溶液摻合 的英文怎麼說

中文拼音 [róngyèchāngě]
溶液摻合 英文
solution blending
  • 溶 : 動詞（溶化; 溶解） dissolve
  • 液 : 名詞（液體） liquid; fluid; juice
  • 摻 : 摻動詞[書面語] （持; 握） hold
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 溶液 : solution; liquor; scald; aqua
  1. ( 2 ) in ( no3 ) 3 was dissolved in acetylacetone in the mol ratio of l : 3. they were mixed for about 3 hours to obtain acetylacetone salts. then glycol methyl aether was added in the ratio of 1 : 40 to obtain indium oxide sol. sncl4 was dissolved in glycol methyl aether and then added into the indium oxide sol to prepare transparent and stable ito sol

    （ 2 ）通過將銦的無機鹽硝酸銦與乙酰丙酮按摩爾比1 ： 3 ，混合攪拌3h左右得到銦的乙酰丙酮鹽，然後按一定摩爾比加入乙二醇獨甲醚溶液，混合攪拌制得氧化銦溶膠，再將一定量的sncl _ 4溶入乙二醇獨甲醚，摻入氧化銦溶膠制得透明穩定的摻錫氧化銦溶膠（ ito溶膠） ，該溶膠性能穩定，易於成膜。
  2. Under the different freezing - thawing cycle circumstance, three factors of water binder ratio, air content and mineral admixture are analyzed by using the method of orthogonal table. the test results show that the chief influencing factor is the water binder ratio in water freezing - thawing cycle circumstance, and in salt freezing - thawing cycle circumstance is the air content. this could illustrate that entraining air into concrete can improve the frost resistance of concrete effectively in salt freezing - thawing cycle

    分析了在純水和3 . 5 % nacl溶液中受凍后，水膠比、含氣量和摻合料對混凝土飽和系數及變化速率的影響規律，試驗結果表明水膠比對混凝土水凍時的飽和系數及變化速率影響顯著，而鹽凍情況下含氣量則是主要影響因素，說明引氣能顯著提高混凝土的抗鹽凍性能。
  3. On the other hand, through inhibted performances of concrete and mortar, the permeability refutations with different w / c, ages, admixture, and physics chemistry absorb regulation of different viscosity permeable liquid, the liquid - gas method is proved science and accuracy. because adopting with liquid - gas method it case clearer concrete permeability regulation. different concretes relativity is more exact and more efficiency and fixed quantity

    另一方面，我們利用混凝土所固有的性質：不同水灰比混凝土、砂漿、抗滲性能規律；不同齡期混凝土的抗滲規律；不同外加劑、摻合料抗滲性能之間相互對比規律；不同黏度滲透液物理化學吸附對測試結果影響的規律；用規律來映證溶液氣壓法的科學性，準確性。
  4. With the very low water to cement ratio, rpc has ultra - high strength high ductility and low permeability. in this paper, the compressive strength of rpc can reach to a high point with the number approximately 135mpa. as illustrated from the study results, we can approve some fundamental conclusions : there are big effects on rpc with deferent kinds and properties of raw materials and deferent curing conditions ; stress - strain curve shows the process of destroy with rpc samples ; x - ray diffraction analysis indicates that heat treatment at temperatures 90 accelerate the hydration of rpc sharply, therefore, mechanical and microstructural properties of rpc are highly dependent on heat treatment ; it is believed that rpc materials have excellent resistance to chloride permeability ; during the heat treatment, the shrinkage of rpc developed quickly because of chemical reactions ; the rpc with slag mostly has the advantage of rpc without slag about resistance to solutions corrosion

    研究結果表明：通過對rpc各組分摻量變化的研究，可以找到rpc的最優配合比；試件成型后的熱養護制度對rpc的性能影響巨大； rpc的抗壓應力?應變曲線可以反映出試件受破壞時微裂紋的擴展情況，剛纖維的摻入可以大幅改善rpc的韌性； rpc在成型后存在較大的收縮，而其中的化學收縮要遠遠大於乾燥收縮； rpc具有很強的抗氯離子滲透性能，漿體的密實度很高；通過x射線衍射實驗，可以發現rpc的膠凝體中ch晶體已經幾乎不存在，膠凝體主要由c - s - h凝膠和未水化水泥顆粒組成；在抗溶液侵蝕的實驗中，摻礦渣rpc的抗溶液侵蝕性能在絕大多數情況下要好於不摻礦渣試件，酸、堿溶液和浙江工業大學碩士學位論文摘要一些鹽溶液都會對rpc的結構產生侵蝕作用，但是機理各有不同。
  5. As the isotropic etching being related to the resistivity of the si material and combining the practical need of the solar cell production, the paper emphasis on the etching of the multicrystal si with resistivity of about 1. cm. the results : ( 1 ) reflectance characteristics the appropriate etching solutions has led to a reduction of the total integrated reflectance to 5. 7 %, which is quite comparable with conventionally pretextured si surface covered by a double layer arc

