無極運輸機 的英文怎麼說

中文拼音 [wújíyùnshūjī]
無極運輸機 英文
endless conveyer
  • 無 : 無Ⅰ動詞（沒有） not have; there is not; be without Ⅱ名詞1 （沒有） nothing; nil 2 （姓氏） a surn...
  • 極 : i 名詞1 （頂點; 盡頭） the utmost point; extreme 2 （地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • 運 : Ⅰ動詞1 （物體位置不斷變化） move; revolve 2 （搬運; 運輸） carry; transport 3 （運用） use; wield...
  • 輸 : Ⅰ動詞1 （運輸; 運送） transport; convey 2 [書面語] （捐獻） contribute money; donate 3 （失敗） l...
  • 機 : machineengine
  • 無極 : g288
  • 運輸機 : transport plane; transport; airfreighter; conveyor; transport airplane; transport aircraft; carrier
  • 運輸 : transport; carriage; conveyance; traffic; transportation
  1. First of all, we bring forward the basic project of tadil, which adapts to combined operations. it is suggested to use tdma ( the abbreviation of time division multiple access ) as the working pattern and utilize the concept of mobile ad hoc network to construct the data link network. aiming at the impact of time delay on data link and the characteristic of cooperative combat under the command of director aircraft, this thesis applies a kind of kalman filtering algorithm in polar coordinates to compensate the error of time delay, and then does the transformation of target motion parameters to obtain the current information of target

    本文結合空軍裝備部某「十五」預研課題，圍繞著戰術數據鏈、多機協同多目標攻擊、超機動攻擊、空對地攻擊這四個方面展開了一系列的研究工作:本文首先給出了適應三軍聯合作戰的戰術數據鏈系統的基本方案，建議採用時分多址的工作模式，並利用移動自組織網路的概念構建數據鏈網路，同時針對數據鏈傳輸信息的時間延遲特性和指揮機指揮下的多機協同作戰特點，應用一種極坐標系下的卡爾曼濾波演算法對該傳輸延遲誤差進行補償，並在此基礎上進行目標運動參數的轉換，以獲得目標相對于某無人機的當前運動信息，且利用模擬驗證了方法的有效性。
  2. Their goal is to have an unmanned aircraft that can be crumpled down and carried or stored in small spaces

    他們的目標是製造出可收摺運輸，或是儲存在極小空間的無人飛機。
  3. The system will use electrodes embedded in a skullcap worn by the patient to transmit messages from the brain to a computer which passes them on to the chair through a wireless link

    電力中斷使得列車無法運行。該系統將採用植入病人所戴無邊便帽的電極把大腦信息傳遞給計算機，然後通過無線傳輸給輪椅。
  4. Furthermore, it was the first time to make a systemic analysis and study to the motion rule and affected factors of this kind of transformer. with the applications of relative polar method and equal view angle method, the transformer that satisfies the requirement of transmission rate and output motion is synthesized. thus, an original non - frictional stepless speed regulator with a 1. 5kw input power, a 1500 rotation speed, a constant150output rotation speed and a maximum 300 output rotation speed was achieved

    在此基礎上利用相對極點法和等視角法按傳動比及輸出運動的要求對轉換器進行了綜合，得出了輸入功率1 . 5kw ，輸入轉速1500 ，額定輸出轉速為150 ，最大輸出轉速300的新型的非摩擦式無級變速器的基本尺寸參數並應用adams軟體對其進行了優化；最後對該非摩擦式無級變速器進行了過約束分析，提出了新型的非摩擦式無級變速器無過約束分析的機構運動副的配置方案。
  5. The paper describes a cw, non - cooling, digital all - solid - stated ld pumped nd : yvo4 driver which adopts microprocessor control, stability power of laser feedback and laser output power about 10mw. the system is composed of constant current source, soft diagram, protection, pulse schematic and laser power feedback loop. by combining appropriate hardware and software, we achieved, in our driver, a variety of protection features including the ability to suppress transients and reduce noise, relay soft and hardware over - current protection and overvoltage shut - off, we have obtained a continuously adjustable laser power output with high accuracy and stability

    介紹一種採用單片機控制的連續運轉無製冷、數字式光反饋穩功率全固態激光器驅動電源，其輸出激光功率在10mw左右，系統包括恆流源、保護電路、脈沖驅動控制、光反饋穩功率控制等部分，結合硬體及軟體實現了激光二極體的可靠保護以及光功率穩定、準確輸出及在穩光輸出情況下，實現激光器的內外調制，並取得了一些有價值的研究成果。
分享友人
分享到 Line

分享到臉書