測量迴路 的英文怎麼說

中文拼音 [cèliánghuílù]
測量迴路 英文
measurement circuit
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 測量 : measure; survey; gauge; meter; measurement; measuring; surveying; mensuration; metering; gauging;...
  1. Pre - data gathering module achieves the collection and communication of sixteen - route temperature signal. speed measuring and controlling module realizes the control of refolw soldering transfer speed by manipulating transducer. on - off outputting module fulfills calefaction control of calefaction tube by solid state relay. above position operator software programs by delphi, and realizes pid parameter automatic timing and no - oversnooting temperature control. software has friendly interface, convenient operation, complete functions

    前置數據採集模塊完成16路溫度信號的採集和通訊；速度測量模塊與速度控制模塊通過控制變頻器來調節迴流焊的傳輸速度；開關量輸出模塊通過固態繼電器對加熱管進行控制；上位機軟體採用delphi編程，實現了pid參數自整定以及無超調的溫度控制。
  2. Intelligent electricity quantity concentration display instrument is a kind of intelligent instrument used to measure combined parameter of ac electricity quantity, which can simultaneously measure each phase electricity parameter in the tri - phase ac loop such as voltage, current, active power, reactive power, apparent power, power factor, frequency, active kilowatt hour, reactive kilovolt ampere - hour and so on

    智能電量集中顯示儀是一種用於交流電量綜合參數測量的智能儀表，它可以同時測量三相交流迴路的每一相電壓電流有功功率無功功率視在功率功率因數頻率有功電度無功電度等參數。
  3. Any subtle change of capacitance can be measured through the method of modulation on high - frequency harmonic oscillation return circuit

    電容的微小變化可通過對高頻諧振迴路調制的方法進行測量。
  4. The probe ' s linearity, temperature and dynamic characteristics are analyzed base on principal theory of eddy - current displacement sensor, such as the influence of the coil q value to the linearity characteristic, influence of the diameter of coil to the linearity characteristic, influence of coil resistance to the temperature characteristic, influence of the measuring coil to the syntony loop

    在介紹渦流位移傳感器的基本理論的基礎上，分析了傳感器探頭線性特性、溫度特性、動態特性的影響因素。從探頭線圈q值對線性特性的影響；探頭直徑對線性的影響；探頭線圈電阻對溫度特性的影響；激勵信號溫度特性的影響：檢測線圈?振迴路動態響應特性等方面分析並提出製作高質量傳感器探頭的改進措施。
  5. Adopt advanced microprocessor for smart control, it is suitable for display and control temperature, humidity, pressure, liquid level, instantaneous flow, speed and so on in many physical quantity inspect signal, and can data - logging multi - channel measure signal

    採用先進的微處理器進行智能控制，適用於溫度濕度壓力液位瞬時流量速度等多種物理量檢測信號的顯示控制，可巡迴檢測多路測量信號。
  6. Intelligent multi - channel data - logging display controller adopt advanced microprocessor for smart control, it is suitable for display and control temperature, humidity, pressure, liquid level, instantaneous flow, speed and so on in many physical quantity inspect signal, and can data - logging multi - channel measure signal. it also can carry on high - accuracy linear correction to various non - linear input signals

    雙迴路數字光柱顯示控制儀採用先進的微處理器進行智能控制，適用於溫度濕度壓力液位瞬時流量速度等多種物理量檢測信號的顯示及控制，並能對各種非線性輸入信號進行高精度的線性校正。
  7. Some correlative designs and experiments are finished before the microwave test experiment. the property of a finite long magnetic coil is studied and the coil magnetic field circuit is constructed for the experiment of microwave. a digital two - channel trigger device is designed and successfully applied in the experiment

