溫差檢測器 的英文怎麼說

中文拼音 [wēnchājiǎncèqì]
溫差檢測器 英文
thermodetector
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 差 : 差Ⅰ名詞1 （不相同; 不相合） difference; dissimilarity 2 （差錯） mistake 3 [數學] （差數） differ...
  • 檢 : Ⅰ動詞1 （查） check up; inspect; examine 2 （約束; 檢點） restrain oneself; be careful in one s c...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 溫差 : [物理學] difference in temperature; range of temperature
  • 檢測器 : detector
  • 檢測 : check; detection; test; gauging; detecting; sensing; [工業] checkout; measuring
  1. The main computer is programmed under windows, while the assistant computer is programmed under dos. the last, based on the idea of module - structure, the software of the testing system are designed, thus this software system is compatible and transplantable to design again. the experiment of measuring principle is taken : take the xy flat of lathe as the parallel - pole device and adjust the angle of sensor, the rotating - probe can test the felloe mould in scanning way

    藉助虛擬儀器的思想，對測控系統進行了設計：採用光柵尺、光電編碼器測量可動部件的運動量，解析度高、誤差小；採用細分驅動的步進電機裝置，控制性能好；系統實施環境溫度的檢測、補償，提高了檢測精度；基於兩級微機組建測控系統：主機為人機界面，採用windows編程，從機用dos編程，實時性好；軟體設計採用兼容性和移植性好的模塊式結構，便於二次開發。
  2. Together with undertaking the power cords designing and researching, it usually takes 15 days to do the development for the new products. the project department has advanced testing equipments mainly including bending testing machine, inserting drawing machine, temperature testing machine, standing pulling machine, internet inspecting machine, chromatic testing machine, static testing machine, salt - spraying machine, burning testing machine, non - toxic inspecting machine

    該部門擁有的試驗檢測儀器包括：搖擺測試機2臺插拔力試驗機1臺高低溫試驗箱1臺立式拉力儀2臺網路測試儀1臺色差儀1臺靜電測試儀1臺鹽霧試驗機1臺燃燒試驗儀1臺低毒檢測儀1臺。
  3. Based on analyzing causes of formation of system error, random error and gross error, together with their influences to observation values, method that examine whether there is system error in apparatus by using temperature values of unbonded elastic wire resistance type meters is studied

    在對系統誤差、隨機誤差、過失誤差成因及對監測數據的影響分析基礎上，研究了利用差動電阻式儀器的伴測溫度測值來檢驗儀器是否存在系統誤差的方法。
  4. A resolution method in software is applied to calibrate zero point and full scale of the circuit. software approach to nonlinear correction for sensor and circuit is presented. therefore system error is eliminated, and measurement accuracy of temperature is improved. the signal of acidity electrode is detected by a differential amplifier circuit, which consists of operational amplifiers tlc2254 with high input impedance and low drift

    採用橋路和單運放差動放大電路對溫度傳感器信號檢測放大，軟體校正溫度傳感器和測量電路的非線性，軟體校準測量電路的零點和滿度，消除測量電路的系統誤差，提高補償溫度的測量精度；採用高阻、低漂移運放tlc2254組成高阻差動放大電路用於酸度電極信號測量。
  5. Due to the dual - fbgs differential measurement structure, the problem of temperature - strain cross - sensitivity on the pressure sensor is improved ; and furthermore, the sensitivity of the sensor is increased theoretically

    該結構的壓力傳感器採用雙光柵差動結構，在提高檢測靈敏度的同時，實現了溫度的自補償。
  6. Abstract : the principle of electro - differential - constant temperature detector ( edctd ) is summarized. a calculation method for selecting resistance value in the measurement circuit based on the sensitivity requirement is proposed. theoretical analysis and experimental result for the method are also given. the proposed method can be applied to production and calibration of edctd, providing guideline in determining the resistance parameters

    文摘:介紹了電子差定溫式火災探測器的工作原理，提出了根據不同靈敏度要求選取電路中各電阻阻值的方法，並從理論和實驗兩方面加以分析和論證，消除了電阻參數選擇的盲目性，為生產、檢測差定溫式探測器提供了理論依據。
  7. Because mz interferometric optical fiber gyroscope has bigger nonreciprocal phase, the system thermal stability, polarization noise and the error caused by the fluctuation of light source is particular analysed, some effective methods is proposed such as : using the " quasi - white - light " interferometry and the fiber polish technology accurately to control the fiber length, using depolarization light to minish the polarization error, and using temperature control, optical power control and depolarizer to stabilize the output of the light source

    結合mz干涉式光纖陀螺的存在較大非互易相移的特點，著重從其溫度穩定性、偏振噪聲以及光源波動引起的誤差三個方面分析了抑制噪聲、提高檢測精度的方法，提出了：採用「準白光」干涉測量法結合光纖研磨技術精確控制光纖長度差的辦法；採用非偏振光源抑制偏振噪聲的方法；採用溫度控制、功率控制以及消偏器實現穩定化陀螺光源的方法。
  8. This instrument is suitable for measuring compaction rate, green compression strength, temperature difference between room temperature and sand temperature ; controlling automatically and making sand keep good integrated capacity when mixing green sand

    本儀器主要用於混制濕型砂時，在線自動檢測型砂的緊實率，濕壓強度，室溫-砂溫差等性能，並自動控制，使型砂保持良好的綜合性能。
  9. By use plc, system can complete function as follow : this auto - control system be applicable to the temperature and smoke and dust the deal the variety quick, control the process is difficult with the operation is ; by the temperature controlor can automatically follow to the wet tower " exit temperature, error in the ? 3 v including ; by to automatically spray fog to lower the electric resistance, with the function for full the electricity equipment accepting the dust ; because of adopting feedback closed loop, and come to a to respond to the speed quick, constant temprature control the accuracy is high ; because of adopting the sensors, and make the system circumstance to leak water quick ; system have many control parameter can set exit control temperature and adjust value low limit by key ; can communication with remote computer and have remote control

    通過使用plc ，使該自控系統可以完成如下功能：適用於溫度及煙塵量變化快、控制過程難以操作的場合；通過溫控表自動跟蹤增濕塔出口溫度，誤差達到3以內；通過自動噴霧來降低粉塵比電阻，以此充分發揮電收塵器的作用；由於採取了閉環反饋迴路，達到了響應速度快，恆溫控制精度高；通過使用各種檢測傳感器，使得異常情況泄水快；該自控系統具有多套控制參數，增濕塔出口控制溫度及調節閥下限值可通過按鍵設定；可與上位機通訊，具有「現控遠控」功能。
  10. A statistic method combining principal component analysis ( pca ) with joint angle plot was proposed to online detect and diagnose fixed or drift bias of temperature and flow rate sensors of air handling unit ( ahu )

    摘要針對空調箱的溫度、流量等傳感器進行固定偏差和漂移故障的檢測與診斷，提出了一種基於統計學的方法進行在線的故障檢測和診斷。
  11. ( 2 ) hardware design of difference frequency capacitance measurement circuit, including the structure of sensor, analysis on several relative measurement circuits, periphery circus design. debugs and practically measures it

    （ 2 ）進行了差頻式電容測量電路的硬體設計，主要包括：傳感器結構設計，各種微小電容檢測電路的對比分析，差頻式檢測電路設計，溫度檢測電路設計以及存儲電路設計。
分享友人
分享到 Line

分享到臉書