濕度元件 的英文怎麼說

中文拼音 [shīdùyuánjiàn]
濕度元件 英文
humidity element
  • 濕 : Ⅰ形容詞（沾了水的或顯出含水分多的） wet; damp; humid Ⅱ名詞（姓氏） a surname
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 件 : Ⅰ量詞（用於個體事物） piece; article; item Ⅱ名詞1. （指可以一一計算的事物） 2. （文件） letter; correspondence; paper; document
  • 濕度 : humidity; dampness
  1. Second, the starting and stopping behaviors under disturbed condition are analyzed and calculated by using the dynamic concentrative parameter model, which gives some advice to better prescribe refrigeration system and set theoretic foundation for carrying out automatic control of refrigeration system. third, the normal running process is analyzed and calculated by means of rational matching theory, which gives some advice on how to better understand the parameter change under steady state and the affection of inlet - parameter on evaporator. fourth, the simulation software with dynamic characteristic is designed, which can be applied to calculate thernio - parameter of cryogen, air humidity and frost thickness under different initial and boundary conditions, and to carry out dynamic simulation under conditions of dryness, wetness and frostiness, at the same time, to achieve detection and simulation at any stage from starting to stopping

    本文的主要內容如下： 1 ）對翅片管蒸發器結構特點進行分析，選取適當的微元控制體，就干、濕和霜工況下對每個微元分別進行傳熱傳質分析，基於經驗關系式確定霜的有關參數，對于霜工況下的霜生長建立模型，經適當假設，運用質量守恆、能量守恆和動量守恆方程建立適合動態模擬的蒸發器數學模型，為系統模擬奠定基礎； 2 ）對蒸發在大擾動下的開、停機過程，運用動態集中參數模型進行分析和計算，為更好地描述製冷系統運行的全過程奠定基礎，同時也為製冷系統實現自動控制提供一定的理論基礎； 3 ）對蒸發器正常運行過程，運用動態分佈參數和參數間定量耦合的觀點來分析和計算，為更好地了解穩態工況下各點參數的變化情況及各入口參數對蒸發器動態特性的影響即蒸發器性能對各參數變化的敏感性； 4 ）編寫翅片管蒸發器動態特性模擬計算程序，可以計算不同邊界條件和初始條件下的製冷劑熱力參數、空氣溫濕度和霜厚度分佈場，實現對翅片管蒸發器在干、濕和霜工況下的動態模擬。
  2. Pressure sensor and hygrothermograph sensor are adopted respectively to sense these change ; a plc and its analogue cell are adopted to collect and analysis the data ; a mcgs component software is used to process and store the data in real time

    給出了以壓力、流量和溫濕度傳感器為測量元件、以plc為主控制器、 plc模擬單元為數據轉換單元的詳細硬體設計、程序設計和組態軟體mcgs在上位機的運用。
  3. 4 - vp - co - buma quaternized with octyl bromide were found to be humi - sensitive material with good linearity, high sensitivity, fast response, high stability at high humidities

    以溴代正辛烷季胺化4vp - co - nbuma為濕敏材料，制備濕敏元件，其具有響應線性度好、靈敏度高、響應快、高濕穩定性好等優點。
  4. Simultaneously cross - linked and quaternized 4 - vp - co - nbuma was also investigated as humidity sensing materials and showed good linearity, high sensitivity, good high stability at high humidity and high temperature, and durability to organic solvent, etc. sensors based on 4vp - co - buma ( vp / buma = l / l ) with crosslinking and quaternization reaction of 17 hours exhibited a change of three orders of magnitude ( 104 ~ 107 ) in impedance over the range of 95 % rh ~ 30 % rh, showing high sensitivity, and little hysteresis was observed

    元件具有響應線性度好，靈敏度高，濕滯小、高溫高濕穩定性好、耐無水乙醇有機溶劑性能好等優點。其中，交聯季胺化17小時配料比為1 1共聚物濕敏元件，在33 rh 95 rh濕度范圍內，阻抗變化達3個數量級（ 10 ~ 7 - 10 ~ 4 ） ，響應靈敏度高，幾乎無濕滯。
  5. Smart materials and structure have definite requirements of sensor components and driving components, for example, they can adhere well to the matrix and have higher strength, fatigue strength, more broad scope of frequency response and faster response speed, etc. piezodielectric ceramics have characteristic of easily preparing, heat - resistance, wet - resistance, high strength and broad scope of frequency response, etc. furthermore, it has piezoelectric effect and inverse piezoelectric effect, namely it can produce electric potential energy when it is transformed by mechanical strength and its mechanical dimension can be transformed when voltage is put on it

    壓電陶瓷能與基體材料很好結合，具有制備容易、耐熱、耐濕、強度高、頻響寬等特點，另外它具有正壓電效應和逆壓電效應，即當它受到機械力變形時，能產生電勢，對它施加電壓時，能改變其機械尺寸，因此它在智能材料結構中既能用作傳感元件又能用作驅動元件。
  6. The humidity sensitive characteristics of these sensors prepared by means of self - assembly have been investigated and the effects of electrode structures, concentration of humi - sensing solution, number of bilayers, materials of the outer layer and inner layer on humidity response were discussed

