滑動量 的英文怎麼說

中文拼音 [gǔdòngliáng]
滑動量 英文
slippage
  • 滑 : Ⅰ形容詞1 （光滑; 滑溜） slippery; smooth 2 （油滑; 狡詐） cunning; crafty; slippery Ⅱ動詞（貼著物...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 滑動 : slither; slippage; slipping; slide; sliding; run; sliding movement [motion]; glide; slump滑動閘門...
  1. Measurement of cage speed can be used to assess the amount of sliding.

    測量保持架的轉速可用來估算滑動的大小。
  2. The bacilliform cell penetrate into interior of the fibre to degrade the cellulose strongly and produced a mass of sticky polysaccharides. after cultured 48 hours, the bacilliform cell ' s surface of sporocytophaga have a great change. at this stage the bacilliform produce a lot of sticky polysaccharides. these sticky polysaccharides associated with the sites where the filter paper was decomposed intensively and form thorns on the surface of the bacillium. at the same time, the filter - paper weight loss is the greatest and decomposing rate is the fastest, so we think that the sticky polysaccharides are produced during the cellulose degradation

    培養48小時，桿狀細胞的表面結構發生很大的變化，此時的菌體表面已產生大量的粘性多糖，這些粘性多糖因菌體在纖維素表面滑動而在菌體表面形成突起，即在纖維素被旺盛降解部位的菌體表面產生了大量突起；而產生突起的菌體深入到纖維素分子內部，纖維素表面可以清晰地看到由於菌體嵌入纖維素分子內部而留下的凹陷。
  3. Abstract : in this paper, friction drive theory is analyzed. between sliding and creeping, analysis are conducted, and the quantity of creeping is obtained

    文摘:分析摩擦傳動機理，對打滑和蠕動現象進行了分析和比較；推導出蠕動量的計算公式，並進行了分析。
  4. The inverse kinematics of a space - based manipulator composed of three rigid bodies with prismatic joint are studied in the second chapter, and the jacobean matrix for space manipulator is derived by fully cartesian coordinates. a control method for space manipulator based on the resolved motion rate control concept is proposed

    為此結合系統動量及動量矩守恆關系導出了以完全笛卡爾坐標表示的系統運動jacobi矩陣，並在此基礎上研究了帶滑移鉸空間機械臂的分解運動速度控制方法，給出了計算機數值模擬算例，以此證明了該方法的有效性。
  5. Methods of test for ancillary components for masonry - determination of shear load capacity and load displacement characteristics of shear ties and slip ties couplet test for mortar joint connection

    圬工輔助砌塊的試驗方法.剪切桿和滑動桿的拉伸和壓縮負載容量和負載轉移特性的測定
  6. Conglomeration of fillers also easily fall off from the matrix, and all these result in wear mass loss increasing. the worn surfaces of the composites having 5 phr, 10plir, 20 phr nano - al2o3 are respectively studied by using the scanning electron microscopy ( sem )

    另外，在相同滑動條件下，隨著粒徑的增大，尼龍6 / a120 :復合材料的磨損量上升，納米級粒子填充的復合材料較微米粒子填充的復合材料耐磨性能要好。
  7. Anchor the mic stand with sand bags or any stable, heavy object that will not slip or rattle ( three sand bags in a triangular position works for me )

    可以用沙袋或者其他固定方法來固定麥架，重量可以讓它不滑動或者發出嗒嗒聲（我會把三個沙袋成三角形位置安置） 。
  8. On the portion where slippage is small or nonexistent, surface offsets should be a maximum and of the order of the throw at depth.

    在斷層中滑動很小或不存在有滑動的部位，表面錯距可能最大並和深部差動屬同一量級。
  9. The actimum series provides the most professional material and design, which is suitable for skiing and climbing

    Aigle產品中的專業actimum系列，提供最專業的布料及設計，適合運動量較大的滑雪或攀山等活動。
  10. In theoretical analysis, the motion of radially - emitted electron beam in diode region and drift region has been analyzed, and the relation between radial momentum or current of electron beam and the guiding magnetic field has also been studied, then the possibility to optimize the guiding magnetic field has been derived. the motion of radially - emitted beam electrons in smooth bore magnetron and smooth bore milo has also been studied theoretically. at last, the motion of radially - emitted beam electrons in compound axial and azimuthal magnetic field has been studied

    在理論分析中，初步分析了軸向發射條件下電子在二極體區域和漂移區的運動規律，電子徑向動量隨著外加磁場變化的規律，以及電子束電流隨著外加磁場的變化規律，還有二極體區域磁場優化的可能性;分別研究了有軸向磁場時以及有角向磁場時徑向發射的電子在光滑陽極結構中的運動規律，最後分析了在軸向和角向復合磁場中電子的運動規律。
  11. Naids is the first data mining based anomaly detection system, the first intrusion detection system which lower false positive rate by classification engineering, the first intrusion detection system which put forward sliding windows techniques to carry out incremental, on - line mining

    Naids是第一個基於數據挖掘方法的異常檢測系統，是第一個通過分類引擎來降低誤報率的入侵檢測系統，是第一個提出滑動窗口技術實施在線增量式挖掘的入侵檢測系統。
  12. And also, the wear resistance at ambient temperature and of za27 alloyed with mn when lightly loaded is desirable but becomes worse at high temperature. the wear mechanism of the one mixed with both adhesive and abrasive wear under sliding friction conditions ( at high temperature )

