激光散斑 的英文怎麼說

中文拼音 [jīguāngsǎnbān]
激光散斑 英文
laser speckle
  • 激 : Ⅰ動詞1 （水因受到阻礙或震蕩而向上涌） swash; surge; dash 2 （冷水突然刺激身體使得病） fall ill fr...
  • 光 : Ⅰ名詞1 （照耀在物體上、使人能看見物體的一種物質） light; ray 2 （景物） scenery 3 （光彩; 榮譽） ...
  • 散 : 散動詞1. （由聚集而分離） break up; disperse 2. （散布） distribute; disseminate; give out 3. （排除） dispel; let out
  • 斑 : Ⅰ名詞（斑點; 斑紋; 污點; 瑕疵） spot; speck; speckle; stripe; stain Ⅱ形容詞（有斑點或斑紋的） spo...
  • 激光 : [物理學] laser 激光靶 laser target; 激光報警器 laser avoidance device; 激光玻璃纖維 laser fibre; ...
  1. The visx star star 4 combines the technologies of customvue wavescan aberrometer, activetrak 3 - d active eye tracking, iris registration, variable spot scanning and variable repetition rate to provide customized wavefront treatment. in the past, standard lasik corrects refractive errors, such as myopia, hyperopia and astigmatism which are so - called low order aberrations

    威視visx star 4是結合前波前像差分析儀3d眼球主動追蹤系統虹膜定位系統ir iris registration及智慧型超微光斑等技術去提供個人化激光矯視療程。在過去，標準lasik可解決近視遠視及散光等所謂低階像差問題。
  2. It has been shown that when the partially coherent beams propagate in the atmosphere, it may be less affected by turbulence than are fully coherent ones. moreover in laser fusion a highly coherent beam is transformed into a partially coherent beam, for reducing the speckle and for getting more smooth focused spot

    例如，部分相干光在大氣中傳輸時所受大氣騷動的影響要比完全相干光小得多;並且部分相干光束具有光強比較均勻，對散斑低靈敏等優點而被應用於激光核聚變等領域。
  3. As proved by experiments, the present method can effectively restrain the influence of speckle to the laser triangular measurement system and the obtained calibration accuracy is about 0. 05mm within 100mm depth range

    只需對特殊設計的模塊進行一次測量，便可完成對整個測量系統的校準。該方法能夠有效的抑制激光散斑的影響，具有較高的系統精度。
  4. The propagation of ultrashort laser pulse in air is analyzed with mechanics analogy by considering kerr effects and free electron defocusing. the equation describing the evolution of the laser spot is derived. it is shown that long distance focusing requires large initial beam and the propagation distance is very sensitive to the initial divergence angle of the laser beam

    考慮多光子電離效應和光學kerr效應，首次利用力學類比的方法研究了超短脈沖激光在電離氣體中的傳輸，詳細分析了傳輸距離與激光初始光斑、初始發散角以及激光功率的關系，提出了實現長距離傳輸的條件。
  5. The influences of optical feedback and external cavity length on the laser output are studied, and the relation between fluctuations of speckle signal and the transverse velocity of rough surface is discussed

    分析了隨機變化的反饋強度與外腔長度對激光光譜特性的影響。模擬了散斑干涉信號的波動與粗糙表面橫向移動速度的關系。
  6. A monte carlo algorithm was presented to model the relation between the scattering phenomenon, depolarization changes and sea water depth, it is discovered that the radius of scattering point and the degree of depolarization increase with increasing of the sea water depth. at last, a optical engineering software ( lighttools ) is introduced to simulate optical scattering in the deep sea water, and studys the corelation between scattering and relative refractive index, particle density and particle size in the sea water. the experiment results show that the intensity of scattering will increase evidently with the increasing of particle size, particle density and relative refractive index. the methods and results in the article provide the basic theory and experiment validation for improving performance of communication, detection and imaging under sea water

    本文以球形粒子的mie散射理論、 stokes矢量法以及mueller矩陣來研究海水的散射特性和散射中的退偏振度變化;通過montecarlo方法模擬藍綠激光在海水傳輸過程中的散射現象以及散射中的退偏度變化與海水深度的關系，發現隨著海水深度的增加，散射后的光斑半徑、退偏振度將逐漸增大。最後通過光學工程軟體（ lighttools ）對海水中的散射進行模擬實驗，研究散射與海水中粒子密度、粒子大小和相對折射率的關系。實驗結果表明，隨著粒子半徑、粒子密度和相對折射率的增加，散射的強度將顯著增加。
  7. The effect of the angle of laser incidence on photoacoustic signal

    入射角對激光散斑測量表面粗糙度的影響
  8. Due to great advantage of the excimer laser in photoelectron material, photoelectron technology research, so in this thesis, a xecl excimer laser is designed in order to solve some problem in semiconductor film, cmr film, quartz film and other kind of film application, optical etching field, interaction between laser and material, material plasma study. the parameters of the excimer laser is e also measured and analyzed

    因此本文以氣相沉積、外延生長、巨磁薄膜、金剛石及其它薄膜制備及后續的光刻，激光與物質的相互作用，等離子體研究為目的，研製獲得了激光脈寬18ns ，單脈沖能量150mj ，矩形光斑大小2cm 1cm ，束散角3mrad ，最高重復頻率5hz的xecl準分子激光器。
  9. The results can be summarized into the following aspects : molecular dynamics study of liquid - vapor interface shows that the planar liquid - vapor interface at macroscopic level is in fact a wavy surface fluctuating with time, and the length scale of the fluctuating region of the wavy surface is the thickness of the liquid - vapor interface. with speckle laser visualized experiment, the fluctuation of the interface can be verified qualitatively. moreover, md simulations indicate that in the liquid - vapor equilibrium system, there exists a local non - equilibrium region near the interface

