測量噴口 的英文怎麼說

中文拼音 [cèliángpēnkǒu]
測量噴口 英文
measuring nozzle
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 噴 : 噴動詞1. （液體等受壓力而射出） spurt; spout; gush; jet 2. （噴灑） spray; sprinkle
  • 口 : Ⅰ名詞1 （人或動物進飲食的器官; 嘴） mouth 2 （容器通外面的地方） mouth; rim 3 （出入通過的地方） ...
  • 測量 : measure; survey; gauge; meter; measurement; measuring; surveying; mensuration; metering; gauging;...
  1. First of all, this paper analyses present problems existing in the boiler combustion monitor system of power plants, then put forward the signification to realize precision measurement for the primary and secondary air speed of boiler and the necessary conditions to solve efficaciously this problem

    本文首先分析了目前電站鍋爐燃燒監測系統中存在問題，提出鍋爐實現一、二次噴口風速準確測量的重要性以及有效解決該問題所需要滿足的必要條件。
  2. At the end of the experiment, we reconstructed the subsystem of second air measuring, i. e. we used airfoil measuring equipment as a replacement of original equipment of flute pipe. we also demarcated the velocities of spouts of burner which can deal with correlative data, and which can provide some help for operation

    最後又對監測系統二次風測量子系統進行改造，將原笛型管裝置修復為機翼測風裝置，對傳感器進行差壓標定;在爐內噴口處標定速度，將數據進行處理，提供給熱工控制顯示用，對運行調整提供了幫助。
  3. Abstract : optimum distances between primary nozzle exit and mixing tube inlet, static pressure recovery of the mixing flow in mixing tube 、 total pressure distributions at the exit of mixing tube 、 pumping coefficients and total pressure losses of the exhaust ejector systems with four different types of primary nozzles have been measured in the experiments

    文摘:對4種主噴管組成的排氣引射系統的引射系數和總壓損失、各主噴管出口與混合管進口之間的最佳間距、混合氣流在混合管內的靜壓恢復及混合氣流在混合管出口處的總壓分佈等進行了測量和對比。
  4. Longradar offer approximate ten thousand of products of pressure, vacuum, flow, air velocity, temperature, humidity, level and valves, which are commonly applied in the fields of industrial automation, hvac, building autoimmunization control, electric power, petroleum, chemical industry, boilers, water treatment, compressors, freezing refrigeration, food brewage, pharmacy, light industrial, environmsent protec - tion, clean industry etc

    在上游安裝一個帶有蛋形格柵的橢圓形流體噴嘴，可以提供一個精確構造簡單的空氣體積測量系統。在噴嘴的出口，空氣釋放時的風速分配是一致的靜壓為零。因此，噴嘴上游的總壓力是噴嘴出的速度壓力-於是就容易計算體積了。
  5. By use plc, system can complete function as follow : this auto - control system be applicable to the temperature and smoke and dust the deal the variety quick, control the process is difficult with the operation is ; by the temperature controlor can automatically follow to the wet tower " exit temperature, error in the ? 3 v including ; by to automatically spray fog to lower the electric resistance, with the function for full the electricity equipment accepting the dust ; because of adopting feedback closed loop, and come to a to respond to the speed quick, constant temprature control the accuracy is high ; because of adopting the sensors, and make the system circumstance to leak water quick ; system have many control parameter can set exit control temperature and adjust value low limit by key ; can communication with remote computer and have remote control

    通過使用plc ，使該自控系統可以完成如下功能：適用於溫度及煙塵量變化快、控制過程難以操作的場合；通過溫控表自動跟蹤增濕塔出口溫度，誤差達到3以內；通過自動噴霧來降低粉塵比電阻，以此充分發揮電收塵器的作用；由於採取了閉環反饋迴路，達到了響應速度快，恆溫控制精度高；通過使用各種檢測傳感器，使得異常情況泄水快；該自控系統具有多套控制參數，增濕塔出口控制溫度及調節閥下限值可通過按鍵設定；可與上位機通訊，具有「現控遠控」功能。
  6. Experimentally, the plasma produced by cable plasma gun ( c - gun ) and dense plasma focus ( dpf ) was measured by the laser differential interferometer system. the clear interference patterns were acquired at different time. the contour maps of line integral density and curves of radial local density at different height above nozzle were presented

    實驗上，對等離子體斷路開關中的電纜等離子體槍（ c - gun ）和等離子體焦點裝置（ dpf ）產生的等離子體進行了測量，獲得了對應不同時刻的清晰的干涉圖像，給出了線積分密度等值線圖和距噴口不同高度處的徑向密度分佈。
  7. The actuators are nozzle vetor controller, rotational measuring valve controller and vane controller. the smart actuators are capable of data collection, self - calibration, power - on self - test and local close - loop control, etc. a simplified mathematical model for the vector nozzle is constructed, and the relationship between the state of vector nozzle and actuator cylinders ’ position is obtained. the effect of the position controller is tested

    實現了智能執行機構的數據採集、自校準、上電自檢測和局部閉環控制等功能，建立了矢量噴口實驗件的簡化數學模型，推導了矢量噴口狀態和作動筒位置之間的關系，並在含實物平臺上對位置控制器的效果進行了實驗驗證。
  8. The relationship between critical pressure ratio and solid / gas ratio is thus found to provide a reference for choosing appropriate jet pipes and conditions for their applications

    實驗測定了質量流量與出口壓強的關系，定義了臨界壓強比可作為判定壅塞發生與否的依據，並找出了臨界壓強比與固氣比之間的變化規律，給出了實用噴管的選擇依據和使用條件。
分享友人
分享到 Line

分享到臉書