    為了微波實驗的順利進行，我們設計並加工了磁場線圈，研製了控制磁場線圈迴路觸發和強流電子束加速器觸發同步的兩路數字同步觸發器，研製了測量電子束流的法拉第筒，並成功地將這些設備應用於微波實驗研究。
  8. For the existing transformer cooling control system has many shortcomings such as the complicated system control circuit, the low reliability, the protection methods of blower fan being so simple, large control error, high fault rate, massive maintenance work and no method to realize telecommunication, this thesis develops a novel intelligent power transformer air - cooled control system based on the center of microprocessor through all - round technology analysis and research

    本文針對變壓器冷卻系統使用常規控制系統存在的系統控制迴路復雜、可靠性低、風機的保護方式簡單而無法進行故障預測、主變壓器油溫測量精度低造成控制誤差大、故障率高、維護工作量大、無法實現遠程通訊等問題，經過多方面的技術分析和調研，設計開發了新型的以微處理器為核心的智能式電力變壓器風冷卻器控制系統。
  9. Thermal power measurement of testing device in hfetr test loop

    試驗迴路中考驗裝置熱功率測量
  10. Being master control part, user controller stores, manages, display and query user information ; as slave control part, sub - user controller calculates and temporarily stores power sent from measuring module ; measuring module measures electric energy by using power meter ' s special circuit which simplifies circuit design and connects or breaks up power supply circuit by relay ; in order to transmitting data fast and exactly, rs - 485 communication standard is adopts between user controller and sub - user controller

    主控部分用戶控制模塊可存儲、管理、顯示和查詢用戶電能信息；從控部分子用戶控制模塊計算並暫存電能測量模塊輸出功率數據；電能計量模塊採用電度表專用厚膜電路hdb6進行電能計量，簡化了電路設計，同時還利用繼電器控制連接或斷開用戶的供電迴路；在主從部分間採用rs - 485通信標準實現數據快速、準確的傳輸。
  11. Intelligent programmable natural gas flow integrated controller adopt advanced microprocessor for smart control, mainly suitable use to flow measurement, integration and control for various natural gas, and with automatic compensation function

    除採用自整定功能，手自動無擾切換外，還具備超前的自適應功能，另外還有雙向pid調節功能及測量迴路斷線報警功能。
  12. In the previous methods of hardware detection, the communication between the detection devices and the board to be detested is performed mainly through serial interface, and the detection speed and precision ca n ' t meet the requirements. neither can they conduct the thoroughly automatic detection of analog circuit

    以前的硬體檢測方法主要通過串口來完成檢測裝置與待測板間的通信，檢測速度和準確度難以滿足要求，也無法實現模擬量迴路完全意義上的檢測。
  13. Then a combustion evolution optimizing system based on the radiant energy measuring was built, economical boiler combustion adjustment was carried out, under the combined action of a controller based on fuzzy self - optimizing of fume

    在此基礎上，建立了基於輻射能檢測的燃燒進化優化系統，通過煙氣含氧量與爐膛總輻射能的模糊自尋優控制器和風煤比進化優化器組成的燃燒優化迴路的共同作用，對鍋爐進行燃燒經濟性調節，達到燃燒優化控制的目的。
  14. Data inputting and graphinputting module respectively achieve data inputting of first system and electric firstwiring diagram inputting ; secondary scheme design module realizes scheme design ofsecondary loops including control, protection, signal, measure, automotive equipment, operation electrical source and electrical source for substation and power distributionstation, using rule - cased reasoning of expert system ; protective relaying settingcalculation module realizes setting calculation for first equipments which aretransformers, circuitries, capacitors, and electromotors ; secondary equipmentselection module realizes type selection of secondary microcomputer integratedequipments ; graph making out module realizes secondary drawings making outautomatically representing design production using case - cased reasoning of expertsystem and the drawings can be edited and modified under the secondary developedautocad environment

