溫度修正系數 的英文怎麼說

中文拼音 [wēnxiūzhēngshǔ]
溫度修正系數 英文
true density temperature correction coefficient
  • : Ⅰ形容詞(不冷不熱) warm; lukewarm; hot; gentle; mild Ⅱ名詞1 (溫度) temperature 2 (瘟) acute ...
  • : 度動詞[書面語] (推測; 估計) surmise; estimate
  • : Ⅰ動詞1 (修飾) embellish; decorate 2 (修理; 整治) repair; mend; overhaul 3 (寫; 編寫) write;...
  • : 正名詞(正月) the first month of the lunar year; the first moon
  • : 系動詞(打結; 扣) tie; fasten; do up; button up
  • : 數副詞(屢次) frequently; repeatedly
  • 溫度 : [物理學] temperature
  • 系數 : [數學] coefficient; ratio; modulus; quotient; factor
  1. Avoiding the difficulties of detecting the difficult parameters in furnace control and of building up the models, integrated with fuzzy control and conventional pid control, abb ’ s control it system is used to predict the bloom surface and center temperature directly based on the temperature of furnace wall easily to be detected so that the temperature settings in various furnace sections can be self - corrected, the furnace temperature of each section self - adjusted and on - line parameters of combustion control self - optimized. in addition, the heating parameters and the operating status of the field plant can be monitored with alarm

    採用abb公司的controlit控制統,避開爐子控制中遇到的困難參檢測及建模困難等因素,直接根據容易檢測的爐壁來推知鋼坯表面及鋼坯中心,將模糊控制技術與常規pid控制相結合,實現各段爐設定值自、各段爐自協調、各參在線自整定的自尋優最佳燃燒控制;對熱工參、現場設備的運行情況進行監視、報警,實現爐膛壓力、管道壓力、換熱器的保護控制,並將重要參送往廠級mis網路。
  2. When the environment temperature is not 24, under non certain lubricating status, the pva is the basic value, it is corrected by temperature correction coefficient and running time correction coefficient

    在非24和非連續運轉狀態下,要以pva值為基本值,用和運轉時間校來加以
  3. Abstract : the in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    文摘:針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況,提出了若干技術改造措施包括,增大對流管表面積以增大對流段的熱負荷;增加輻射管的換熱面積;煙囪高;換用新型燃燒器,變自然通風為強制供風,以增大燃燒器的發熱量,減小過剩空氣,節省燃料2 % 3 % ;在對流段和煙囪之間增設空氣預熱器以提高空氣入爐;採用高輻射塗料增強輻射換熱效果,從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  4. The in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況,提出了若干技術改造措施包括,增大對流管表面積以增大對流段的熱負荷;增加輻射管的換熱面積;煙囪高;換用新型燃燒器,變自然通風為強制供風,以增大燃燒器的發熱量,減小過剩空氣,節省燃料2 % 3 % ;在對流段和煙囪之間增設空氣預熱器以提高空氣入爐;採用高輻射塗料增強輻射換熱效果,從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  5. According to the raman selection rule and the pl measurement, it is reasonable to evaluate the quality of galnp / algalnp mqw by analyzing the relative intensity ratio of a1p - lo / to. ( 4 ) a new modified random element isodisplacement ( mrei ) model is set up to calculate the dependence between the long - wavelength optical phonon frequencies and the composition of iii - v - type ab1 - xcx mixed crystals. the second neighbor force constants are still assumed to be a linear variation with the composition, but the two first neighbor force constants can be evaluated to be a negative exponent variation with the composition, using the overlapped repulsive potential of the ion crystal combination

    通過實驗我們找到了在這些結構參上生產gainp algainpmqw的較理想的結果; ( 3 )首次用喇曼( raman )散射方法研究了常下的gainp algainp多量子阱結構,除了指認出喇曼光譜中各光學聲子模外,還結合樣品光致發光譜的測量結果,分析發現喇曼光譜中alp - lo to的相對強比可以在一定程上評定晶體gainp algainpmqw的生長質量; ( 4 )在的隨機元素等位移? mrei模型的基礎上建立了一個新模型,計算了ab _ ( 1 - x ) c _ x型?族半導體混晶的長波長光學聲子模頻率的組分變化關
  6. Via starting and stopping air compressor, it can make the ice of evaporator melt. this controlling system can display the temperature of railway carriage, control temperature with multi - grade setting and modify controlling parameters on line. the algorithm of fuzzy controller is revising factor ( a ) consulted on line fuzzy control with integral link

