激光用元件 的英文怎麼說

中文拼音 [jīguāngyòngyuánjiàn]
激光用元件 英文
laser components
  • 激 : Ⅰ動詞1 （水因受到阻礙或震蕩而向上涌） swash; surge; dash 2 （冷水突然刺激身體使得病） fall ill fr...
  • 光 : Ⅰ名詞1 （照耀在物體上、使人能看見物體的一種物質） light; ray 2 （景物） scenery 3 （光彩; 榮譽） ...
  • 用 : Ⅰ動詞1 （使用） use; employ; apply 2 （多用於否定: 需要） need 3 （敬辭: 吃; 喝） eat; drink Ⅱ名...
  • 件 : Ⅰ量詞（用於個體事物） piece; article; item Ⅱ名詞1. （指可以一一計算的事物） 2. （文件） letter; correspondence; paper; document
  • 激光 : [物理學] laser 激光靶 laser target; 激光報警器 laser avoidance device; 激光玻璃纖維 laser fibre; ...
  1. Based the eag - i etchant, a new etchant was developed, with which the etch pit pattern on ( 110 ), ( 111 ) and ( 100 ) faces of czt crystals can emerge immediately and effectually. this pager investigated relation between the ( 110 ) faces of cutting from crystals conveniently and accurately by laser reflex method. by the surface treatment, the nuclear radiation detector was fabricated with ( 110 ) of czt crystal and strong 241am responsibility was observed

    在改變e _ （ ag ）腐蝕液的配方的基礎上，研製了新的腐蝕液，可方便、快速、有效的顯示czt不同晶面的缺陷蝕坑形貌;研究了利用激光正反射法和自然解理的不同（ 110 ）面之間的關系，方便、快速、準確的進行定向切割晶體的方法;採用生長的czt單晶體自然解理的（ 110 ）面，經過表面處理，試制了探測器元件，對24lam有較強的響應。
  2. By improving the conventional electric - arc fusion method, we have realized the splicing between two kinds of mofs and smf with relatively low splice losses. we have written fiber bragg gratings in grapefruit mof successfully. the multi - wavelength resonances are observed in the grating, and theoretical analysis shows that this phenomenon is caused by the resonances between core modes and cladding modes

    在此基礎上對微結構光纖光柵進行了理論和實驗研究，在柚子型光敏微結構光纖上成功寫制了布拉格光柵，觀察到多波長的反射峰，並利用全矢量有限元方法對微結構光纖布拉格光柵中的多波長諧振現象進行了理論分析，最後在實驗上對其在多參量傳感和多波長光纖激光器件中的應用進行了嘗試。
  3. Instead of using an adhesive bond strain gauge, laser spots are used to achieve an atomic bond between the deformation body and measuring cell

    使用激光點焊代替膠結技術應變測量儀來實現變形體和測量元件的原子連接。
  4. A theoretical and experimental study of a new, efficient technique to couple a laser, emitting a highly elliptical beam, to a single - mode fiber without the use of bulk optical components is presented. the technique involves butt coupling the laser to a cylindrical lensed fiber and spherical lensed fiber

    本文從理論上和實驗上呈現了一個實用的耦合技術，即在沒有使用分立球形光學元件的情況下將高度橢圓化的激光光束通過透鏡光纖耦合到單模光纖中。
  5. The laser unit, because of its monochromaticity and small divergency, is used as sensor ’ s light source. devices and chips provided with high - speed responsing and processing capabilities are employed. as a result, the achieved uncertainty of time measuring is 125 ps, demonstrating an accuracy improvement in magnitude of an order

    在設計製作中採用了單色性和方向性好的激光作為光源，選取了高速響應和有高速處理能力的一系列器件、晶元，因此時間測量的精度達到了125ps ，比以往的測試方法提高了1個數量級以上，速度測量精度達到掃描速度的0 . 1 % 。
  6. Zno film is a novel - direct compound semiconductor with wide band gap energy of 3. 37ev and a exciton binding energy 60mev at room temperature. due to its the prerequisite for visible or ultraviolet light emission at room temperature, it has the tremendous potential applications for ultraviolet detectors, leds, lds. zno thin film is used widely and effectively in the fields of surface acoustic wave devices, solar cell, gas sensors, varistors and so on because of its excellent piezoelectrical performance