    測試了不同體系濕敏膜的感濕特性，探討了電極結構、感濕液濃度、離子強度除閂電翻動復合膜層數、最外層材料、最內層材料等因素對濕敏元件響應特性的影響。
  7. Data on pressure, temperature and humidity measured by sensors of the radiosonde were transmitted to the ground station using radiowave

    無線電探空儀將感應元件量度到的氣壓、氣溫及濕度數據用無線電波送回地面站。
  8. Measurements of pressure, temperature and humidity taken by sensors on the radiosonde were transmitted to the ground station by radiowave

    無線電探空儀將感應元件量度到的氣壓氣溫及濕度數據，用無線電波送回地面站。
  9. Air temperature, dew point and relative humidity : digital thermometers with platinum resistance sensors have been used since 1982. mercury - in - glass thermometers are used for back - up purposes

    氣溫露點及相對濕度：天文臺自一九八二年開始使用配備白金電阻感應元件的數字溫度表，水銀溫度表則用作后備。
  10. 3. with time series simulation software, the cpu ’ s i / o ports simulate i2c bus and exchange data with clock chips, temperature humidity sensors, memory chips and other devices

    3 、採用軟體模擬時序使cpu的i / o口模擬i2c總線，實現了單片機與時鐘晶元、溫濕度傳感器、存儲晶元等器件的數據交換。
  11. The optimal aging conditions for the sensors investigated are : u 200 mv, f1 khz, t24 - 48 h, rh 81 - 87 %, t 3 80c ii the sensing mechanism of the humidity sensors has been explored by means of complex impedance analysis

    合適的老化條件為：施加電壓200mv ， 1khz ， 24 48h ， 38 ， 81 87 rh 。採用復阻抗譜分析法，研究元件感濕機理，認為napss濕敏元件感濕機理為離子導電，其電導隨濕度的變化可由改進的onsager方程描述。
  12. Humidity test procedure for fiber optic components

    光纖元部件的濕度試驗程序
  13. It was found that self - assembly films of napss / pdda showed low impedance, good linearity and high sensitivity. impedance of sensors with 25 bilayers of napss / pdda composite film changed linearly for four orders of magnitude ( 10 - 10 q ) over the range of 20 % rh ~ 95 % rh. furthermore it was found that organic / inorganic nanocomposite films exhibit faster response than organic / organic composites

    發現： napssrpdda體系具有阻抗低、響應線性度好、濕滯小、響應快、靈敏度高等優點，其中雙層數為25的濕敏元件在20 rh95 rh濕度范圍內具有良好的線性響應，阻抗變化近4個數量級』 l 』 q卜靈敏度高。
  14. The humidity sensors so prepared enjoy the advantages of linear response and wider working humidity range, etc. compared with imported commercial sensors

    制得的濕敏元件與國外同類元件相比，具有線性度較好、測濕范圍寬等優點。
  15. It was found that introduction of hydrophobic monomer into polymer chain improved the response linearity and sensitivity, and the impedance of sensors decreased with longer quaternization time and shorter distance between electrode tracks

    發現：疏水性單元的引入，提高了濕敏元件的響應線性度和靈敏度；季胺化時間的延長，使聚合物季胺化程度提高，濕敏元件阻抗減小；電極叉指間距增大，阻抗增大。
  16. Humidity generators and humidity testing methods for humidity sensors

    濕敏元件用濕度發生器和濕度測試方法
  17. That line will vary depending on the particular speaker you use, the music you play, the volume you play it at, the quality and condition of your connections to the speakers, everything mentioned above and a lot that isn ' t - even, believe it or not, factors like wind blowing on the cone of a woofer or the ambient humidity and temperature

    這條線還會不斷變化，它會收到的影響包括你所使用的揚聲器，你正在播放的音樂，你所播放的音量，你的揚聲器連接線的質量和條件，幾乎是所有的上面提到的事情，還有無數上面沒有提到的事情，甚至，信不信由你，包括像吹過低音單元的風，或環境濕度與溫度這些因素。
  18. Sensors based on nanocomposites of meba - co - si with nanosized zinc oxide colloids was prepared, which show smaller impedance, good linearity, small hysteresis ( < 2 % rh ) and fast response ( less than five seconds )

    復合后濕敏元件阻抗減小，響應線性度好，濕滯小（ 2 rh ） ，響應快，耐水性好：浸水（ 30min ）前後響應幾乎不變。
  19. The effect of sensing materials on humidity response of sensors has been investigated. humidity sensor based on na - sam exhibits fast response and small hysteresis, and sensors with high sensitivity, small hysteresis and wide sensing range can be prepared using composite of na - sma and napss

    研究了濕敏材料對元件響應特性的影響，發現na - sma具有響應快，濕滯小的特點，其與napss以一定比例復合，可制得靈敏度高、濕滯小、感濕范圍寬的濕敏元件。
  20. General specification for the capacitance type humidity sensor and transducer

    電容式濕敏元件與濕度傳感器總規范
分享友人
分享到 Line

分享到臉書