溶液生長法 的英文怎麼說

中文拼音 [róngyèshēngzhǎngfǎ]
溶液生長法 英文
solution growth method
  • 溶 : 動詞（溶化; 溶解） dissolve
  • 液 : 名詞（液體） liquid; fluid; juice
  • 生 : Ⅰ動詞1 （生育; 生殖） give birth to; bear 2 （出生） be born 3 （生長） grow 4 （生存; 活） live;...
  • 長 : 長Ⅰ形容詞1 （年紀較大） older; elder; senior 2 （排行最大） eldest; oldest Ⅱ名詞（領導人） chief;...
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  • 溶液 : solution; liquor; scald; aqua
  • 生長 : grow; grow up; ascent; merisis; build up; auxesis; increment; overgrowth; gain; burgeon; bourgeon...
  1. The amount of free ions and labile complexes of copper has been determined and the apparent stable constants have been calculated in a proteose peptone medium by anodic stripping staircase voltammetry ( assv )

    採用陽極階梯溶出伏安法，測定了蛋白腖細胞生長液中的易變形態銅，並獲得了總銅量中易變形態的摩爾分數以及易變形態的表觀穩定常數。
  2. Under suitable conditions, dark brown short rhombohedron crystals could be obtained from nifb mofe protein. both of the longest sides of the biggest crystal were o. lmm. the possibility and time of the formation of crystals, and number, size, quality, and shape of crystals obviously depended not only on the kinds and concentrations of the components in the crystalline solution, but also on the methods for crystallization and technical bias, etc

    對nifb ~ - mofe蛋白的結晶及晶體生長進行了的研究，初步探討了結晶溶液各組分的種類和濃度、結晶方法和實驗操作等與能否出現晶體及晶體的數目、大小、質量、形狀和出晶時間等的相互關系。
  3. In this study a microbial system for biphenyl biodegradation is set up in order to investigate the effects of surfactants on biodegradation of hydrophobic organic compounds. four strains which can grow on biphenyl as the sole carbon and energy sources are selected out, in which alcaligenes eutrophus dj1 and pseudomonas sms02 are chosen as degradation strains. after studing the bioavailability of three nonionic surfactants ( op - 10, tween - 80, and triton x - 100 ), they are added into the biodegradation system of biphenyl

    為了考察表面活性劑對疏水性有機污染物生物降解的影響，本論文選擇聯苯作為模擬研究體系，篩選、馴化得到四株可利用聯苯作為碳源生長的菌株；考察了聯苯降解菌株對三種非離子表面活性劑op - 10 、 tween - 80 、 tritonx - 100的生物可利用性；用高效液相色譜法測定了非離子表面活性劑對聯苯的增溶曲線；較系統地研究了加入非離子表面活性劑對聯苯生物降解速率的影響。
  4. In this thesis, the mechanism of high conductivity along c direction in ktp crystal grown by high temperature solution method was firstly elucidated. a scheme of doping certain elements to reduce the conductivity of ktp crystal along c direction was put forward

    本文首先闡述了導致高溫溶液法生長的ktp晶體c向電導率較高的形成機理，提出採用摻入特定元素的離子來降低ktp晶體c向電導率的方案。
  5. And considerable work has been done hi the growth behaviour in the tetrachloride solution concluding studies of crystal growth and growth kinetics. a crystal of dimensions 20mm x 20mm x 1mm was produced hi the tetrachloride solution by lowing temperature. and bcf spiral growth mechanism for the surface diffusion model was analyzed using the kinetic data

    本文以苯為溶劑溶液降溫法培養出了60mm 40mm 3mm大尺寸hhm單晶；另外探討了hhm在四氯化碳溶液中的生長行為，溶液降溫法培養出了20mm 20mm 1mm的較大尺寸單晶，並用動態循環體視顯微鏡觀察法測定了其在不同的過飽和下主要顯露晶面的法向生長速率，在較大過飽和度范圍內考察了其bcf表面擴散螺位錯生長機制。
  6. In this paper, the ceramic coatings were prepared in situ on ti - 6al - 4v alloy by micro - plasma oxidation ( mpo ). the phase composition, microstructure and corrosion resistance of the ceramic coatings were studied in detail and the technology of corrosion resistant coatings was optimized. the dissolution of the substrate and the changes of the elements in the electrolyte during the mpo process were studied to discuss the growing characters and the structure of the ceramic coatings

    本文通過微等離子體氧化（ mpo ）方法在ti - 6al - 4v鈦合金表面原位生長陶瓷膜，系統地研究陶瓷膜的相組成、微觀結構及膜層耐腐蝕性能，並優化耐蝕性陶瓷膜層制備工藝;分析基體在mpo過程中的溶解現象和電解液中離子濃度變化特點，探討電極表面陶瓷膜層生長規律和結構特點;研究膜層的等效電路、膜層結構與耐腐蝕性能的關系，並對優化工藝條件下制備的陶瓷膜層進行進一步的耐腐蝕性能測試和耐腐蝕機制研究。
  7. Considering the mass balance law for solute, and combining with the populance balance model and the mccabe ' s l law, a linear crystal growth rate model was presented for potassium nitrate aqueous system. the test variables of both the liquid and solid for kinetic parameter estimations were given on this model, and the experimental apparatus were also set up

    基於粒數衡算模型，以kno _ 3 - h _ 2o為模型研究體系，根據結晶過程中溶質質量守恆和mccabe定律，首先建立了晶體線性生長動力學模型，並確定出動力學參數估計所需要表徵的固液兩相物理參數，進而建立了實驗表徵方法和測定裝置。
  8. Carbon nanotubes were separately synthesized by a new pulsed laser ablation ( pla ) for in - situ growth method and cvd support method in this paper. ft - ir, uv - vis, xfs, laman, tem, xrd, bet methods were used to characterize the sol, carbon nanotube and other products in the experiment. in the pla method, the sols containing carbon nanotubes were successively obtained by using 1064nm pulsed laser to ablate the interface of fe / c, or ni / c targets and ethanol under common temperature and pressure, and then carbon nanotubes were directly acquired by evaporating the ethanol

    脈沖激光轟擊原位生長法是在常溫常壓下使用1064nm波長的脈沖激光轟擊目標靶與乙醇流動相的固液界面來連續制備含有碳納米管的溶膠，進而除去乙醇相得到碳納米管，其中目標靶為石墨與fe 、 ni等金屬催化劑混合壓製成的靶片； cvd基體法是使用自製的六方介孔mcm - 41多孔材料為基體，負載fe催化劑活性組分，通過cvd法催化裂解c2h2來生長碳納米管。
  9. In this paper, a novel method for synthesis of zno colloidal spheres is presented. in addition, we have proposed a tunable pc, in which the pbg can be tuned as desired by controlling parameters such as zno colloidal spheres size and temperature

    利用膠體自組裝法制備了zno光子晶體，並通過控制反應溫度、溶液a用量、膠體懸浮液的濃度、前處理溫度、基片潔凈度等因素，可以實現對zno光子晶體的可控生長。
分享友人
分享到 Line

分享到臉書