    由於以hf + hno _ 3 + h _ 2o為溶液各向同性腐蝕與矽片的摻雜濃度有關，結合生產太陽電池的實際需要，本文重點研究了電阻率1 . cm左右的多晶硅的腐蝕情況，結果如下： （ 1 ）反射特性在適當的hf + hno _ 3 + h _ 2o溶液中制備的多晶硅電池的絨面，其反射率降到了5 . 7 。
  6. The results displayed that the spectra were wider than that of one single dye and there were energy transfer between c102 and rh6g. in silica films the energy transfer efficiency was higher than that in ethanol solutions

    C102 ： r上6gh元混合染料間存在著能量傳遞，將其摻雜到isio 。凝膠中，發現與無水乙醇溶液中相比；能量轉移效率增加，光譜i展寬，原因可能是出。
  7. There are two main factors resulting in fading capacity and poor cyclability, one is the john - teller distortion of mn3 +, and the other is mn dissolution to electrolyte. the main objects of this paper are to resolved these key problems effecting on the performance of batteries. during the research of suppressing jahn - teller distortion, low valence cation ( al 、 mg ) and anion ( f ) doped method are usually adopted

    針對limn2o4正極材料在電化學循環過程中發生jahn - teller畸變和mn在電解液中溶解這兩個導致容量衰減和循環性能劣化的關鍵問題，分別採用al 、 mg陽離子摻雜和al / f 、 mg / f陰陽離子復合摻雜兩種措施，對尖晶石結構limn2o4正極材料進行了改性研究。
  8. The significant capacity loss of the spinel limn2o4 during cycling hereby prevents its wider use as cathode materials for lithium secondary batteries. there are two main factors resulting in fading capacity and poor cyclability, one is the jahn - teller distortion of mn3 +, and the other is mn dissolution to electrolyte. the main objects of this paper are to resolved these key problems effecting on the performance of batteries

    針對limn _ 2o _ 4正極材料在電化學循環過程中發生jahn - teller畸變和mn在電解液中溶解這兩個導致容量衰減和循環性能劣化的關鍵問題，分別採用陰陽離子復合摻雜和尖晶石晶粒表面包裹兩種措施，對尖晶石結構limn _ 2o _ 4正極材料進行了改性研究。
  9. The spray consists of a synthetic polymer mixed with ethanol and placed in a small, high - tech dispenser that could be mistaken for a prop on the set of star trek

    這種噴劑是一種摻有乙醇的聚合物，被置於一個不大而精密中分配器中。這個分配器很像電影《星球大戰》中道具飛船帶噴咀的推進器，用一外加電場對混合溶液充電。
  10. This means the saturation degree of concrete is different. by means of analyzing the l9 ( 34 ) orthogonal table, the air content is the chief factor, the second factor is water binder ratio and the third is mineral admixture in both high water pressure and low water pressure. the water saturation degree of concrete in damaging point ( e6 / e0 = 60 % ) can be found by measuring the dynamic modulus of elasticity after six freezing - thawing cycles

    採用l9 （ 34 ）正交表對水膠比、含氣量和摻合料三個因素進行分析，試驗結果表明:在自然情況下，影響混凝土水飽和系數的主要因素是水膠比，而影響混凝土在鹽溶液中飽和系數的主要因素則是含氣量;在水壓力作用下，無論壓力大小，混凝土水飽和系數的影響次序依次為含氣量、水膠比、摻合料。
  11. By using the method of orthogonal table, the water binder ratio, air content and mineral admixtures which affect the saturation degree are analyzed in this paper. meanwhile in freezing and thawing cycle circumstance including water environment and 3. 5 % nacl liquor, the saturation degree and the saturation rate are also analyzed. moisture content of the concrete is different by varying water pressure

    本文採用正交分析方法，研究了自然飽水和壓力飽水條件下水膠比、含氣量和摻合料三個因素對混凝土飽和系數的影響規律，並研究了混凝土在純水和3 . 5 % nacl溶液中受凍后飽和系數的變化規律。
分享友人
分享到 Line

分享到臉書