溫度下限 的英文怎麼說

中文拼音 [wēndùxiàxiàn]
溫度下限 英文
lower temperature limit
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 下 : 下動詞1. （用在動詞后,表示由高處到低處） 2. （用在動詞后, 表示有空間, 能容納） 3. （用在動詞后, 表示動作的完成或結果）
  • 限 : Ⅰ名詞（指定的范圍; 限度） limit; bounds Ⅱ動詞（指定范圍, 不許超過） set a limit; limit; restrict
  • 溫度 : [物理學] temperature
  1. At a definite temperature a mesoscopic circuit isnt in a determinate quantum state instead of in the mixed state ( or statistical state ). using the density matrix of the canonical ensemble, we have deduced the formulate of the quantum fluctuations of both charge and current in a non - dissipative mesoscopic coupled circuit. and the dependences of the quantum fluctuation of the circuit on its temperature have obtained

    在有限溫度下，介觀電路系統實際上並不處在一個確定的量子狀態，而是處在混合態.根據正則系綜的密度矩陣導出耦合互感電路中電荷和電流的量子漲落，得到了量子漲落與溫度的依賴關系
  2. Using the lagrangian at a finite temperature of the scalar field which can generate global cosmic string in the spontaneous breakdown, solved the gravitational field equation outside the core of a global cosmic string at the background of temperature, corrected the result in the theory at zero temperature. on the basis of this, the properties of the gravitational field outside the core of a global cosmic string are discussed

    考慮溫度效應，運用改寫的能自發破缺產生整體宇宙弦的標量場在有限溫度下的拉氏密度，求解了整體宇宙弦核外的引力場方程，對零溫理論中的結果作了修正，進而討論弦核外引力場的性質
  3. The lower limit of temperature at which this occurs is known as the softening point or critical temperature.

    呈現這一性質的溫度下限稱為軟化點或臨界溫度。
  4. How to set the upper limit and lower limit temperature

    怎樣設置溫度上限下限和化霜周期？
  5. This thesis used aerodynamics equation and mechanics of materials knowledge analyzed the high pressure caused by overloading in terms of theory. by compared the increment of pressure in a not full container with the full one and combined with the igc - code, this thesis put forward a method of calculating safe loading capacity under different temperature

    本文應用了氣體力學方程和材料力學理論知識，對充裝過量導致過高的液貨艙壓力進行了理論分析，對比保留有氣枕時的液貨艙的壓力增量和充裝過量時造成滿液的壓力增量，並結合igc規則對充裝極限的規定，提出了不同溫度下的安全貨液充裝量的計算方法。
  6. Abstract : the model parameters for uniquac and nrtl equations are obtained by using the infinite dilute activity coefficients of a component at several temperature and the nonlinear regressive technique. the vaporliquid equilibrium ( vle ) data calculated by using the parameters for uniquac or nrtl equation is agreement with that from vle experiment

    文摘:通過一個組分在不同溫度下的無限稀釋活度系數，利用非線性回歸確定了四氫呋喃1 ， 4丁二醇、水1 ， 4丁二醇二元體系的uniquac 、 nrtl溶液模型參數.用所獲得的兩溶液模型參數對三元氣液平衡數據進行理論推算，並與實測的三元氣液平衡數據進行比較，發現兩結果比較吻合
  7. In the framework of thermofied dynamics it is shown that, at finite temperature the final state in the bremsstrahlung process is just the eigenstate of the annihilation thermal - field operator which indicates that it is a coherent state

    運用熱場動力學的相關知識，我們發現有限溫度下的韌致輻射的末態恰好是熱場湮滅算符的本徵態，從而說明熱qed下的韌致輻射是一個相干態。
  8. Abstract : during the heating of scrap with carbon or hydrocarbon contented substances in some process, it will bring problems like explosion of carbon monoxide, fume and smell from oil volatilization, etc. ， if incomplete combustion occurs. through laboratory experiments, the time related variation of gas contents and post combustion ratio of fume during the heating of oil - bearing scrap are studied. the results show that the restrictive chain of reaction procedure is the thermolysis of oil ; that temperature and ( co ) / ( co2 ) ratio influence transformation ratio and post - combustion ratio under lower temperature ; that 900 is the temperature above which the complete reaction can be ensured at all ( co ) / ( co2 ) ratios

    文摘:在某些廢鋼熔煉過程中，當爐料中含碳及碳氫物質且燃燒不充分時，會帶來煙氣中一氧化碳的燃爆、油污揮發時造成的煙霧、臭味等問題.通過實驗室裝置研究含油廢鋼在加熱過程中煙氣成分隨時間的改變以及二次燃燒率的變化，試驗結果表明，反應過程的限制性環節是油分的熱分解；在較低的溫度下（ co ） / （ co2 ）比例影響轉化率和二次燃燒率；而在任意比例下保證充分反應的溫度為900以上
  9. Based the humidity theory, the paper adopts the relative humidity as the character value and puts forward using 30 % rh and below 0c dew - point as the on - line monitoring critical value. it gives the method of volume ratio convert at the different temperature. with the standard value, we can conclude the result of moisture content

