無水氧化硅 的英文怎麼說

中文拼音 [wúshuǐyǎnghuàguī]
無水氧化硅 英文
anhydrous silica
  • 無 : 無Ⅰ動詞（沒有） not have; there is not; be without Ⅱ名詞1 （沒有） nothing; nil 2 （姓氏） a surn...
  • 水 : 名詞1 （由兩個氫原子和一個氧原子結合而成的液體） water 2 （河流） river 3 （指江、河、湖、海、洋...
  • 氧 : 名詞[化學] （氣體元素） oxygen （o）
  • 硅 : 名詞[化學] silicon （14號元素符號 si）
  • 無水 : [化學] anhydrous
  • 氧化 : [化學] oxidize; oxidate; oxide; burning; rust; oxygenize; oxido-; oxy-
  1. Abstract : researches on unformaldehyde unironing finishing are summarized in this paper. functions and deficiencies of glyoralamido, water soluble heat reactive polyure thane, bishydroxyethyl - sulfoue, natural high precision chitosan, reactive organosilicon, amyloidosis epoxide, multiple carboxyl acid compound are also analyzed and compared

    文摘:綜述了無甲醛免燙整理方面的研究，分析比較了乙二醛-酰胺類整理劑、水溶熱反應性聚氨酯、雙羥乙基碸、天然高聚物殼聚糖、反應性的有機硅、澱粉改性物、環氧類整理劑、多羧酸化合物等無甲醛抗皺整理劑的功能以及各種整理劑存在的不足
  2. Aim of this study was to meet the need for development of tribological parts in pumps. at room temperature tribological properties of different sliding pairs of silicon carbide and alumina - based ceramics were tested using a laboratory tribometer in the ring - on - plate geometry under reciprocating sliding linear contact in different media, such as distilled water, aggressive media and air

    本文針對目前泵用摩擦零部件材料發展的需要，在實驗室摩擦磨損試驗機上研究了按環/塊線接觸方式作往復運動條件下的碳化硅和氧化鋁基陶瓷材料摩擦副在水、化學腐蝕性介質作潤滑劑和無潤滑時室溫下的摩擦磨損特性。
  3. Product this getting wet different silica gel of variety, pouch of packaging completely, main raw materials silica gel one high capillary structure moisture to oxidize silicons 2 times, nonpoisonous, tasteless, has not scented, the chemical property is steady, have strong performance of picking up the moisture

    本品是透濕性小袋包裝的不同品種的硅膠，主要原料硅膠是一種高微孔結構的含水二氧化硅，無毒無味無嗅，化學性質穩定，具強烈的吸濕性能。
  4. It is discovered that the diameters of silicon rubber decrease and the number of silicon rubber increase by the dc electric pre - stress applied during solidifying of silicon rubber - toughened epoxy resins. the effect is independent of the polarity of electric pre - stress, but it is dependent of the intensity of electric pre - stress

    本文通過實驗研究證實：在硅橡膠改性環氧樹脂的固化過程中所施加直流預電應力導致了固化物中硅橡膠相數量增多、尺寸減小；並且，預電應力的這種效應與預電應力的極性無關，但與預電應力的水平有關。
  5. It us possible to raise the modulus of normal low modulus sodium silicate by adding some quantity of amorphous silicon dioxide ( white carbon black ), however the author ' s investigation showed that the quality of the hi - modulus sodium silicate obtained such way is not ideal for casting production

    一般低模數的水玻璃可以通過在其中加入一定量的無定形二氧化硅來提高模數，但研究表明，用這種方法調得的高模數水玻璃質量並不十分理想，在使用上存在很大問題。
分享友人
分享到 Line

分享到臉書