    模糊控制演算法採用帶有積分環節的因子在線插值的模糊控制,控制統的輸入為車廂與設定值的偏差和偏差的變化率,輸出為與門開口角相關的占空比可調的脈沖的占空比參,均採用態模糊模型。
  7. Multi - span plastic greenhouse structure design theory has been studied systemic which include design loads, design methods and system optimization designs aimed at the situations above - mentioned, meanwhile, theory analysis and designs have been completed for series east - china multi - span plastic greenhouses in accordance with the local climate characteristic. some elementary conclusions are summed up : ( 1 ) in the aspect of multi - span plastic greenhouse structural design loads researches, based on the contrast analysis of loads provided in foreign and chinese standards, analysis and discussion are mentioned about the definition loads, the estimation and load cases for multi - span plastic greenhouse structural design in details, some conclusions are summed up first : i, wind load : under the present conditions, it is unnecessary to

    得到一些初步的結論: ( 1 )在連棟塑料室結構設計荷載研究方面,從分析比較國外關于室建築及我國工業與民用建築設計荷載規范的角出發,針對連棟塑料室結構設計中的荷載定義方法、計算取值、荷載組合等進行了較深入的探討和分析,首次得到以下結論: 、風荷載:在現有條件下,考慮風壓高變化、陣風作用因子和風荷載體型,按中國建築結構荷載規范( cbj9 ? 87 )計算風荷載是可以的,不必進行重現期博士學位論文摘要
  8. By pointing out that ambient pressure should take the place of scavenging air temperature in the formula of nox correction factor khdies, a new and more reasonable khdies has been brought forward

    提出掃氣空氣不應出現在no _ x環境狀況公式牛,而應將大氣壓力包括在其中。並通過計算得出了新的公式。
  9. True density - temperature correction coefficient

    溫度修正系數
  10. Volume - temperature correction coefficient

    容積溫度修正系數
  11. Temperature correction coefficient, c

    溫度修正系數, c
  12. ( 2 ) xrd analysis showed that phenolic resin molecules could insert into the interlayer of organic - montmorillonite, but there are some differences of the behavior of intercalation between thermosetting phenolic resin and thermoplastic phenolic resin. ( 3 ) the cure kinetics parameters of epoxy resin / org - mmt / deta, epoxy resin / org - mmt / toa and epoxy resin / org - mmt / mz nanocomposites were investigated by differential scanning calorimetry ( dsc ). some kinetics parameters including the reaction order and activation energy were caculated with kissinger method

    ( 3 ) dsc研究了環氧樹脂二乙烯三胺蒙脫土、環氧樹脂桐油酸酐蒙脫土、環氧樹脂咪唑蒙脫土固化體在不同org - mmt配比( 0 , 5 , 10 )及不同下的固化動力學,除了運用常見的kissinger和crane方法求出活化能和反應級等動力學參外,還嘗試了用的avrami方程和自催化動力學模型研究了環氧樹脂蒙脫土體的固化動力學。
  13. Based on the thomas - fermi approximation, the finite number effect, along with dimensionality, has been discussed for a bose system and fermi system trapped in 3d, 2d, 1d anisotropic harmonic oscillator potential, without considering the inter - atom interaction. we indeed found the remarkable differences between the finite number case and the thermodynamical case, including dimensionality

    基於thomas - fermi近似,在不考慮原子間相互作用的前提下,我們分別對處於三維、二維、一維諧振子勢場中的bose體和fermi體的熱力學性質作了詳細的討論,並得到了有限粒子效應下熱力學量和臨界
  14. A new temperature - controlled algorithm has been developed, where fuzzy control was a core. some characteristics of the temperature - controlled device and the electric system were considered in the virtual instrument algorithm. measurement precision of pt100 was improved to integrate with pt100 ' s characteristic

    在整體方案的指導下,在認真分析控箱和電氣統特點的基礎上,提出了一種適合自身特點的、以自適應模糊控制為核心的控制演算法;對鉑電阻傳感器的非線性進行了,提高了測的精;充分發揮pc機的優勢,建立了據管理統。
  15. This study, from the research of the basic mass and heat transference phenomena of the oil / water two - phase flow in the borehole and formation - borehole systems in production oil well as well as their potential mechanisms, extracts a new method of oil / water two - phase profiles interpretation based on temperature and flowmeter logs after carefully mathematical analysis and process

    本文通過研究生產井中油水兩相在井筒及井筒?地層統的傳熱、傳質的基本物理現象和本質,經過一定的學分析和處理,在原有基本方法的基礎上,提出了一種的基於流量、信息定量解釋油水兩相產出剖面的方法。
分享友人