無觸點開關 的英文怎麼說

中文拼音 [wúchùdiǎnkāiguān]
無觸點開關 英文
contactless switch
  • 無 : 無Ⅰ動詞（沒有） not have; there is not; be without Ⅱ名詞1 （沒有） nothing; nil 2 （姓氏） a surn...
  • 觸 : Ⅰ動詞1 （接觸） touch; contact 2 （碰; 撞） strike; hit 3 （觸動） touch 4 （感動） move sb ; sti...
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  • 關 : Ⅰ動詞1 （使開著的物體合攏） close; shut 2 （圈起來） shut in; lock up 3 （倒閉; 歇業） close down...
  1. The main loop of the welder uses a thyratron transistor non - contact switch circuit, quick and reliable close time, accurate timing of welding, high precision of welding, good repeatability, bring a high quality welding

    焊機主迴路採用晶閘管無觸點開關電路，關斷時間快、可靠，焊接定時精確，焊接精度高，重復性好，可實現高品質焊接。
  2. A soli state rely ( ssr ) is an electronc swithig device utilizing discrete semiconductors, integrated circuit and microelectronic technologics to provide electrical isolation and signla coupling between the control circuit and the output circuit without the use of moving part or contacts

    本產品具有體積小、重量輕、靈敏度高、開關速度快、輸出功率大、無觸點抖動、無火花干擾、密封防水防磁防爆、高可靠、長壽命。
  3. In this part, the high - frequency series inverter with resonant pole capacitor is introduced mainly. the current - exchanging processes of the inverter in different working modes are analyzed, how to reduce the switching loss is discussed, and the calculating methods of snubber capacitor c, factor angle switching frequency and pulse width pw are given in optimum switching process. and results of simulation and experiment verify the validity of theoretic analysis

    接著重點研究了含有諧振極無損緩沖電容的逆變器，對其換流過程中的不同工作狀態進行分析，討論了如何減小逆變器的開關損耗，給出了最佳工作狀態下緩沖電容c 、感性角、開關頻率、觸發脈沖的脈寬pw的詳細計算方法，並通過大量的模擬和實驗波形證明了理論分析的正確性。
  4. This paper introduces the operation principle of ac voltage stabilizer and analyzes in detail the existing problems of thyristor used as switching device and proposes the methods for solving these problems

    介紹了所研製的新型無觸點電力穩壓源的基本工作原理，詳細分析了作為開關器件的晶閘管在使用過程中存在的一些問題及解決方法。
  5. Magnetoelectric sensor is a kind of non - contact sensor and has some useful characteristics, such as non - contact, high response frequency, low power waste, high reliability, long life - span and etc

    磁電傳感器是一種非接觸式傳感器，它具有無觸點、無開關瞬態抖動、響應頻率高、低功耗、高可靠性和長壽命等特點。
  6. Djw - wb, sjw - wb series of series of single - phase three - phase micro - computer superpower avr, it gathers advaned combinated roll compensation, no - touch of wsitch, and micro - motor controlhaving special function such as high efficiency, energysaving, quick adjustment, auto - balance of three phase, no machanical breakdown and carbon brush fret. especially, the avantages of timedelay, over - voltage and under - voltage protection absorbs more and more customers

    Wb系列單、三相微電腦無觸點大功率電力穩壓器是集先進的組合繞組補償方式和無觸點開關、微機控制交流穩壓技術於一體，具有高效工能、調節快速、三相自動平衡、無機械故障和碳刷磨損，並具有延時，過壓欠壓報警和保護功能。
  7. Djw - wb 、 sjw - wb series single and three phase & large - power auto compensated voltage regulator, incorporating advanced technology of group winding compensation and mon - contact suitch and micro - computer controling ac regulation, with functions of high effeciancy quick regulating ou - to - balance of three phases no mechanical no mechanical broken down and wear of carbon brush and time delay over and low load warning and protection

