濕塗膜 的英文怎麼說

中文拼音 [shītúmó]
濕塗膜 英文
wet coating
  • 濕 : Ⅰ形容詞（沾了水的或顯出含水分多的） wet; damp; humid Ⅱ名詞（姓氏） a surname
  • 塗 : Ⅰ動詞1 （抹） spread on; apply; smear 2 （亂寫或亂畫） scrawl; scribble 3 （抹去） cross [blot; s...
  • 膜 : 名詞1. [生物學] （像薄皮的組織） membrane 2. （像膜的薄皮） film; thin coating
  1. Best concentration of ions is 1. 5mol / l and dispersant pvp monomer 0. 8mol / l. spin - coating speed, which affected the quality of limn2o4 film greatly, was also studied. it demonstrated that smooth limn2o4 film without cracks could formed under 2000 rotates / min with the solution cion = 1. 5mol / l, cpvp = 0. 8mol / l, what ’ s more, fewest spin - coating times were needed at that speed

    實驗結果表明:採用離子總濃度溶液為1 . 5mol / l ，聚乙烯吡咯烷酮單元濃度為0 . 8mol / l的溶液旋轉塗覆時，轉速在2000轉/分鐘時最佳，所得到的濕limn204薄膜平整光滑均勻，加熱后無龜裂現象。
  2. According to the feature that deformation resulted from water absorption and mildew appear mainly on the rabbet surface of ccf, this paper adopts rsst to spray a special waterproof sealant on rabbet surface of ccf, so that the sealant can get into fiberboard to certain extent by means of capillarity and penetration, blockage the holes between fibers and capillary, cut up passage of water and change the properties of soakage and sorption to water in capillarity and fiber. at the same time, solidified sealant can form a compact waterproof pellicle on rabbet surface so as to prevent water and humidity from fiber ' s expansion and mildewing

    針對吸水變形、霉變主要發生在地板企口表面的特徵，採用企口表面全封閉法，在復合強化地板企口表面噴塗特殊的防水封閉劑，使其依靠毛細管作用及滲透作用進入板內一定深度，堵塞木纖維之間的空隙及毛細孔通道，截斷水分傳遞的渠道，並改變毛細孔壁及纖維的表面性質以不利於水的浸潤與吸附，同時其固化后能在企口表面形成一層緻密的憎水薄膜，防止水分、濕氣從企口侵入板內引起木纖維膨脹變形、發霉等現象。
  3. As a mask : smooth thin layer onto damp, clean skin. leave on for 5 - 7 minutes. remove with tepid or warm water

    作面膜之用：薄薄的塗于清潔濕潤的皮膚上，待5至7分鐘，再用溫水洗凈。
  4. The target determines the precision, reliability, stability and tcr of the resistor. on the other hand, the coatings play an important role in improving the heat - resistance and moisture - resistance of the resistor. however, nowadays the study in this field is some deficient in our country

    此外，金屬膜電阻器的耐熱、耐濕、耐腐蝕性能還直接與金屬膜電阻器表面的保護塗料的性能密切相關，而目前國產的塗料在耐高溫、耐高濕方面還達不到國家軍標的要求。
  5. Test methods for measurement of wet film thickness of organic coatings

    有機塗層濕膜厚度的測試方法
  6. Testing methods for paints - part 7 : long - period performance of film - section 4 : humidity and cool - heat cycling test

    塗料試驗方法:第7部分:膜的長效性.第4節:潮濕和冷熱循環試驗
  7. 1 testing methods for paints - part 7 : long - period performance of film - section 4 : humidity and cool - heat cycling test erratum 1

    塗料試驗方法.第7部分:薄膜的長效性.第4節:潮濕和冷熱循環試驗
  8. Testing methods for paints - part 7 : long - period performance of film - section 2 : resistance to humidity continuous condensation erratum 1

    塗料試驗方法.第7部分:薄膜的長效性.第2節:耐潮濕性能
  9. Testing methods for paints - part 7 : long - period performance of film - section 3 : resistance to humidity intermittent condensation erratum 1

    塗料試驗方法.第7部分:薄膜的長效性.第3節:耐濕性能
  10. Methods of test for paints - tests associated with paint film formation - wet edge time

    塗料試驗方法.塗料膜形成試驗.濕邊時間
  11. The wet layer of film shall be immediately measured with a wet film thickness gauge after the paint is applied

    在塗裝結束后，應立即用濕膜計對濕膜進行厚度測量。
  12. Firstly, choose an appropriate solution system to make a steady solution, and then limn2o4 film precursor was prepared on stainless steel by spin coating method with the solution

    在前驅體溶液體系選擇過程中，確定了最佳前驅體溶液體系組成;在最佳的前驅體溶液組成體系下，採用旋轉塗覆法在不銹鋼基體上制備前驅體濕膜。
  13. Methods of test for paint - durability tests on paint films - determination of resistance to cyclic corrosion conditions - wet salt fog dry humidity uv light - part f19 : determination of resistance to cyclic corrosion conditions - wet salt fog dry humidity uv light

    塗料的試驗方法.漆膜的耐久性試驗.耐循環腐蝕條件的確定.濕的
  14. Potent disinfectant and anti - bacterial active ingredients including bee propolis, tea tree and lavender oil reduce inflammation and infection in several days rather than weeks, even in cases of deep boils and break - outs. this treatment helps to clear blemishes and acne break - outs when applied twice daily on the blemish directly

    首先潔臉，用花水保濕，再塗上面膜，不要敷在眼袋位置，待15 - 20分鐘后，用微溫水洗面，抹乾，塗上合適的潤膚霜。
  15. The paper studied the effects of various ingredients such as film - former, preservatives, moisture - retaining agent and anti - oxidant in the emulsion system on strawberry preservation by edible coatings

    摘要本論文主要研究在乳狀液體系中各種塗膜保鮮成分如成膜劑、保鮮劑、保濕劑和抗氧化劑等對草莓進行塗膜保鮮效果的影響。
  16. A 0. 85um - or 1. 3um - led - lighted fiber optic humidity sensor based on a film of 40 ~ 100nm in thickness self - assembled on the end face of the fiber can work in the range of 1 ~ 100 % rh with a response time less than 1s. this novel humidity sensor can be used for monitoring human breathing - conditions. organic molecules including congo red, a derivative of copper phthalocyanine and a fullerol were self - assembled with polymers into multilayer thin films, and organic molecules with more than 4 charged groups exhibited satisfactory features for multilayer self - assembling

    聚電解質pdda -聚染料ps - 119體系具有很好的自組裝性，多層復合膜無明確的層狀結構特徵，在宏觀上表現出單層光學塗層的特性，單層膜的厚度在納米量級且與聚電解質水溶液的濃度有關；薄膜具有濕敏特性，在光纖端面上組裝厚度為40 100nm的薄膜，採用0 . 85 m或1 . 3 m的led光源，可以製成光纖濕度傳感器，傳感器的工作區間為0 100 rh ，響應時間1s ，可以用於對人的呼吸監測。
  17. Methods of test for paint. durability tests on paint films. determination of wet - scrub resistance and cleanability of coatings

    塗料試驗方法.第f節：塗料膜的耐久性試驗.第17部分：塗層耐濕刮和清潔度的測定
  18. Paints. determination of wet film thickness

    塗料.濕性薄膜厚度的測定
  19. If the required paint film thickness has not been achieved, the additional coats should be applied till the specified thickness is attained

    如果未達到要求的濕膜厚度，應覆塗直到滿足指定的濕膜厚。
分享友人
分享到 Line

分享到臉書