測量電流 的英文怎麼說

中文拼音 [cèliángdiànliú]
測量電流 英文
measuring current
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 測量 : measure; survey; gauge; meter; measurement; measuring; surveying; mensuration; metering; gauging;...
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. So it is used instead to calibrate more practical current-measuring instrument, called ammeters.

    因此，它只用於校準更實用的測量電流的儀表安培計。
  2. When measuring the magneto performance parameter ， we find that the instrument which use to measure voltage and current is still the simple voltmeter and amperemeter in the national standard ， and the form of wave that we observed is anomaly. based on the measure principles, it obviously ca n ' t be used to do quantitative analysis ； because the discharge process of ignition system is quite complex, accompanies with very strong electromagnetism interference, and the ignition current and voltage are variable ， it make the measure of ignition energy become a difficult thing of ignition system performance detection

    在磁電機常規測量時，發現在國家標準中用於測量電壓、電流的儀器仍然是普通的電壓、電流表，而觀測到的波形多為不規則的形狀，根據測量原理，顯然不能用其來做定量的分析；由於點火系統的放電過程比較復雜，伴隨著很強的電磁干擾，點火電流、點火電壓都是變量，使得點火能量的測量成為點火系統性能測試的一個難點。
  3. Depend on the comprehensive analysis and study of the structure, principle, and exterior characteristic of the motor, through the methods of system modeling and digital simulation analysis, two kind of control device that work for the low voltage ( lvdc ) and the high voltage ( hvdc ) in avigation are researched respectively. point to the control technique of close - loop speed stabilization at a limited adjustment speed range, we bring out the close - loop speed control method that using the rotor position sensor indirectly measure the speed of the motor

    在全面分析了稀土永磁無刷直流電動機的結構特點、工作原理、運行方式以及外部特性的基礎上，通過系統建模和數字模擬分析，分別針對航空低壓直流（ lvdc ）和高壓直流（ hvdc ）兩種電動機構用永磁無刷電動機，在小范圍轉速連續調節下的閉環穩速控制技術進行了詳細理論研究，提出了利用轉子位置傳感器信號間接測量電機轉速進行電機轉速閉環穩速控制的策略。
  4. Chaotic measured circuit of constant current and simulation analysis

    恆流式混沌測量電路及其模擬分析
  5. Current passing thermal resistance not over 5 milliampere

    通過熱電阻中的測量電流最大不超過5毫安。
  6. Design of an extremely weak photoelectric current measuring circuit

    極微弱光電流測量電路的設計
  7. It combained potentiostat, potentiostatic circuit instrument and ac impedance measurement organticace, which can measure usual dynamic potentio - scan, experiment of dynamic potentio - scan, but also unique measurement of ac impedance measurement, also, this new type electrochemical workstation can carry on complex experiment, sucn as potentio / current scan ac impedance measurement procedural measurment, life - span - circle ac impedance measurement procedural measurement in order to fullfill the goal of track and analysis of parameter in various electrochemical conditions. this graduation thesis indicate the structure, function of the multifunct - ional electrochemical workstation

    它把恆電位儀，恆電流儀和電化學交流阻抗分析儀有機地結合到一起，既可以做常規的基本測試如動電位掃描、動電流掃描試驗和電化學交流阻抗測量，也可以做基於這三種基本試驗的程式化試驗，如恆電流充電-電化學交流阻抗測量，電池壽命循環試驗-電化學交流阻抗測量試驗，從而完成多種狀態下電化學體系的參數跟蹤和分析。
  8. During the period of measurement, the transduction circuits transform the differential pressures, the absolute pressures and the temperatures received by the sensors into the voltage signals, and then, the voltage signals are transformed into digital signals by the a / d convertor. the mcu processes these digital signals and calculates the cumulation of the flow. finally the totalizers contact with the pc by rs - 485 bus to form a distributed measuring network

    在測量過程中，系統以流量計節流所獲得的差壓信號作為主信號、絕壓和溫度信號作為補償信號進行流量積算，這三種信號分別由相應傳感器感知后，經各自的物理信號測量電路轉換為電信號，再由a / d轉換模塊轉變為數字量，交微控制器進行處理、積算。
  9. Resistance welding - welding current measurement for resistance welding - current sensing coil

