激勵控制器 的英文怎麼說

中文拼音 [jīlìkòngzhìqì]
激勵控制器 英文
excitation controller
  • 激 : Ⅰ動詞1 （水因受到阻礙或震蕩而向上涌） swash; surge; dash 2 （冷水突然刺激身體使得病） fall ill fr...
  • 勵 : Ⅰ動 （勸勉） encourage; exert oneself Ⅱ名詞（姓氏） a surname
  • 控 : 動詞1 （告發;控告） accuse; charge 2 （控制） control; dominate 3 （使容器口兒朝下 讓裏面的液體慢...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 激勵 : 1 （激發鼓勵） encourage; impel; urge; inspire; excite; stimulate; put one on one s mettle 2 [電...
  • 控制器 : controller; regulator; monitor; pilot; keyer; manipulator; control unit; control device; [自動化]...
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  1. A 2dof vehicle structure model with mr damper is established, a sliding model controller is designed, and the real - time control damping force of suspension system is educed

    摘要建立了履帶車輛1 / 2車體振動模型，設計了相應的滑移面和滑移模態控制器，得出了履帶車輛半主動懸掛系統的實時控制阻尼力，並對路面激勵下滑模控制與最優控制的減振效果進行了模擬。
  2. Rf over voltage protection, laser over heat protection, automatic power control and automatic temperature control to ensure the reliability and stability

    射頻過激勵保護激光器過熱關斷保護，自動功率控制，自動溫度控制，確保光發射機工作性
  3. Investigation on low - speed vector control of adjacent synthetic jet actuators

    相鄰合成射流激勵器低速射流矢量控制研究
  4. The paper synoptically and comprehensively introduces eddy current theory, equivalent circuit, excitation coils, test circuit and application of the eddy - current sensors. a feasible solution of motor core height control based on silicon steel sheet thickness measuring with double eddy - current sensors is presented

    論文在系統全面的分析了電渦流傳感器的基本原理、等效電路、激勵線圈、測量電路及應用后，提出將雙探頭測厚系統應用於電機鐵芯疊控制。
  5. The paper on the basis of the study on the control of the changing slope curve paving in theory, through the study on the responses of the screed to different input signal in condition of the erected string, the controller of the transverse gradient and the floating beam on the spot experimentations, and through the analyzes the three paving design method in theory and the experimentation, on through the analyzes the three paying design method in theory and the experimentation data, provides some material solving measures to solve the changing slope curve paving

    摘要根據彎道變坡攤鋪控制特性的理論研究，在工程實際中採用掛線法、橫坡控制器和浮動均衡梁進行了不同輸入激勵函數下熨平板響應的試驗研究，並通過對這3種攤鋪設計方法的理論和試驗數據的分析，提出了解決彎道變坡攤鋪的具體措施。
  6. The governing equations were derived for laminated plates incorporating shear - mode piezoelectric actuators from hamilton ' s principle

    採用哈密頓原理導出帶剪切型壓電激勵器的層合板的控制方程。
  7. Currently, the large space vehicle ’ s vibration test usually adopted dual - shaker system, the electric current phase synchronous controller is one of the equipments importantly in the system. the existing control equipments make use of tri - tek704d controller, and the current feedback in - phase control method

    目前，我國大型航天器環境振動試驗採用多振動臺同步激勵的試驗系統來完成，電流相位/幅值同步控制器是並聯雙振動臺同步控制系統中重要的組成設備之一。
  8. Through analyse, the thermal prompting source of infrared bulbs was improved on. the time controller can control the loading time, which was one components of the device of infrared bulbs. the improved thermal prompting source can fit the change fo size of object

    通過分析，對紅外燈的熱激勵源進行了改進，使其由時間控制器控制加載時間，使其能滿足試件大小要求，形成空間梯度小，時間梯度大的均勻溫度場分佈。
  9. We apply fuzzy control theory to active control over engine body vibration, design fuzzy control system which combines intelligent control with feedback control. this control strategy mends the flaw of complexity, nonlinear and uncertainty when we use traditional control method. by measuring rotate speed and vibration speed of i. c

    在主動控制的基礎上，採用了模糊控制的演算法，設計了內燃機整機振動模糊控制器，改進了傳統控制方法在處理振動復雜性、非線性和不確定性等方面的缺陷，通過測量內燃機轉速和內燃機整機振動速度信號，動態地改變動力減振器的剛度，使減振器的固有頻率跟隨內燃機整機振動激勵頻率的變化，達到降低內燃機振動的目的。
  10. This paper proposes a novel tracking control approach for nonholonomic mobile robots by integrating the neural dynamics model into the backstepping technique, and an adaptive parameter model is utilized to implement robust tracking

    摘要提出了一種針對非完整移動機器人軌跡跟蹤控制的新方法；該方法將神經動力學生物激勵模型集成到後退控制方法中，同時採用自適應參數模型來實現具有魯棒性的跟蹤控制。
  11. Based on giant magnetostrictive actuator, does a experiment of active vibration control about direct disturb, and the results show that the giant magnetostrictive actuator can satisfy the need of active vibration control