    針對現有規程標準中控制水分的指標的缺點和局限，提出了採用相對濕度作為監測特徵量並轉換為露點以直觀表示設備絕緣狀況：採用30相對濕度及0以下露點作為監測的臨界值與允許值；同時推導出了體積比單位在不同溫度下的折算方法，以結合現有標準，綜合分析，做出判斷結論。
  10. Comparison of the calculated elastic moduli with the experiment ones for fcc al and bcc li and na it shows they are in perfect agreement with each other

    當晶體從絕對零度升高到某一有限溫度下時，晶體發生體積膨脹，計算出發生體積膨脹后的新體積。
  11. It begins to refrigerate when the temperature in the milk jar is higher than the temperature upper limit, and stops refrigerating when the temperature is below temperature lower limit

    ：當奶罐內溫度高於「溫度上限」時，開始製冷，一直到溫度降到低於「溫度下限」時停止製冷。
  12. Integrated circuits require less power and lower voltages than the equivalent macroscopic circuits, consequently they operate at lower temperatures, and individual components may be closed together without exceeding the operating temperature limit

    參考譯文：集成電路比等效的分離元件電路功率小，工作電壓低，因而可以在較低的溫度下工作，電路中包含的單個元件可以緊靠在一起而不超過工作溫度極限。
  13. And then, we specially study the effect of spin interaction ' s anisotropy on the critical temperature tc. from what we have observed we suggest that the critical temperatur tc grows as the anisotropy intensifies, while the system magnetization becomes weaker. the system becomes id if the anisotropy ratio r goes to infinity, and its equilibrium state keeps zero magnetization at any finite temperature, which confirm that there is no observable transition for id system

    其後，著重研究了自旋相互作用的各向異性程度r對其臨界溫度t _ c的影響，總結出：隨著系統各向異性程度的增強，系統的臨界溫度向高溫轉移，而系統的磁化強度在不斷的減弱；當r趨近於無窮大時，系統演變為一維系統，系統在任何有限溫度下達到的平衡態始終保持磁化強度為零，這也證實了一維系統不發生相變
  14. At the beginning of this article, we give the analysis about the principle of external condensation. we find out that the most important factor in the condensation is the temperature of the air in the system. and we point out the factors which can make influence in the external condensation, such as the temperature and the humidity of the environment, the temperature and the pressure of the supplying air, the load of the system, the area of passage of speed control valve, and so on. next, we give the mathematics model of the pneumatic system using the knowledge of aerodynamics and heat transfer theory. and using the finite difference method and the numerical analysis we can get the solutions of the model. we use c program to simulate the model

    本文首先對氣動系統外部結露的原理進行了分析，指出了氣動系統內部氣體溫度下降是氣動系統外部結露根本原因，提出了影響氣動外部結露的主要因素，包括環境溫度、環境濕度、供氣壓力、供氣溫度、氣缸負載和調速閥開度等。然後應用氣體動力學、氣體熱力學和傳熱學對氣動系統建立數學模型，用逆步進有限差分法和數值分析演算法對所建模型進行求解，利用c語言編製程序對氣動系統模型進行模擬，給出了氣管及氣缸內氣體的各個時刻的狀態參數。
  15. Besides, it was found that compared with cta +, the confined geometry improves the thermal stabilization of methylene chains about 20 in the case of the gallery height less than 9. 1 a and surfactant content less than 24. 7 wt %, while the onset temperature of degradation reduces about 25 at high gallery heights and surfactant loadings

    較小的受限空間可提高烷基鏈降解溫度20 。隨著層間高度和插層物含量增大，起始降解溫度下降25 。有機蒙脫土的熱失重微分曲線呈多峰，與層間烷基鏈密度分佈呈多層堆積有關。
  16. Ltd. a coupled vibration method on suspended free poles is employed to determine the initial young ' s modulus at elevated temperatures, also the thermal expansion coefficients of fire - resistant steel

    通過高溫下的恆溫加載拉伸試驗，得到不同溫度下耐火鋼的屈服強度、極限強度、延伸率、面縮率和應力應變關系，並測定高溫下耐火鋼的熱膨脹系數，採用懸絲耦合共振法測定高溫下耐火鋼的初始彈性模量。
  17. How to set upper limit lower limit and defrosting cycle

    怎樣設置溫度上限下限和化霜周期？
  18. Set temperature lower limit

    溫度下限設置下限溫度
  19. Tco changes its state of conductivity to open circuit with loading detection current only at this temperature

    在此溫度下，限時斷路器（ tco ）才用負荷檢波電流將導電狀態改為開路狀態。
  20. A tco changes its state of conductivity to open circuit with loading detection current only at this temperature

    在此溫度下，限時斷路器（ tco ）才用負荷檢波電流將導電狀態改為開路狀態。
分享友人
分享到 Line

分享到臉書