焙燒時間 的英文怎麼說

中文拼音 [bèishāoshíjiān]
焙燒時間 英文
roasting time
  • 焙 : 動詞（用微火烘） bake; torrefy; heat over a slow fire
  • 燒 : Ⅰ動詞1 （使東西著火） burn 2 （加熱或接觸某些化學藥品、放射性物質等使物體起變化） cook; bake; hea...
  • 時 : shí］Ⅰ名1 （比較長的一段時間）time; times; days:當時at that time; in those days; 古時 ancient tim...
  • 間 : 間Ⅰ名詞1 （中間） between; among 2 （一定的空間或時間里） with a definite time or space 3 （一間...
  • 時間 : time; hour; 北京時間十九點整19 hours beijing time; 上課時間school hours; 時間與空間 time and spac...
  1. It ' s obtained that ph = 6. 5 is a suited ph value for getting ideal product with good properties. the calcinate temperature is the key factors to transform the precursor to a pure product with spinel structure

    研究了不同的工藝條件如溶液ph值、焙燒溫度、焙燒時間、焙燒方式、 li / mn的比值對產物結構的影響。
  2. The characteristic of different products at different calcinating temperatures and time, ph value of solution, raw materials were investigated. the results show that perfect spinel li4mn5o12 crystals whose size belongs to nanometer can be obtained from the precursor of lithium manganese oxides after being calcinated. it is founded that calcinating temperature has great influence on the crystal structure of li4mn5o12 and the optimized temperature is 500

    結果表明焙燒溫度是影響產物結構性能的最重要的因素，最佳焙燒溫度為500 ，溫度小於200不能形成完整的尖晶石結構，而焙燒溫度超過500產物會發生分解；綜合考慮焙燒時間最佳為8小時；溶液ph值也是影響產物性能的因素之一，實驗證明前驅體合成ph = 9 . 0最佳；另外不同的原料也會影響產物的結構，考察了不同鋰源的影響，選擇li _ 2co _ 3為最佳鋰源。
  3. This first microprocessor - controlled dental oven with an integrated vacuum pump was only on the market for a short time : the fast evolution in the field of electronics led to its replacement

    它是第一代使用微處理機控制的牙科焙燒爐，並帶有集成真空泵，但推向市場的時間很短：電子設備的迅速發展使它很快退役。
  4. The entire firing process with the firing number, program name and probable remaining time is displayed graphically or in a table on the color screen

    整個焙燒進行過程焙燒號碼程序名稱和預計剩餘時間都在彩色屏幕上用圖或表格顯示出來。
  5. Hence we combined coprecipitation method, using zinc carbonate as enclosure dose causing the crystal nucleus can not grow up, zinc titanate acts as phase - transition accelerant, thereby we can obtain rutile nanometer tio2 powder at lower calcining temperature and in briefer calcining time relatively

    因此我們結合共沉澱法，引入碳酸鋅作包覆劑控製品粒長大，利用鈦酸鋅作品型促進劑，在相對較低的焙燒溫度和較短的保溫時間內制得到了金紅石型納米tio _ 2粉體。
  6. The results showed that sequence and way of feeding, reaction temperature, time of aging, stirring speed and drying and calcinations had remarkable influence on the pore structure

    結果表明，加料順序、加料方式、成膠溫度、老化時間、攪拌速率以及乾燥焙燒等因素對孔結構均有明顯影響。
  7. In this paper, concentrated sulfuric acid and titanium dioxide are used to prepare the tios04 solution that test later required under long time heat. the influences of reaction time and reaction temperature to yield of tioso4 are discussed. in the experiment of preparing tio2 powder, reaction temperature, ph values, material ratio, operation way, velocity of feed, calcining heat and time are researched by the principle of nucleation and growth in thermodynamics and kinetics

    在制備tio _ 2粉體實驗中，根據成核生長的熱力學和動力學原理，深入分析了沉澱反應時環境的溫度、 ph值、反應物配比、操作方式、加料速度等因素對ti （ oh ） _ 4粒度的影響，以及焙燒溫度和保溫時間等因素對制得的納米tio _ 2粉體性能的影響，得出了制備銳鈦型納米tio _ 2粉體的優化工藝條件。
  8. The effect of amorphous hydrated ruo _ 2 power production is discussed here, including : selection and ratio of solvent, selection and concentration of precipitator, terminal ph of titration and anneal temperature and time of colloid. research indicated that terminal ph and anneal temperature are the most important influence factors on physical and electrochemical properties of amorphous hydrated ruo _ 2 power