    數據輸入和圖形輸入模塊分別完成一次系統資料錄入和電氣主接線圖的輸入;二次方案設計模塊利用專家系統基於規則的推理實現變配電所各二次迴路的方案設計，包括控制、保護、信號、測量、自動裝置、操作電源和所用電源;繼電保護整定計算模塊實現主設備的整定計算，包括變壓器、線路、電容器和電動機;二次設備選型模塊實現二次微機成套裝置的型號選擇;圖形生成模塊利用專家系統基於實例的推理實現代表設計成果的各類二次圖紙的自動生成，生成的圖紙可以在二次開發的autocad環境下進行編輯和修改。
  15. According to the results of experiments, the stability of detection and the significance of photocurrent normalized are discussed. how the illumination mode, the frequency and the resistance of photocurrent loop affect the response of photocurrent is analyzed in detail. and the pilot study on the real - time detection of laps system has been done

    根據實驗結果分析討論了新系統的測量穩定性，以及光照射方式、光調制頻率和光電流迴路阻抗對光電流響應的影響，以及光電流歸一化處理的重要性，並且初步研究了laps系統的實用化實時檢測。
  16. A new full - wave measurement circuit structure is put forward that would increase distribution automation system reliability and veracity. the distributed protection and monitoring unit in this paper can instead of general instruments of low voltage distribution system. it not only combines ampere meter, voltage meter, active power meter, reactive power meter and power meter, frequency meter into a meter, but also increases monitoring position switch, control bus switching alternately and monitoring energy

    本文研製的保護和測控單元，可替代低壓配電系統中所使用的常規儀表，將原來迴路需要的電流表、電壓表、有功功率表、無功功率表和功率因數表、頻率表簡化為一塊表，並增加了位置開關量檢測，控制母線投切和電度監測功能，從而極大的簡化了低壓配電二次儀表設計、安裝調試，提高了運行、維護和管理水平。
  17. This method has three merits : first, reduce the harm to the battery ; second, this current is stable ; the last, the current may represent the battery ' s current function better. in order to study this problem, we design a install to make lots of experiments to prove this result. the install can use in the factory as a automation instrument if it be perfected

    此方法和原有方法比較有三大憂點：一是減少了直接短路時大電流放電對電池的損傷：二是此迴路電流值穩定存在，可以對其進行比較準確的測量：三是此電流值更能代表堿錳電池實際工作時的放電性能c為了本研究的順利實施，本課題提出了一個堿錳電池四參數檢測的實驗平臺，做到對電池的開路電壓、負載電壓、電流指標、電池重量四參數的檢測。
  18. 8 - loop flash alarm controller adopts advanced microprocessor for smart control, and can match use with our any control instrument or other contact control instrument. it can detect simultaneously 8 - loop signals. inputs and mainframe both adopt photoelectric isolation structure

    智能多路巡檢顯示控制儀採用先進的微處理器進行智能控制，適用於溫度濕度壓力液位瞬時流量速度等多種物理量檢測信號的顯示控制，可巡迴檢測多路測量信號。
  19. Single - loop flash and sound alarm controller adopts advanced microprocessor for smart control, and can match use with our any control instrument or other contact check control instrument. it can be conveniently fabricated into multi - loop alarm system. on the field normally open normally closed input mode are optinal for users

    超大屏幕單迴路數字顯示控制儀採用先進的微處理器進行智能控制，適用於溫度濕度壓力液位瞬時流量速度等多種物理量檢測信號的顯示及控制，並能對各種非線性輸入信號進行高精度的線性校正。
  20. This thesis is founded on the investigation of the ion migration of 500kv dc ceramic support insulators for the production of the 500kv dc ceramic support insulators. in the test system, we added the grounding switch for each circuit and the mutual switch, prescribed the four status of the current measuring program, making the measurement system more stabile

    在對離子遷移試驗研究的過程中，對原有離子遷移試驗測量系統進行了改進，通過為每路泄漏電流迴路設置接地開關及公共測量開關，並在軟體上為測量迴路設定4種狀態，提高了測量系統的穩定性。
分享友人
分享到 Line

分享到臉書