漂移電位 的英文怎麼說

中文拼音 [biāoyídiànwèi]
漂移電位 英文
drift potential
  • 漂 : 漂動詞[方言] （事情、帳目等落空） fail; end in failure
  • 移 : Ⅰ動詞1. （移動） move; remove; shift 2. （改變; 變動） change; alter Ⅱ名詞（姓氏） a surname
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  • 漂移 : 1 （漂流移動） be driven by the current; drift about2 [電子學] drift; shift; shifting; shunt runn...
  1. The effect on display characteristic made by thermal deformations of the shadow mask is comprehensively investigated. by using the electron beam distribution automatic measurement system with a micro - deflective coil, a concave spot in luminance distribution can be get. it changes its position when the shadow mask changes its form

    本文系統全面地分析了傳統蔭罩的各類熱變形對顯示屏特性的影響，利用本文研製的電子束亮度分佈自動測試系統，附加一個微偏轉磁場，使相鄰兩電子束打在同一顏色的熒光粉條，並形成一個亮度凹點，當蔭罩變形時，凹點位置作相應的位移，以此原理跟蹤測量凹點位移量，即可得到色純漂移動態變化曲線。
  2. In general, a precise resistor is in series with one of the resistors in wheatstone bridge to compensate the zero offset, and the other one is in parallel with another arm of the wheatstone bridge to compensate thermal zero drift. based on this principle, in this paper, a compensation method based on virtual instrument technology has been put forward. actuated by current source, a good calculation method of compensation resistors and their position in the bridge is deduced

    本文基於串並聯電阻補償法的原理，提出了一種基於虛擬儀器的誤差補償方案，推導了在恆流源供電下可以精確的計算出補償電阻大小和補償位置的演算法，並且在虛擬儀器軟體平臺labview上完成了數據採集、處理、顯示等軟體的設計，經過實驗的驗證，對傳感器的零點溫度漂移補償取得較好的效果，而對靈敏度溫度漂移的工藝補償亦有一定的效果。
  3. Based on an analysis of the major factors affecting the quality of data obtained in aeroelectromagnetic survey, this paper has put forward zero horizontal drift correction methods such as field value standardization and phase check and correction, studied and developed a suite of techniques suited to data - processing and graphical representation for aeroelectromagnetic method

    摘要在分析探討影響航空電磁測量數據質理主要因素的基礎上，提出了場值標定，相位校驗改正等零水平漂移改正方法，研究開發了一套適合航空電磁法數據處理與圖示的方法技術。
  4. It radically solves the problems, which are lead by bad contacts of mechanical potentiometer, such as noise and excursion

    從根本上解決機械電位器因接觸不良而產生的噪聲、漂移等問題。
  5. Abstract : the attitude error performance of electrostatic gyro should be understood and the relevant error equations must be set up in order to ensure the navigation precision of esgm. the relation between the navigation errors and the attitude errors of gyro was derived by use of spherical triangle. the simulation results show that the temporal performances of the longitudinal and distance errors which come from the initial alignment errors are periodically variational. they also show that the longitudinal and distance errors resulted from gyro drifts are not convergent in time. thus, the effects of initial alignment errors and gyro drifts can not be neglected and must be estimated and compensated

    文摘:為了保證靜電監控器的導航定位精度，需要了解靜電陀螺的姿態誤差特性，建立相應的誤差方程.本文採用球面三角形原理推導了導航定位誤差與陀螺姿態誤差的關系式.模擬結果表明，由初始定向誤差引起的經度誤差和距離誤差的時間特性是周期變化的；由陀螺漂移引起的經度誤差和距離誤差是隨時間發散的.因此，初始定向誤差和陀螺漂移的影響不能忽略，必須對其進行估計和補償
  6. The saturation time in our simulation is consistent with the prediction of the theory. furthermore, we also studied the propagation of two pulses with inverse phase. in this case, the wakefield excited by the first pulse will be absorbed by the second pulse which shifts to higher frequency

    此外，我們還研究「位相相反」的兩個脈沖在稀薄等離子體中的傳播，第二個激光脈沖由於吸收了前一脈沖激發的靜電場，頻率向高頻方向漂移，得到頻移的大小與符合理論推測。
  7. 2. to design an axial magnetic field. the cathode lies in 0. 4 - 0. 7 of peak value of the magnetic field and excursion channel in a uniform magnetic field to suppress space charge effects ; to design transition section between the gun and excursion channel in converse computation. 3

    選擇電子槍陰極處于軸向聚焦磁場峰值的0 . 4 - 0 . 7倍處;漂移通道（互作用區）位於均勻軸向聚焦磁場中，以抑制電子束的空間電荷效應;使用反演算法設計電子槍和漂移通道之間的過渡區。
  8. At the same time, the method of disposal phase shift of ct by compensation is introduced. then the analysis and statistic of electrical power quality, the control scheme and compensating amount of capacitor for reactive power compensation are analyzed respectively. and in the paper, the control with a / y and the switch with ac contactor and solid state switch is valid measure not only for improving operate level economically and amending electrical power quality but also for avoiding of replacing switch frequently and decrease economic loss