    在上述基礎上對直接激勵干擾下的系統振動進行了控制以及對系統階躍激勵的控制，結果顯示此超磁致伸縮執行器可以達到進行主動振動控制的要求。
  12. Its premise is pci bus specification and its sticking point is to analysis the function and architecture of pci bus controller. this dissertation finishes the design of pci bus controller, and it has also completed the function simulation of this module as well as timing simulation and a pcb card for test which prove it rightness at last

    通過本論文的研究，完成了pci總線控制器的設計，並且通過編寫測試激勵程序完成了總線控制器功能模擬，以及布局布線后的時序模擬，並設計了pcb實驗板進行了測試，證明所實現的pci目標控制器完成了要求的功能。
  13. Secondly, methods of improving on probe are investigated in detail : using the electromagnetic shielding effect to decay the direct - coupled magnetic field and using the dual probe to control the energy flow, so as to make the probe to be shorter ; designing 3 - d pick - up coil array to increase detection sensitivity. at last, experiment system is set up to verify the simulation result and the comparing result shows simulation result agrees with experiment result

    其次，對改進傳感器性能的幾種方法進行了詳細研究:利用電磁屏蔽效應以衰減在直接路徑上的磁場傳播、採用復式探頭激勵方式以實現能流控制，從而減小傳感器體積，模擬證實這兩種改進方案有效;設計三維周向檢測線圈陣列以提高缺陷檢測靈敏度，模擬結果證實三維探頭的周向靈敏性。
  14. ( 3 ) for a kind of general discrete nonlinear system, a new scheme of fuzzy adaptive controller with globally stability is proposed, based on new parameter adaptive law of the system. owing to no need of the assumptions " x falling in a compact set " or " the base function being persistence excitation " which are difficult to be gotten and verified in reality, this result precedes the former research work

    （ 3 ）本文在沒有通常採用的，但在實際中難以獲得和驗證的「 f （ x ）的定義域在緊集中」或「模糊基函數滿足持續激勵」條件下，針對一類一般的離散非線性系統，基於新的系統參數自適應律，給出了一種離散系統自適應模糊控制器的設計方法，證明了演算法的全局穩定性
  15. In order to avoid the turbulence caused by various forms of excitation fell under the operating course, a kind of robust track controller was designed, thus ensured the consistent final value of the tracing error to be bounded

    為避免運行過程中受到的各種激勵形式造成的擾動，設計了一種魯棒軌跡控制器，保證了跟蹤誤差的一致終值有界。
  16. It is revealed that the control commands from the filter are composed of a sequence of ramp signals, whose time - ratio of variation never exceeds the permissible value to restrain the excitation to un - modeled harmonic modes

    研究結果表明，該濾波器形成的控制信號是一系列的斜坡信號，對時間的變化率不超過允許的最大沖擊值，從而降低了未建模動態激勵。
  17. And the technology can also control the vector of a primary jet, the ratio of momentum between the synthetic jet and the primary jet is a main influence factor, and the vectoring control of primary jet is also effected deeply by the position and the frequency of actuators

    應用合成射流技術可以有效控制宏觀低速流流動方向，其控制強度由宏國防科學技術大學研究生院學位論文觀流動與合成射流的動量比決定，而合成射流激勵器的工作頻率以其布置位置對主流的控制效果影響很大。
  18. ( 4 ) the potential applications of the synthetic jet technology are studied. it shows that the synthetic jet actuators can significantly enhance fuel / oxygen mixing and heat transfer, and the synthetic jet actuators " working condition determines the controlling efficiency

    （ 4 ）主要工作之二是探討了合成射流技術的潛在應用，應用合成射流控制技術，可以大大提高低速燃氣氧氣的摻混程度以及加強換熱，合成射流的控制效果與激勵器的工作情況密切相關。
  19. This dissertation finishes the design of pci bus target controller, with vhdl description of register transfers level. and it has also completed the function simulation as well as timing simulation after placing & routing. a fpga on pcb board is designed to test the target controller and the result of test meets basal function demand

    本論文完成了pci總線目標設備控制器的設計，採用vhdl對其進行了rtl級的描述，並且通過編寫測試激勵程序完成了功能模擬，以及布局布線后的時序模擬，通過fpga在pcb實驗板上進行硬體模擬，證明所實現的pci目標設備控制器符合基本功能要求。
  20. As the key part of synthetic jet technology, the synthetic jet actuator can work without fluid feeding and has momentum flux but no mass flux. since it only needs electricity when works, it can be controlled easily

    合成射流激勵器作為該技術的關鍵工作部件，具有無需流體輸送，凈質量流量為零，動量不為零的特點，而且合成射流激勵器工作時只需要電能，易於實現電參數控制。
分享友人
分享到 Line

分享到臉書