    主要研究成果歸納如下：對汽液界面進行了分子動力學研究，揭示出宏觀尺度的平界面在分子尺度上是隨時間起伏漲落的曲分界面，分界面的漲落區域就是汽液界面的厚度，相應的激光散斑實驗也定性地證明了界面漲落區的存在；研究還發現在汽液平衡體系中，界面附近存在局域熱非平衡區域，並指出了其可能的原因及影響。
  10. The pd packaged in the laser diode can detect the signal of the self - mixing speckle interference and determine the motion state of the target

    封裝在半導體激光器另一側的光電二極體，檢測光學反饋生成的自混合散斑干涉信號，確定物體的狀態。
  11. Laser speckle interferometry was used as the experimental method to test the coefficient of thermal expansion ( cte ) of the metal composite leads used in the packaging structures and the thermal deformations of the entire packaging structures due to the change of temperature from room - temperature to 150oc

    通過實驗和數值模擬的方法對其熱變形和熱應力進行了研究。採用激光散斑干涉法測量了從室溫到150oc的封裝用金屬復合引線的熱膨脹系數和整個封裝結構的熱變形。
  12. Two methods of reducing the speckle noise and improving the depth resolution in optical 3d profilometry with laser sheet are proposed in the paper

    本文提出了兩種激光片光三維傳感中減小激光散斑影響，提高深度解析度的辦法。
  13. Math. and physics department, yanshan university, qinhuangdao 066004 ) [ / align ] [ align = left ] [ b ] abstract [ / b ] : through the pictures taken by means of laser speckle on the metal material weldment, we can obtain double - exposed displacement patterns at a temperature range. by point - to - point analysis heat displacement field at the welding points can be measured, and the distribution of thermal strain and thermal stress can be obtained. as a result, the flaws at welding points can be measured through experiments

    本文應用激光散斑法，其測量靈敏度介於全息干涉法和雲紋法之間，象所有其它散斑法一樣，它是一種非接觸式的測量技術，對環境及設備條件要求不高，對被測件表面不需進行特殊處理，可在生產現場對實際物體進行測試。
  14. We use the laser output ( 320 nm, 200 fs ) of optical parametric amplifier ( opa ) in < wp = 5 > an active passive mode - locked femtosecond ti - sapphire laser operating at a repetition rate of 1khz as a exciting resource to develop optically pumped stimulated emission of zno thin films. when rectangular stripe laser irradiates thin films, optical resonant cavity is naturally formed between two nanocrystallites along with the rectangular laser stripe and planar weveguide confines the light scattering

    利用飛秒激光器作為光泵浦激發光源，研究了氧化鋅薄膜的光泵浦受激發射，當條形光斑輻照薄膜樣品時，將沿著光斑條由氧化鋅納米晶面自然地形成光學諧振腔，由於平面介質波導結構限制光散射，所以成功地觀測到二氧化硅襯底上的納米氧化鋅（ zno ）薄膜的紫外受激發射。
  15. Based on the rate - equation theory of four - level system, the expressions of threshold pump power, output power and slope efficiency are given. the influence of space distribution of pump light ( the position of focusing point, dimension of pumping light and divergence angle ) to the output characteristics are also discussed. then, by investigating the effects of thermal effect of laser crystal on the size of laser cavity mode, we obtain the mode - matching principle of high power laser diode end - pumped solid - state lasers

    其中，在泵浦光的空間分佈變量中我們分別考慮了泵浦光聚焦后的腰斑大小、聚焦腰斑在增益介質中的位置以及泵浦光在介質中發散角的影響；然後我們研究了在高泵浦功率下激光晶體因吸收泵浦光而產生的熱效應所導致的熱透鏡效應以及熱致衍射損耗，通過分析它們對振蕩激光腔模尺寸的影響，得到了高功率半導體激光二極體端面泵浦固體激光器模式匹配的要求，為高功率連續單頻nd ： yvo _ 4激光器的優化設計提供了理論依據。
  16. Single mode optical fiber laser confocal scanning microscopy is a new technology in microstructure studying. the speciality of the system is limiting the out - of - focus light reflected from out - of - focus plane in object to restrict the blur of image. therefore, the plane resolution and axial resolution of the system could be improved to sub - micron grade

    單模光纖激光共焦掃描顯微成像系統是研究微觀結構的一種新技術，其本質是抑制目標物體離焦面所反射的光線進入系統，從而抑制這些離焦光線造成像點彌散斑增大的影響，使系統的橫向與軸向解析度得到大幅度的提高，能實現亞微米級的層析。
  17. When laser diode illuminates the rough surface moving transversally across the light beam, the feedback light forms the random speckle due to the random pattern of the target surface, causing random fluctuations in the laser output, which is called as self - mixing speckle interference

    結合自混合和散斑的原理，將散斑現象引入半導體激光器。讓半導體激光器的光學反饋來自垂直地照射的粗糙表面，把光強調製成為隨機的散斑信號。
  18. The main characteristics of the optical system of the transmitter are analyzed and simulated, and the transmissivity, the output laser radiation angle and output laser shape of the optical system of the transmitter are tested in the experiments

    對發射光學系統進行了詳細的理論分析和模擬，通過實驗測試了發射光學系統的透過率、輸出激光的發散角和光斑形狀。
分享友人
分享到 Line

分享到臉書