    討論了超細氧化釕粉體的制備影響因素，包括:溶劑選擇和配比、沉澱劑選擇和濃度、滴定終點ph值以及焙燒溫度和時間對氧化釕粉體粒度分佈及電化學的影響，研究表明:沉澱終點ph值以及膠體焙燒溫度對粉體物理和電化學性能影響較大。
  9. The more favorable experiment conditions of preparing anatase nanometer tio2 powder are obtained from a lot of data. preparation technology of rutile nanometer tio2 powder is researched on the base of experiment of anatase nanometer tio2 powder. the influences of enclosure dose ' s quantity, preroasting temperatures phase - transition accelerant ' s quantity and calcining intensity and so on on the properties of inclusion body - zntio3 / ti ( oh ) 4, granule size and properties of rutile nanometer tio2 powder are discussed

    在銳鈦型納米tio _ 2粉體的制備基礎之上，進一步研究了金紅石型納米tio _ 2粉體的制備工藝，探討了包覆劑用量、預焙解溫度、晶型促進劑量及焙燒溫度和保溫時間等因素對znco _ 3 / ti （ oh ） _ 4沉澱包覆體性能、金紅石型納米tio _ 2粉體產品的粒度和性能的影響。
  10. This paper explores mainly the influence of reduction roasting temperature, time and pulverized coal consumption on content of soluble zinc

    本文主要探討還原焙燒溫度、時間和煤粉用量對可溶鋅含量的影響。
  11. Spinel limn2o4 begin to form at 350 with the sintering time of 4 hours because there are one li + and two mn2 + in one precursor molecule. when the sintering temperature is larger than 750, a specific sintering route is designed to avoid the formation of li2mno3 impurities

    前驅體的焙燒溫度和焙燒時間對limn _ 2o _ 4樣品的晶相結構有很大的影響，焙燒溫度高於750時，應採用分段焙燒工藝以防止局部高溫形成li _ 2mno _ 3雜質。
  12. The results show that the a - phase - transformation of pure aach can be completed by heating at 1200 ? for two hours. but under this temperature, the alumina particles will be sintered together, which can lead to the formation of bough - like structures. and these bough - like structure will make the powder difficult to be dispersed

    接著對碳酸鋁銨進行了焙燒實驗，研究了其在升溫過程中的相變行為，結果表明：純aach在1200保溫1 . 5h的情況下才能100轉變為氧化鋁，而在這樣高的溫度下，粒子之間會形成燒結頸，從而使粉體產物在形貌上出現所謂「樹枝狀」結構，給粉體使用時的分散帶來了困難。
  13. Through the synthesis of licoo2 by using non - water dispersant and two - step roasting, influences of microstructures of precursor, the roasting temperature and the reaction time on the electrochemical properties of licoo2 were studied. it indicated that co3o4 with nano - crystalline have very good electrochemical property, and can shorten solid reaction time

    02的制備工藝，考察了不同微結構的co30 ;先驅物，焙燒溫度和焙燒時間等工藝條件對licoo ，電化學性能的影響，其中以納米晶co3o ;制備出的licooz表現出優良電化學性能，且大大縮短了反應時間。
  14. ( 2 ) the affecting factors such as components in precipitation process, the add - on, add on of precipitator, calination temperature and calination time were studied in the preparation process of ceo2 nanoparticles. the tg was used to analyze the processor, the xrd, sem and tem were used to characterize the size of crystal type of products. by a series of designed experiments the interaction between different factors and impacts on the preparation of ceo2 nanoparticles were probed, and the optimum preparation condition was gotten

    （ 2 ）對納米二氧化鈰制備過程中可能的一些影響因素（反應組分的濃度，沉澱劑的加入量，焙燒溫度，焙燒時間等）進行了研究，並通過tg ? dta分析手段對前驅物進行熱重分析；用xrd 、 sem及tem等測試手段對產物的粒度和晶型進行分析；探索了各個因素對納米二氧化鈰制備的影響及各因素間的交互作用；確定了在該試驗條件下制備納米二氧化鈰比較優化的制備條件。
  15. Allows you to program firing and pressing cycles in any sequence without time limits

    允許以任意順序，沒有時間限制地編寫焙燒和壓制循環程序。
分享友人
分享到 Line

分享到臉書