測量變量 的英文怎麼說

中文拼音 [cèliángbiànliáng]
測量變量 英文
measured variable
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 測量 : measure; survey; gauge; meter; measurement; measuring; surveying; mensuration; metering; gauging;...
  1. Compensated instrument transformator

    補償測量變壓器
  2. Fyd multi - channel wind pressure measure transmitter

    Fyd系列多路風壓測量變送器
  3. Ds series single - channel wind pressure measure transmitter

    Ds系列單路風壓測量變送器
  4. The first stage is primary slip then followed by secondary slip ; the last stage is due to dislocation passing the slips. the cyclic stress strain ( css ) curve exhibits a stronger hardening occurred in cyclic plastic deformation than that in tensile test

    建立了拉伸和應變疲勞的有限元模型，使用基於晶體滑移模型的數值方法，對晶體內部滑移系的啟動以及滑移繫上的分解切應變、切應力這些無法試驗觀測的變量進行計算，分析它們對晶體塑性變形的不同影響。
  5. Aiming at the study actuality of fan performance monitoring system and analysis of fan performance curve changes affected by inlet - box and the different fixed - angles of guide blades in the course of installation, a fan flow monitoring model based on rbfnn in whole flow zone was established in this thesis. in the model, the method of no throttle and fan performance curve were used as basis. and on the basis of that model, fan performance curves of 4 - 73no. 8d were approached with experimental data of different speed, different opening - angles of guide blade and different resistance of pipeline, the precision and the error law of model were studied

    本文針對電站風機性能監測系統研究較少的現狀，在實驗的基礎上分析了現場加裝進氣箱和由於安裝造成的導流器葉片開度不一致對風機性能曲線的影響，並在此基礎上採用無節流方法測量流量，以風機調節性能曲線為依據，建立了基於徑向基函數（ rbf ）神經網路的風機流量全程監測模型；以實驗室4 - 73no . 8d離心風機為研究對象，探討了rbf神經網路差壓模型在變轉速、變導流器開度和變管網阻力等工況下的應用精度和誤差分佈規律；最後用visualc + +語言開發了風機性能在線監測系統。
  6. This project is applied to the control circuit of the frequency converter power source of for measuring ground resistance in an electric substation

    此方案成功地應用於變電站接地電阻測量變頻電源控制電路中。
  7. Partially linear relationship model with errors in some variables observed at net - points

    基於網點觀測的變量不全含誤差的部分線性函數關系模型
  8. Calibration specification for magnetical coupling measuring

    磁耦合直流電流測量變換器校準規范
  9. Measuring transducer with electrical output

    電量輸出測量變換器
  10. Electrical measuring tranducers for converting a. c. electrical quantities to analogue or digital signals

    交流電量轉換成模擬信號或數字信號用電氣測量變換器
  11. Electrical measuring transducers for converting a. c. electrical quantities to analogue or digital signals

    交流電量轉換成模擬信號或數字信號用的電氣測量變換器
  12. Electrical measuring transducers for converting a. c. electrical quantities to analogue or digital signals ; amendment 1

    交流電量轉換成模擬信號或數字信號用的電氣測量變換器.修改件1
  13. Electrical measuring transducers for converting a. c. electrical quantities to analogue or digital signals ; amendment 2

    交流電量轉換成模擬信號或數字信號用的電氣測量變換器.修改件2
  14. Symbol, word, size, site, color of measured variables

    測量變量的符號、文字、大小、位置、顏色。
  15. Variable range shall be within the pricision recognized by system

    測量變量的變化值應在系統可識別的精度范圍內。
  16. The content of studying in my thesis are as follow : first is the selection of direct measuring values

    研究內容主要包含了以下幾個方面：一、直接測量變量的選取。
  17. By using temporal redundancy, upper and lower bounds of process measurements are added in the modified sicc method to avoid the misidentification of gross errors

    改進后的演算法利用時間冗餘性，加入對過程測量變量的上下限約束，避免了顯著誤差的誤判。
  18. To solve the problems caused by the varieties of the missile dynamics with the difference of flight height, velocity and attitude angle in modeling the missile, in this thesis, the theory of variable structure model reference adaptive control is used to design a pitch channel autopilot based on a longitudinal missile model, the status equation using the measurable parameters of load and angular rate is established, and the methodology to choosing the reference model is discussed also, and the performance of the controller is analyzed by means of simulation

    為了解決攔截彈氣動參數隨飛行高度、速度、姿態的不同，變化范圍大，控制系統難以準確建模的困難，基於縱向平面攔截彈模型，採用模型參考變結構控制理論設計了俯仰通道姿控復合控制系統，以可測量變量過載和角速度作為狀態量建立了系統的狀態方程，討論了參考模型的選擇方法，並對系統的性能作了模擬分析。
  19. The suitable oil flux during the circulating of transformer could be defined according to the difference of temperature between the oil and wind in the inlet and the cooling capacity of the wind cooling system ; besides the oil flux can be determined by ultrasonic, it can be estimated whether the oil is flowing equably by determining the oil flux in the branch pipes ; reducing the oil flux of the oil pump could be realized by controlling to change its frequency, which could not only save the energy, reduce the wastage, but benefit the transformer ' s circulating safely

    變壓器運行中可根據進口油溫和進口風溫之差、風冷卻器的冷卻容量來確定合適的油流量；油流量可以通過超聲波法進行測量，測量油的分管流量還可判斷油流的均勻情況；降低潛油泵流量可通過潛油泵的變頻控制來實現，不僅節能降耗，對變壓器的安全運行也有著重要意義。
  20. On the basis of piv measurement of the gas solid velocity field, the size and the numbers of particles are measured by newly developed image processing software. the results are identical with the variation of the factual size of particles. by the viable datum, the average size of particles in the cross section is calculated in the dilute phase area of circulating fluidized beds ( cfb ) riser

    在piv測速系統基礎上，通過二次開發的圖像識別軟體，實現不同工況下各截面顆粒粒徑分佈的測量，測量結果基本反映出實際顆粒粒徑變化，證明了該方法的可行性，進一步獲得了循環流化床稀相區顆粒粒徑分佈特性。
分享友人
分享到 Line

分享到臉書