差的各種因素,特別對其中一些主要因素進行了詳細地分析,並給出了相應的數學表達式,進行了一些定量計算,對其中一些導致的來源給出了解決方案。
  18. The phase detecting error caused by local oscillator frequency drift and non - synchronization of measurement signal and gate signal is eliminated and the measurement speed is improved at the same time

    該方法可以有效的消除因本振信號頻率漂移及閘門信號與被信號的非同步引起的,同時提高了度。
  19. Moreover, the effects of the system parametric ( such as baseline length, time measure error, sound velocity fluctuate and buoys errors ) on localization accuracy are studied. the laws of the bistatic tol and bol localization algorithm are obtained

    同時,通過對各種系統因素,如基線長度、系統、聲波動、浮標偏移等參數對演算法性能影響的分析,得出了採用tol和bol方法進行定位時,定位的分佈規律。
  20. Base on the analysis of the grating linear displacement measurement theory, the measure errors especially the subdivision error of the grating scale, this paper focuses on the theory of switch and merge of dual grating scales ’ signals, builds the design criteria of high speed high precision displacement measurement by using dual grating sales, designs the switch picking reference with high precision and fast switch and merge method, analyses the errors brought in by switch and merge of the duals grating scales

    在分析光柵線性位移量原理、光柵尺的尤其是細分的基礎上,本文重點研究雙光柵尺切換與合成的原理,建立了基於雙光柵尺高高精度位移量的設計準則,根據設計準則設計了切換基準拾取方法以及快切換與合成方法,分析了雙光柵計數值切換合成的
分享友人