    室溫下禁帶寬度為3 . 37ev ，激子束縛能為60mev ，具備了室溫下發射紫外光的必要條件，在紫外探測器、 led 、 ld等領域有著巨大的發展潛力； zno薄膜以其優良的壓電性能、透明導電性能等使其在太陽能電池、壓電器件、表面聲波器件、氣敏元件等諸多領域得到廣泛應用。
  7. Especially in high power laser applications, absorption can cause thermal distortion to optical components, then change the transmission characteristics of the incident beam, and also lower the laser induced damage thresholds ( lidt )

    尤其在高功率激光作用下，吸收損耗不僅會引起光學薄膜元件的熱畸變，影響激光傳輸特性，還會降低薄膜的損傷閾值。
  8. In this experiment, a neodymium glass laser is used to study the effects of the operating voltage, power density, the height from the observed location of the plasma to the surface of the sample, the location of the sample, the gas composition and the pressure on the intensity and quality of the spectrum

    本文採用高能量釹玻璃激光器，研究了激光器工作電壓、功率密度、等離子體的觀測高度、樣品位置、環境氣體及氣壓對等離子體的譜線強度及譜線質量的影響，獲得了最佳的實驗條件，並測量了金屬分析樣品中某些元素的含量。
  9. This product adopts oem pressure transducer with stainless steel isolation diaphragm as signal measure element and automatic testing by the computer. using laser adjustment resistant technology carries on temperature compensation to zero point and sensibility in width temperature scope

    該產品採用帶不銹鋼隔離膜片的oem壓力傳感器作為信號測量元件並經過計算機自動測試，用激光調阻工藝進行了寬溫度范圍的零點和靈敏度溫度補償。
  10. Polarization characteristics of laser beam, which is one of the important characteristics of high power laser, have a direct effect on output power, damage threshold of optical elements and beam quality etc. the polarization characteristics in the high power coil resonator is analyzed by jones calculus, and draw a conclusion that, in general the eigen - polarization state is elliptical polarization

    激光光束的偏振特性是高功率激光器的一個重要特性之一，直接影響著高功率激光器的輸出功率、腔內光學元件的損傷以及光束質量等。本文首先利用瓊斯矩陣演算法對高功率氧碘激光器腔內的偏振特性進行了分析，並得出結論，諧振腔內的本徵振蕩一般為橢圓偏振。
  11. In this paper, a simple and practical circuit for laser diode modulation is presented, the principle circuit and the principle of choosing component are given, at last, application in sine wave modulation in non - cooperative target phase shift laser rangefinder is introduced

    本文介紹了一種簡單有效的半導體激光器調制電路，給出了電路原理圖，元件的選擇原則，最後介紹了在非合作目標相位式激光測距系統中實現正弦調制的應用。
  12. Due to the advantages such as short response time, easy operation, and convenient to comprehend the wavefront modes, the hartmann wavefront sensor ( h - wfs ) is widely utilized nowadays in real - time adaptive optics system, turbulence statistical characterization, optical components test, light quality evaluation, laser atmosphere communication, the wavefront correction of ultrahigh power laser pulses, as well as human eye aberrations measurement. the detection accuracy is important to the performance of the whole optical system. considerable efforts have been performed in the investigation of h - wfs wavefront detection techniques in past years

    哈特曼波前傳感器具有實時探測，易操作，可以直觀顯示波前畸變分佈等優點，被廣泛地用作自適應光學系統的波前信息探測和波前畸變補償，大氣湍流統計特性表徵，光學元件檢測，光束質量評價，超強激光脈沖波前整形，激光大氣通信以及人眼象差測量等各個領域之中，其探測精度的高低對整個光學系統的工作性能有著極其重要的影響。
  13. Scratches on optical component surface and its ' modulation on injecting laser

