湍流應力 的英文怎麼說

中文拼音 [liúyīnglì]
湍流應力 英文
eddy stress
  • 湍 : [書面語]Ⅰ形容詞（湍急） rapid; rushing; torrential; swiftⅡ名詞（急流的水） rapids; rushing waters
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 湍流 : 1 （急流） swift current; rushing waters; torrent; rapids 2 [物理學] turbulent flow; turbulence; ...
  1. A one - dimensional oceanic mixed layer model with the m - y level - 2. 5 turbulence closure schemes is employed. the rate of energy loss by breaking waves is estimated by parameterization and incorporated into the model as a source of turbulence kinetic energy ( tke ) by modifying the existing surface boundary condition of tke equation. the velocity field and turbulence energy budget are calculated under different forcing conditions ( the results given below are for a wind speed of 20 m / s. )

    採用一維2 . 5階湍封閉混合層模式，根據參數化方法對波浪破碎導致的能量耗散率進行了估計，通過改變湍動能方程的上邊界條件引入波浪破碎對湍動能生成的影響，計算了不同風應力強迫下的混合層流場結構和湍能量收支（下述給出的結果是取風速為20m s得到的） 。
  2. When the effect of surface wave breaking is considered, mld is 50 cm deeper than that obtained without wave breaking, and with the enhancement of wind stress forcing, the deepening of mld is increased

    模擬結果表明，當考慮波浪破碎的影響時，混合層深度比無波浪影響時的結果加深了約50cm ；隨著風應力作用的增加，波浪破碎加強了混合層中的湍流混合，促使加深幅度也增加。
  3. In the third chapter of this dissertation, based on the physical and chemical properties of hydrogen and the combustion characteristics of hydrogen, the quasi - dimension combustion calculation model of hydrogen ? fueled engine is set up through analyzing the characteristics of turbulence flame and chemical reaction kinetic of hydrogen ? air mixture. the model includes the dual ? area thermodynamics sub - model, quasi - dimensional turbulent entrainment combustion sub ? model, turbulence flame promulgating sub ? model, hydrogen - air mixture chemical kinetic sub - model and loss of heat transfer sub - model and so on

    本文從氫燃料的物化特性和燃燒特徵著手，通過分析氫空氣混合氣燃燒的湍流火焰結構和燃燒化學反應動力學，基於雙區燃燒模型，建立了包括雙區熱力學、準維湍流卷吸燃燒、湍流火焰傳播速度、氫空氣混合氣燃燒化學反應動力學以及傳熱損失等模塊的燃燒模型，並給出了相應的計算方法。
  4. On the basis of the existing turbulent model and its respective numerical simulation, this study offers emulation solutions to the study of pneumatic splicing, by selecting appropriate models and the software of computational fluid dynamics

    在研究現有流體力學中的湍流實驗模型以及其對應的數值模擬的基礎上，選用適當的模型和計算流體力學軟體對空氣捻接機理進行模擬。
  5. The three - dimensional primitive equations were derived for ocean in the condition of turbulence, by using the reynods time average method

    首先在流體動力學和熱動力學的基礎上，應用雷諾時均方程法，詳細推導得到海水在湍流狀態下的三維原始方程。
  6. Based on the vibration test in yantan hydropower house, in this paper the author adopt les method which belong to three dimensions unsteady turbulent flow numerical analysis to simulate vibration resource characteristics of hydrogenerator set, a harmonic vibration model of powerhouse substructure is put forward to carry out firstly a precise modal analysis and dynamic response analysis for generator floor. the numerical calculation results agree well with the surveyed data in situ

    本文結合巖灘水電站廠房振動的試驗研究，採用非定常湍流數值分析的大渦模擬方法進行混流機組水力振動振源模擬；提出一種水電站廠房下部結構簡諧振動模型，首次進行了發電機層樓板結構的精確模態分析和水力激振荷載下的動力響應分析，各項計算結果與實測數據吻合良好。
  7. A brief of description of the fluid machinery development, turbulence and computational fluid dynamics ( cfd ) in the engineering is introduced

    簡要介紹了流體機械設計方法、湍流和計算流體力學的發展狀況及在工程中的應用； 2
  8. The conclusion is that sheering and radial stress are dominant in viscosity shearing force, and that reynolds stress is larger than viscosity stress in turbulent flow, and the multiple is the reynolds number

    由分析可知在粘性應力中，切向和徑向剪切應力佔主導地位；而在湍流條件下，雷諾應力是粘性應力的若干倍數，此倍數在量級上即為雷諾數。
  9. The resolution of optical system can not reach its diffraction limit because of the phase aberrations caused by atmospheric turbulence and other wavefront errors. adaptive optics technology uses deformable mirrors to perform dynamic phase modulation and endow optical system the ability to decrease the influence of dynamic wavefront errors

    大氣湍流等動態干擾使光波面相位發生畸變，使光學系統的解析度無法達到其衍射極限，而自適應光學系統使用變形鏡對光波面進行動態相位調制，賦予了光學系統能動可變的能力而有效地解決了動態干擾的問題。
  10. Thirdly, geometry modeling of the pump was made and meshes were divided with gimbit, then the flow filed was investigated using flunt, a commercial available cfd code. as result, lots of internal flow filed of outlet of the gear pump was obtained, including velocity magnitude and pressure magnitude