    Si的加入量為1 - 3時， za27合金的磨損量最少，高溫摩擦性能最好；加入mn后， za27合金在低溫輕載下耐磨性能較好，高溫耐磨性能不理想；在滑動摩擦條件下（高溫）的磨損以粘著磨損和磨料磨損兩種方式共同存在。
  13. Against the particularity of problem of gas bursting of ( subscript 1 ) coal seam in ludian gliding structure in west henan, through a large amount of work of field surveys and interior research, and viewed from the basic theories of structural petrology, discussed some characteristics of mining gas hazard such as image, mechanism and tectonic control process

    摘要針對豫西蘆店滑動構造區二（下標1 ）煤層瓦斯突出問題的特殊性，通過大量野外地質調查和室內研究工作，從構造巖石學基本理論著手，討論了構造區礦井瓦斯地質災害的表象、機理和構造控製作用。
  14. Plain bearings - quality assurance of thin - walled half bearings - design fmea

    滑動軸承.薄壁軸瓦質量保證. fmea設計
  15. When a small window is selected, the local signals can be derived. when a large window is selected, the global information is calculated. using the wavelet de - noising techique, the isochore boundaries in human genomes are correctly located by combination of the information derived from two scale windows

    本論文提出組合窗口模型方法識別人類基因組的isochore邊界，利用滑動窗口可以連續地提取基因組的g + c含量，小尺度窗口可以提取局域信息，大尺度窗口可以提取全局信息，組合兩方面的信息，並結合小波消噪技術可準確地識別人類基因組的isochore邊界。
  16. Based on the pull - out tests data between geogrids and expansive soil / sands arranged by the orthogonal table l9 ( 34 ), the following conclusions are reached : 1 ) the displacement - properties of pullout tests depend on the pullout speed. the law of factors " affecting degree, which influences the parameters between geogrids and soils in the pulling - out procedure, is obtained. with the concept of " equivalent pull - out displacement ( x ) " brought forward, the whole process of pull out tests is divided into two process - " main process ( when x 1. 0 ) " and " residual process ( when x 1. 0 ) ", and three stages - static friction resistance stage, slip friction resistance stage, and residual friction resistance stage

    基於正交設計表l9 （ 3 ~ 4 ）分別安排了影響因素與土工格柵膨脹土或砂土界面相互作用參數的拉拔試驗數據，獲悉： 1 ）拉拔試驗位移特性主要取決于影響因素中拉拔速率；通過分析並獲取影響因素對筋土界面相互作用參數的影響程度及其在拉拔試驗過程中的變化規律，提出了當量拉拔位移（ x ）的概念，並據此將拉拔試驗全過程劃分成「主過程（ x 1 . 0 ） 」和「殘余過程（ x 1 . 0 ） 」 ；且將影響因素對拉拔力或摩擦阻力系數的影響程度分成三階段（靜摩擦阻力階段、滑動摩擦阻力階段，殘余摩擦阻力階段） ； 2 ）不同（規范）定義的筋土界面摩擦阻力系數數值相差較大，但影響因素對摩擦阻力系數影響程度及其變化規律不會因不同（規范）定義而受到影響。
  17. The equipment adopts centrifugal sliding plow groove rotor and is the newest structure evaporator at present. it can form membrane under the condition of small flow. comparing with that of fixed space drag evaporator, its evaporation capacity can increase 40

    本設備採用離心式滑動溝槽轉子，是目前國外最新結構蒸發器，在流量很小的情況下也能形成薄膜，在簡體蒸發段內壁表面附著處理液中的淤積物可被活動刮板迅速移去，和固定間隙的刮板蒸發器相比，蒸發量可提高40 69 。
  18. If we halve the mass carried, sliding friction is also halved

    如果我們將質量減半，滑動摩擦力也會減半。
  19. With the development of automobile industry and road transportation ， the traffic accidents happen every day in the world and become a serious society problem the vehicle collision accidents are over 2 / 3 times as much as all traffic accidents they cause a large amount of social infuence and serious economic loss therefore ， it is urgent to study vehicle collision accidents comprehensively and systematically ， and the research also is the academic foundation to analyze and deal with traffic accident it is difficult to authenticate car velocity after traffic accident to dig over locate witness is right way mechanics is avaid tool in this field it is important to establish math model and this is precondition to calculate vehicle velocity firstly on the basis of summarizing the research results ， this paper deeply discusses the calculating model to analyze the instantaneous motion state in the vehicle collision, the interrelation among the every moving mechanics parameters in the every phase of the collision secondly ， according to the collinear collision and two - dimension collision and the restitution coefficient ， the paper estabishesthe post collision movement models it proves that these models are correct and valid thirdly ， this paper try to research reconstruction of road traffic accident and put forward the method on it

    對交通事故的科學分析應是建立在正確的數學模型與計算機模擬技術基礎上的定量分析，其基本條件就是要有能正確描述事故過程中汽車狀態的數學模型，只有建立正確的數學模型，才能較準確地推定事故車輛的碰撞速度。所以建立正確地車輛碰撞模型和運動模型正是汽車事故再現的關鍵問題。本文首先在總結前人研究的基礎上，深入地研究汽車碰撞理論，分析了車對車碰撞作用瞬間狀態的計算模型及碰撞恢復系數與碰撞前、后速度的關系；其次，根據交通事故中最普遍的一維和二維碰撞的不同情況，採用恢復系數和滑動摩擦系數等概念，分別建立了碰撞后車輛動力學模型；第三，對汽車碰撞事故再現進行了初步研究，確定了車對車碰撞事故模擬計算和反推計算方法，並給出相應的模擬程序流程圖。
  20. Its flaw is that after the system state getting to the sliding plane, it will produce high frequency chattering around the sliding plane and the control variable of the system will also produce high frequency chattering

    它的不足主要是當系統運動狀態在到達滑動平面后，會在滑動平面附近產生高頻抖振，同時系統的控制量也產生高頻振蕩。
分享友人
分享到 Line

分享到臉書