    集先進的組合繞組補償方式和無觸點開關、微機控制交流穩壓技術於一體，具有高效節能、調節快速、三相自動平衡、無機械故障和碳刷磨損，並具有延時，過、欠壓報警和保護等功能。
  8. It emphases the selection of secondary voltage of the step - down transformer, the control and protection of thyristor, the calculation of compensation capability and group capability, the technique of cross - zero switched on / off capacitors or reactor, the solution of avoiding possible resonance in switching on / off groups of capacitors or reactor and the measure of the best time to switch ( including the design of the computer survey and control system, instrument deliver system, delay operate and protect system ). although thyristor as a no - contact switch can avoid almost the problem of contact switch with contact, it can not solve the over - voltage, over - current and transient process itself as switching on / off capacitors or reactor. so we must develop a set of thyristor - switched control and protect system with great reliability so that it can realize of cross - zero switching on / off capacitors or reactor at any time

    晶閘管具有過零、動作快速的特點，本研究以晶閘管為電容器和電抗器的分組投切開關，重點研究了協調變壓器二次電壓的選擇、晶閘管觸發控制及保護、動態補償容量及分組容量的計算確定、過零投切電容器和電抗器技術的實現、以及分組投切電容器和電抗器可能發生諧振的處理計算方法，給出實現最佳補償投切選擇方法（測控系統、儀表變送系統、操作和保護系統的設計步驟） ，研製了一套高可靠性晶閘管觸發控制及保護系統，實現對無功的靜止可調補償。
  9. In addition, there is 8 on - off signal data input ( di ) passways ( 24 vdcs light separate ) ; 8 on - off signal isolated data output ( do ) passways ( contact without power, 1a / 220v ) ; 4 analog signal data output passways ( 4 ~ 20ma ), every of them can be set as a certain analog signal ' s close ring control output passway

    另外，還有8路開關量輸入（ di ）通道（ 24vdc光隔） ； 8路隔離開關量輸出（ do ）通道（無源觸點， 1a 220v ） ； 4路模擬量輸出（ 4 20ma ）通道，每一路均可設定為某一路模擬量輸入的閉環控制輸出。
  10. The voltage is manually regulated by non - load machine switch, which is apt to be burnt. as a result, frequent fixing is inevitable ; moreover, these methods of controlling cannot meet the needs of processing certain work pieces

    電壓調節通過人工轉換無載分接開關機械觸點實現，造成無載分接開關容易燒壞，維修頻繁，並且溫度波動大，有時不能滿足某些工件的加工要求。
  11. In the approach, non - load machine switch is replaced by scr controlled by mpu to regulate the temperature. this control precision is greatly improved, and at the same time parameters can be automatically stored and displayed during the manufacturing process, it also included some other auxiliary controlling functions, such as over - temperature alarm, work piece input or output reminding, etc. the fuzzy pid control algorithm consists of fuzzy control and digital pid adjustment

    針對鹽浴變壓器只能進行無載分接、有級調節的問題，本方案採取在變壓器原邊串接晶閘管的方法，將手動轉換的溫度控制，即無載分接開關機械觸點調節電壓改為單片機自動控制晶閘管的導通，將手動控制溫度改為模糊pid控制，從而提高了控制精度，降低了工人勞動強度。
  12. Analog quantity output dc 420 ma, load resistance 500 relay output max ac 250 v, 3a 1a contact when resistive load

    開關量輸出輸出一對無源常開觸點開關報警時閉合，觸點動作同步
  13. The contactless hall effect - based measuring principle gives the pressure switch extremely good repeatability and longevity, even with extremely high load change frequencies. the adjusting screws allow the switching points of the magswitch

    符合無觸點霍耳效應測量原理使得這種壓力開關即使在極高負載變化頻率條件下也具有卓越的可重復性和壽命。
  14. The contactless measuring method based on the hall effect combines excellent switching accuracy with high stability, even under high load alternations

    基於霍爾效應的無觸點測量方法結合了極高的開關精度和即使在高負載變化下也具有的高穩定性。
分享友人
分享到 Line

分享到臉書