漿質 的英文怎麼說

中文拼音 [jiāngzhí]
漿質 英文
pulpiness
  • 漿 : 漿同「糨」
  • 質 : Ⅰ名詞1 （性質; 本質） nature; character; essence 2 （質量） quality 3 （物質） matter; substance;...
  1. Neuroid identification of paste - like backfill pulp quality

    似膏體充填料漿質量神經網路辯識
  2. Also a refined - pulp quality predictive model, with specific energy, specific load as the model inputs, and beating degree, wet weight as the model outputs, is presented. simulation results show that the models can be acted as theoretical bases for the automatic control of high - consistence pulp refining process

    即，建立了以原漿流量、白水流量、盤磨機功率為輸入變量，比能量、比負荷、濃縮機漿位為輸出變量的動態模型，以及基於比能量、比負荷的成漿質量預報模型。
  3. Test methods for quality of coal water mixture - part 10 : determination for fusibility of ash of coal water mixture

    水煤漿質量試驗方法第10部分:水煤漿灰熔融性測定方法
  4. Hydropathic establishments - control of quality of the hydropathic mud - guidelines

    水治療設施.水療泥漿質量的控制.指南
  5. Test methods for quality of coal water mixture - part 6 : determination of calorific value of coal water mixture

    水煤漿質量試驗方法第6部分:水煤漿發熱量測定方法
  6. Based on the analysis of the characteristics of the raw mix slurry preparing process in alumina sintering production process, firstly, a mechanism model based on material balance principle was established as the master - rule model for the quality prediction ; secondly, considering the problem that the alkali liquor composition was unstable and its real - time measurement was difficult, a nn ( neural networks ) prediction model for the prediction of the alkali liquor composition was set up and nesting - integrated with the mechanism model ; finally, using the gray theory for the information mining from the errors of the mechanism model, a gm ( 1, 1 ) compensation model was put forward and parallel - connection - integrated with the mechanism model, achieving a raw mix slurry quality prediction model

    摘要針對燒結法氧化鋁生產過程中生料漿配料工藝的特點，根據物料平衡的原理建立機理模型，作為生料漿質量預測的主規律模型；針對堿液成分波動大且難以實時檢測的問題，對堿液成分含量建立了神經網路預測模型，並和機理模型進行嵌套集成；利用灰色理論對機理模型的偏差數據進行信息挖掘，建立了gm （ 1 ， 1 ）補償模型，並與機理模型進行並聯集成，獲得生料漿質量預測模型。
  7. In practice, it is not uncommon for disturbances to evolve over several cooking batches, leading to a gradual drift of the pulp quality out of acceptable control limits

    實際間歇蒸煮過程中，時常有某些干擾影響連續多個批次，導致紙漿質量逐漸漂移出控制限的情況。
  8. In the alumina process with sintering, the slurry comes out from the grind with low quality because of lots of uncertainty factors and the delay of composition analysis, the qualified raw mix slurry is commonly gained through arranging

    摘要由於燒結法氧化鋁配置生料漿過程中不確定性因素多，成分分析滯后，造成生料漿出磨合格率低，一般需經調配使生料漿質量指標符合工藝要求。
  9. The results of this research show that gin grouting, compared with the traditional grouting technique, is a kind of grouting method which can save materials, simplify techniques, increase working efficient and make the foundation or curtain uniform, dense and durable. meanwhile, in gin grouting, it is more suitable to use computers to automatically monitor the grouting procedure, thus to reduce artificial influences and increase grouting quality

    本試驗研究成果表明gin法灌漿與傳統灌漿工藝相比是一種節省材料、簡化工藝，可提高工效並使基礎或幕體均勻緻密且耐久，同時更適用於計算機自動監控灌漿過程、減少人為因素影響，提高灌漿質量的灌漿方法。
  10. With the soft sensor we developed, stable control of high - consistence refined - pulp quality is achieved by adjusting concentrator level, pulp consistence and disc refiner power properly. to insure safety in the refining process, sequential control system and interlock protection system are designed and realized

    為了得到穩定的成漿質量，採用基於軟浙江大學博士學位論文口測量模型，適當調節濃縮機漿位、出口濃度、盤磨機功率的策略，實現了打漿度、濕重的穩定控制。
  11. Abstract : the paper introduces advantages of cantilever assembly of long - span pc continuous beam. exploration is made on line control, shear key design, matching face treatment and grouting quality requirements, etc

    文摘:結合工程實際介紹大跨度預應力混凝土連續梁懸拼施工的優點，對線形控制、剪力腱的設計、匹配面處理、壓漿質量要求等問題進行了探討。
  12. Test methods for quality of coal water mixture - part 1 : sampling for coal water mixture

    水煤漿質量試驗方法第1部分:水煤漿采樣方法
  13. Test methods for quality of coal water mixture - part 3 : sieving method for coal water mixture

    水煤漿質量試驗方法第3部分:水煤漿篩分試驗方法
  14. Test methods for quality of coal water mixture - part 7 : proximate analysis of coal water mixture

    水煤漿質量試驗方法第7部分:水煤漿工業分析方法
  15. Test methods for quality of coal water mixture - part 12 : determination of nitrogen of coal water mixture

    水煤漿質量試驗方法第12部分:水煤漿氮測定方法
  16. Experimental study of nondestructive testing for grouting quality in prestressed concrete t - beam

    梁束孔管道壓漿質量的無損檢測試驗研究
  17. Verification results show that the quality prediction model is with satisfactory prediction accuracy, and its industrial application will benefit to improving the quality of raw mix slurry

    驗證結果表明，該質量預測模型能獲得較理想的生料漿質量預測精度，其應用可使生料漿質量得到顯著的提高。
  18. However, its cement rock has disadvantages - low strength, drying shrinkage and low durability. to apply the gin grouting method in practice and improve the grouting quality and its durability, it is necessary to develop the high performance grouting material

    ，為了gin灌漿法的推廣應用和技術提高，切實保證高壩工程中的灌漿質量和可靠耐久性，迫切需要研製出一種高性能穩定性灌漿材料。
  19. Firstly, the batch cooking technology and reaction machanism in the cooking process are introduced. an overview on the history and latest achievements in modeling and control of batch cooking process are given. advantages and problems of quality control and monitoring for batch cooking process are discussed and research direction of this dissertation are pointed out

    主要內容包括： 1 、介紹了間歇制漿蒸煮過程工藝、反應機理，總結了間歇蒸煮過程建模和控制的發展歷史與研究現狀，簡要介紹了常用的建模方法和控制策略，分析了間歇蒸煮紙漿質量控制和過程監控存在的問題。
  20. The proposed state - space monitoring approach is tested on a pulp digester. 4sid method is used to develop a state - space model of multi - dimensional batch variables correlation from nomal operating data. simulation results on pulp quality control and process monitoring shows the effectiveness of the method

    4 、在上述研究的基礎上，以間歇蒸煮為應用背景，對過程輸入輸出數據進行子空間辨識，建立了狀態空間模型，應用於該過程的紙漿質量控制和過程監視。
分享友人
分享到 Line

分享到臉書