測鏈誤差 的英文怎麼說

中文拼音 [cèliànwùchā]
測鏈誤差 英文
chaining error
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 鏈 : Ⅰ名詞1. （鏈子） chain Ⅱ動詞（用鏈栓住） chain; enchain Ⅲ量詞（計量海洋上距離的長度單位） cable length
  • 誤 : Ⅰ名詞（錯誤） mistake; error Ⅱ動詞1 （弄錯） mistake; misunderstand 2 （耽誤） miss 3 （使受損害...
  • 差 : 差Ⅰ名詞1 （不相同; 不相合） difference; dissimilarity 2 （差錯） mistake 3 [數學] （差數） differ...
  • 誤差 : error
  1. In this dissertation, both single and complex driver - magnifier as a whole body is tested and studied by the tool of ansys for the deep analysis of kinemics, workspace, error analysis and compensation. and the method of helix - mechanism is induced to study the model accurately

    本文利用ansys工具對智能並聯微執行器驅動機構的柔性鉸鏈進行了分析與模擬，為並聯微操作機器人整體性能測試及分析，即微執行器的位置空間、運動學、誤差補償提供了基礎。
  2. According to the characteristics of dtc ( direct torque control ) in induction machine, this paper analyzed the estimation error of flux linkage and torque, and introduced an improved method of flux estimation, a compensation method based on low - pass filter

    摘要根據感應電機直接轉矩控制的特點，對低速下磁鏈觀測誤差產生的原因進行了分析，給出了一種磁鏈觀測的改進方法低通濾波器補償法。
  3. The supply chain mode is further extended to study the upstream demand mode, for which it is proved that the bullwhip effect is not always amplified under different forecasting technologies

    並對二級供應鏈進行拓展，證明在信息傳遞過程中，非最優預測將導致上游需求模式復雜化，牛鞭效應逐級遞增，而最優預測可使上游需求模式簡化，遏制誤差的傳遞。
  4. ( subject no. : 402050103 ) firstly, besides considering the net topology of data link and the components of communication delay, we propose a target state predictor based on markov acceleration model

    文中首先研究了空戰數據鏈的組網結構，對延時產生的原因及參數測量進行了分析。同時採用馬爾可夫加速度模型建立機動目標預測器，對通信延時造成的誤差進行補償。
  5. The study, analysis and calculation of accumulative error in chain measurement length are conducted and its rational value accepted commonly by enterprises is determined in this paper

    摘要對鏈條測試長度累積誤差值進行了研究、分析和計算，給出了合理的誤差值，可為生產企業普遍採用。
  6. According to the transfer - chain function and error " whitening model " or " quasi - whitening model " of the dynamic measuring system, the output errors are decomposed into the component ones of the inner parts and the outer noises. then the error tracing is realized. the selection of the decomposition method is also a key problem

    根據所建立的動態測量系統傳遞鏈函數與誤差「白化」或「準白化」模型，將測量總誤差分解為與動態測量系統內部各組成單元誤差以及外界干擾相對應的各項分誤差，即各單項誤差源，從而實現系統的誤差溯源。
  7. To the second model, it means we turn to the information - sharing mechanism from the linked information communication mechanism, so we can reduce the asymmety of the information and the mistake of the forecasting error

    第二類協調模式是通過改進運作制度，促使供應鏈成員的信息溝通機制由環環相扣轉向一定程度的信息共享，從而減少信息不對稱，降低預測誤差。
分享友人
分享到 Line

分享到臉書