    電阻焊.電阻焊的焊接電流測量.電流感應線圈
  10. This paper describes mainly system functions, measuring methods, circuit design, software program and errors analysis of a new type of measuring instrument. this instrument can measure and monitor electric parameters in single - phase circuits, three - phase ( three - wire or four - wire ) circuits. this system can be applied to electric devices and power plants, transformer substations with harmonic pollution. it can measure current, voltage, power, energy, frequence, power factor etc. it also can detect load quality, phase sequence, alarm, display and print results, as well as detect and dispose negative power

    該儀器適用於含有諧波污染情況下的機電設備現場、發電廠、供電局、企業變電所現場，可用來測量電流、電壓、有功功率、無功功率、視在功率、有功電能、無功電能、視在電能以及頻率和功率因數等電參數，並具有負載性質（感性、容性）判別，正、逆相序判別指示功能；超限報警功能；列印記錄功能和負功檢測及處理功能。
  11. Use clamp ampere meter to measure the current and check if the heating power is normal

    用鉗形表測量電流，檢查發熱功率是否正常。
  12. How to measure the current in a low stray inductance dc bus design

    如何在母線電感很小的情況下測量電流？
  13. So it is used instead to calibrate more practical current - measuring instrument, called ammeters

    因此，它只用於校準更實用的測量電流的儀表? ?安培計。
  14. To test passive components, the tester places a test voltage across the component under test and measures the current

    在測試無源器件時，測試設備對被測試的器件施加一個測試電壓后，測量電流。
  15. The high density resisitivity method through electrode power supply, surveys electric current and voltage, gathers apparent resistivity data

    摘要高密度電法通過電極供電、測量電流和電壓，採集視電阻率數據。
  16. The singlechip design includes sensor circuits for testing electromotor ' s electrical current, voltage and rotate speed, and includes data collection board and data communication board, and includes rs - 232 and rs - 485 communicate mode

    其中單片機設計包括測量電流、電壓和轉速的傳感器電路、數據採集板和數據通信板設計以及rs - 232和rs - 485通信方式。
  17. As we all know, it can be used to measure not only magnetic field, but current, velocity, position, angle and rotate speed. as a key component, hall sensors are wide playing role in precisely measure, industrial control, automotive electronics, home electrical products and so on

    它不僅可以用來測量磁場，還可用於測量電流、速度、位置、角度和轉速等物理量，在精密測量、工業自動化控制、汽車電子、家用電器等領域獲得廣泛應用。
  18. Otherwise it decreases with the dielectric constant. since the direction of the particle chains is different from that of microwave transmission, which was considered to have different effect on microwave attenuation. two different erf containers for measuring the microwave transmittance were made

    考慮到微波傳播方向與電流變液顆粒鏈方向不同會造成微波衰減的不同，因此設計並製作了兩種用於測量電流變液微波透射率的電流變液樣品盒。
  19. In order to fulfill the protection more effectively in the short circuit failure, a new method based on the varying rate of the system current is developed. in order to get the virtual value of the system current, considering the characteristic of the rogowski coil output, a new integral method based on software is adopted and the traditional integrator is omitted

    為更好地實現短路電流的保護，本文針對rogowski線圈測量電流的特點，結合對短路電流變化規律的分析，提出了一種基於電流變化率判斷短路發生的新型判據，並通過模擬實驗對本文理論部分進行了初步的驗證。
  20. For the first time, the solenoid collecting magnetic field optical transducing principle is presented in this paper, and it is proved that the way to measure current by polarized light encircling conductor and that by polarized light threading solenoid axes are equivalent

    為了解決aoct的長期運行穩定性問題，首次提出了「螺線管聚磁光學傳感原理」 ，證明了偏振光圍繞著無限長通電導體測量電流與偏振光通過通電螺線管的軸向方向測量電流，在光學傳感測量電流的意義上是等價的。
分享友人
分享到 Line

分享到臉書