    光學元件的表面劃痕及其對入射激光的調製作用
  14. 3. a raytrace model of both co - axis and non - axis beam propagations for high - power solid - state laser systems has been set up and simulations on shots have been conducted to get the spot distribution at target point. according to the requirement of system design and theory of mathematic statistics, the dispersion circle and frequency distribution, which optimize the stability allocation of optical components, have been presented

    3 、建立了共軸與非共軸相結合的光線追跡模型，通過對大型固體激光裝置打靶的模擬模擬，獲取光束在靶點處的彈著點分佈，依據總體設計要求，運用數理統計原理，採用彌散圓和頻率分佈方法對彈著點分佈進行分析，優化光學元件穩定性分配指標。
  15. When the laser facilities are in operation, the position and direction of all the beams are subject to change due to the optical structural drifts excited by multiple input sources. these changes will influence the precision of the beam propagation and finally the focal spot positions on targets which are strictly dictated by the requirements of plasma physics experiments

    這些激光裝置在運行過程中，光學元件結構在外界激勵因素作用下容易產生漂移，使光束位置和方向發生改變，影響光束打靶定位精度，無法滿足精密物理實驗要求。
  16. The structure and character of deformable mirror were analyzed, and the conflict between the deformation band and the pitch of deformable cells was pointed out. the " two - time compensation " wave - front correct mode was introduced to settle that conflict. the method for allocating wave - front aberration and designing static corrector was found, and the " two - time compensation " wave - front correct mode was validated by simulation

    分析了變形鏡的結構特點，初步給出了變形鏡本身驅動單元數與校正量之間的制約關系；引入「二次補償」波前校正方案，解決了變形鏡校正量有限與高功率固體激光系統波前誤差起伏量大的矛盾，建立了波前校正對象優化分配、靜態校正器優化設計等細節過程所需要的方法，通過模擬模擬驗證了「二次補償」波前校正方案對于降低變形鏡校正量要求和放寬光學元件加工精度的作用； 5
  17. Laser direct writing ( ldw ) is an advanced fabrication technique for < wp = 5 > diffractive optical elements ( doe ' s ). so far the level of fabricating by ldw technique is too low to satisfy the demands of the application in china

    激光直寫是衍射光學元件的一種先進製作技術，國內激光直寫製作技術的水平遠沒有達到實際應用的要求。
  18. Laser direct writing ( ldw ) is an advanced fabrication technique for diffractive optical elements ( does ). ldw equipment adopting laser direct writing technique is substance foundation for researching and manufacturing does

    激光直寫是衍射光學元件的一種先進製作技術，激光直寫設備是採用激光直寫技術製作衍射光學元件並開展其研究的物質基礎。
  19. 5. the excitation sources that can cause motion of the optical elements and its relations are studied and analyzed. based on stability of optical component, the stability allocation theory and methodology for accounting for excitations are presented

    5 、分析和確立了影響光學元件穩定性的激勵源及其相互關系，並基於光學元件穩定性指標要求，探討了激勵源穩定性指標分配所採用的理論和方法，為系統分析和研究大型固體激光裝置光學元件穩定性提供了理論基礎。
  20. The main work of this dissertation focuses on the analysis and design theory for a resonator with diffraction optical elements by using a matrix eigenvalue method. the principle and method how to realize a low diffraction beam have been described. both the experimental and theoretical results show that the low diffraction beam has great advantages over the gaussian beam in an ablation - dominated material removal processes

    本文的重點是：闡述了利用矩陣本徵值方法分析和設計激光諧振腔的系統理論；簡述了產生和實現低衍射光束的原理和方法，實驗發現了低衍射光束比高斯光束所具有的獨特性能；理論設計和研製了衍射光學元件，並通過實驗獲得空心激光光束，提出了對不同空心光束的描述方法。
分享友人
分享到 Line

分享到臉書