    然後對現有的演算法進行了詳細的分析、比較，篩選出既能滿足硬體要求又可降低投資、保證精度、簡化軟體的方案，確定了準同步采樣的方案，並通過對準同步采樣誤差的分析，提出了一種從45開始采樣，從而提高精度的采樣數據處理辦法，同時，對于電流互感器相位漂移提出了一種補償辦法，接著對裝置中電能質量分析與統計以及無功補償中電容器的補償量、投切原則也作了相應分析，其中對于無功補償採用y混合接線，並利用交流接觸器和固態開關共同投切電容，不但提高了經濟運行水平、改善了電能質量，而且有效的避免了頻繁更換開關，減少了經濟損失；最後，設計了裝置的硬體電路並繪制了相應的軟體流程圖。
  9. The traditional level measuring methods can n ' t meet our demand because the subjective investigated is in such a poor systemic condition that the temperature is a little high and there ' s so many mill dust and steam there. in this article we perform systemic discuss and research against the dynamic level measuring method under special working condition on the basis of analyzing kinds of level measuring technique in and abroad. first we establish the pressure distribution mathematic model in storage bin and then deduce the mathematic relation between level height and the uniform stress on the bottom of the bin and designed a resistance compressive stress sensor used for the special condition and put forward a resoivement according to its zero excursion existing in practical use

    由於本研究系統被測對象環境溫度較高且潮濕，同時料倉中有大量粉塵及蒸汽，因此傳統的料位檢測方法不能滿足本測試要求。本文在分析國內外各種物位檢測技術的基礎上，針對特殊工況下動態物料高度的檢測進行了系統的探討與研究。首先建立了料倉中的壓力分佈數學模型，推導出料位高度與倉底均布壓力間的數學關系式，並據此設計了中溫電阻應變式壓力傳感器，同時對它在實際應用中存在的零點漂移等問題提出了改進措施，提高了傳感器性能，解決了上述特殊工況下動態物料檢測的技術難題。
  10. At last, the experiment result proved the effectiveness of the spectrum rebuilding technology. the experiment result show that the wavelength detection accuracy is improved by an order of magnitude using the spectrum rebuilding technology compared with that obtained from direct peak search. some other schemes to enhance the accuracy are illustrated

    最後列舉了其它幾種提高測量精度的方案，包括關鍵器件可調諧濾波器的位置變化提高信噪比，調整探測器pinfet的輸出電壓的零點以提高a / d採集卡的利用率，以及採用系統參考消除系統誤差造成的波長漂移。
  11. A temperature compensation algorithm to overcome cross sensitivity according to the behavior of the inductance sensor, and a system self - calibration algorithm to overcome the drift of the analog circuit are designed. on the basis of these two algorithms, a new kind of data fusion algorithm combing both of them is derived out

    提出了利用浙江大學博士學位論文智能位移傳感器系統的研究傳感元件自身特性實現溫度補償的演算法以及對模擬電路特性漂移的系統自校準演算法，並在此基礎上，提出一種將兩者有機地結合在一起的數據融合演算法。
  12. It was found from the experiment that, with the increasing of substrate temperature, there were more oxygen vacancies in the films, which lead the conductance of the sample become larger, and the absorb edge of zno thin films shifted toward higher wavelength ; with increasing of ar : o2 ratio, there were lesser oxygen vacancies in the films, which lead the absorb edge of zno thin films shifted toward lower wavelength

    實驗還發現，隨著襯底溫度的升高，薄膜中產生的氧空位將會增多，使得zno薄膜的電導逐漸增大，而且其紫外透射吸收截止邊帶向高波長方向漂移；隨著氬氧比例的增加，薄膜中的氧缺陷相對減少，薄膜的透射吸收截止邊向低波長方向漂移。
  13. It was found from the experiment that, with the increasing of substrate temperature, there were more oxygen vacancies in the films, which lead the conductance of the sample become larger, and the absorb edge of ito thin films shifted toward lower wavelength ; with increasing of ar : o2 ratio, there were lesser oxygen vacancies in the films, which lead the absorb edge of ito thin films shifted toward lower wavelength

    實驗還發現，在一定的溫度范圍內隨著襯底溫度的升高，薄膜中產生的氧空位將會增多，使得ito薄膜的電導逐漸增大，而且其紫外透射吸收截止邊帶向短波長方向漂移；隨著氬氧比例的增加，薄膜中的氧缺陷相對減少，薄膜的透射吸收截止邊向低波長方向漂移。
分享友人
分享到 Line

分享到臉書