    應用pro / e和gambit軟體對機油泵進行幾何建模並劃分網格，應用fluent軟體模擬多種工況下機油泵出口部分的三維湍流流動，得到詳盡的三維湍流場的分析結果，包括壓力分布圖、速度矢量分布圖等。
  11. Based on prandtl ' s momentum transportation, this paper calculates in detail the physical quantities such as eddy viscosities, and ratio of eddy viscosity to motion viscosity, total stresses with respect to relative position in three regions of viscous sub - layer, buffer layer, and main turbulent stream for non - newtonian fluid flowing turbulently in ducts, which according to karman ' s three layer models and measurement of fluid parameters in evaluation apparatus, discusses the influence of polymer drag reduction on flowing properties of non - newton fluid, analyzes quantitatively principle of turbulent reduction phenomenon and condition of increasing reduction rate

    摘要以普蘭德動量傳遞理論為基礎，按照卡門的三層模型，通過室內模擬環道用0號柴油及加入減阻劑在圓管內的流動參數的測定，計算了非牛頓型流體管內湍流邊界層的層流內層、過渡層、湍流中心的渦流粘度，渦流粘度與運動粘度比、總應力隨相對位置的變化等定量參數，探討了高分子減阻劑對非牛頓流體流動特性的影響，對湍流減阻現象的機理與增大減阻率的條件進行了定量分析。
  12. The influence of turbulence is seen as a new term in the equations. this term is the divergence of a second - order correlation tensor of the fluctuating parts of each velocity component

    湍流脈動的影響作為一個新的附加項?雷諾應力，出現在rans方程中，它是擾動速度分量二階關聯張量的散度。
  13. The numerical results show that the flow - field structures and main features of the compressible mixing layer including the distribution of mean velocity, turbulent fluctuation intensities, reynolds stress and growth rates agree well with experimental and other numerical results

    計算出的流場結構和主要的流動特徵包括平均速度、湍流脈動強度和雷諾應力的分佈以及混合層擴張率都同實驗測量和其他時間發展數值模擬結果符合得很好。
  14. Turbulence over flat wall is presented with the cfd software cfd ace ( u ) when given by various inlet boundary conditions, subgrid model and turbulence intensity under the two - dimensional circumstance. on comparing these outcomes with the experimental data, we can analyze the impacts that all these factors have on the development of flow boundary layer

    採用計算流體力學軟體cfdace （ u ） ，在二維情況下應用不同的進口邊界條件、亞格子模型和來流湍流度對平壁流動進行大渦模擬，並將模擬結果與已有的實驗結果進行對比，分析比較了這些因素對流動邊界層發展的影響。
  15. Application of homogeneous k - equation turbulent closure model in the coastal sea

    齊次湍流動能輸運方程封閉模型在淺海動力學中的應用
  16. Three - dimensional gas flow field in the new vortex quick separation system with an inner component of fcc disengager was simulated based on the reynolds stress model ( rsm ) provided by cfx

    摘要用cfx軟體對催化裂化沉降器新型旋流快分器的氣相流場進行了三維模擬，湍流模型採用雷諾應力輸運方程模型。
  17. A algebraic stress model based on the two - phase flovo pdf model considering particles collision

    考慮碰撞的兩相湍流概率密度函數代數應力模型
  18. Generate the grid of the channel nonclogging pump by the trade software named gambit and then calculate the internal flow of 3 - d incompressible in the channel nonclogging pump with the trade software named fluent

    應用流體力學商用cfd軟體fluent對無堵塞泵實施網格劃分以及對其葉輪內部三維不可壓湍流場進行數值模擬。
  19. If the two - equation turbulence models employ a linear relationship between the reynolds stress and the mean strain - rate tensors, this relationship is known as the generalized boussinesq model, the two - equation models can be extended for a wider range of applicability by developing more advanced nonlinear algebraic relations between the stress tensor and the mean - velocity gradient and the turbulent scales, this is known as explicit algebraic stress models ( easm )

    另一個是構成模型，即決定應力張量、應變率張量和兩個湍流尺度因子之間的函數關系式，它決定了雷諾應力。如果構成模型是線性的，則為boussinesq渦粘模型（ evm ） ，如果構成模型是非線性的代數關系式，則為顯式代數應力模型（ easm ） 。
  20. In this paper, maccormack explicit time - split scheme, baldwin - lomax algebraic turbulent model and two - steps hydrogen - air nonequilibrium chemical kinetics model are employed to simulate the 2 - d flow fields in a fixed geometry scramjet combustor in different injecting way of fuel in different flight conditions. the results show, in the same entrance condition, the operating mode of scramjet combustor is influenced by the control of fuel

    本文採用maccormack顯式時間分裂法、 b - l代數渦粘性湍流模型及氫-空氣兩步非平衡化學動力學反應模型，模擬了在不同的飛行馬赫數條件下，固定幾何的雙模態燃燒室在不同供油規律下的二維燃燒流場。
分享友人
分享到 Line

分享到臉書