焦料比 的英文怎麼說

中文拼音 [jiāoliàobǐ]
焦料比 英文
coke and raw material feeding ratio
  • 焦 : Ⅰ形容詞1 （物體受熱失去水分 呈現黃黑色並發硬、發脆） burnt; scorched; charred 2 （著急） worried;...
  • 料 : 名詞1 （材料; 原料） material; stuff 2 （喂牲口用的穀物） feed; fodder 3 （料器） glassware 4 （...
  • 比 : Ⅰ動詞1 （比較; 較量高下、 長短、距離、好壞等） compare; compete; contrast; match; emulate 2 （比...
  1. In recent years at iron - making plant of pangang, the coke ratio of pig iron has reduced evidently by insisting on “ burden preparation ” course, improving quality of sinter, raising wind temperature, increasing rich oxygen quantity and injecting abundant pulverized coal into bf. the solid fuel consumption of sinter has been decreased greatly through insisting on using high - quality calces, practising high feed sintering, actualizing many techniques in solving key problems. at the same time, the energy source base management has been strengthened, and energy - saving work has made great progress, profits generated by energy - saving have exceeded a hundred million yuan

    近年煉鐵廠通過堅持「精料」方針，改善燒結礦質量，提高風溫，增大富氧，實施大噴煤，使入爐焦比有明顯下降；燒結堅持用好生石灰，推行厚料層燒結，實施多項技術攻關，固體燃耗大幅度下降；同時加強能源基礎管理，節能工作取得長足進步，節能創效益1億元以上。
  2. Wood is charred by exposure to thermal radiation, the depth of the char being closely proportional to the radiant exposure.

    木料受到熱輻射照射后就會燒焦，燒焦的深度大致上與輻射照射成正比。
  3. The destructive distillation of bituminous coal, done in the absence of air in order to obtain coke and other fractions having a greater percentage of carbon than the original material

    碳化作用煙煤的分解蒸餾，在沒有空氣的條件下進行，為得到比最初的原料所含碳的百分比大得多的焦煤以及其它餾分
  4. Since the dichromated gelatin has a higher diffraction efficiency in all holographic recording materials, the aim of this research is to use dichromated gelatin as the recording material and to make use of the principle of holography to design holographic optical components, especially in fabrication procedure of dichromated gelatin film and in experimental technique to form a high diffraction efficiency using different angular exposure method

    為了產生優質的聚焦能力與效率，本研究採用目前具有最高繞射效率（ 80 ~ 90 % ）的重鉻酸明膠材料作為感光劑，除了自行調制藥劑比例成分，並依嚴格的製作步製成重鉻酸明膠全像片外，並採用不同角度重覆曝光方式改良干涉式波帶板無法自動追蹤的缺點，經過多次試驗與改進，藉以形成具備高繞射效率和自動追蹤功能的全像光學波帶板。
  5. The graphitized cathode block samples have been trial - produced using high quality eca ( electrically calcined anthracite ) rationed petroleum coke and pitch coke and quantitative pitch used as raw materials by the conventional carbon technics concluding moulding, baking, high pressure impregmating, after - baking and graphitization

    摘要選取優質電煅無煙煤，分別配以一定比例的石油焦和瀝青焦作為骨料，與煤瀝青混合后按照模壓成型、焙燒、高壓浸漬、二次焙燒和石墨化等常規炭素製品生產工藝流程制備石墨化陰極材料試樣。
  6. Abstract : coke saving measures in the recent ， years at pangang are summarized according to various ways of beneficiated materials ， high blast temperature ， oxygen - enriched blast ， pulverized coal injection rate and improvement of blast furnace operation ， the effect of related smelting factors on coke rate is investigated in combination with the production data and moreover further measures for reduction of coke rate are proposed

    文摘:從精料、風溫、富氧和噴煤量以及改善高爐操作等方面總結了攀鋼近幾年來採取的節焦措施，並結合生產數據分析了有關冶煉因素對焦比的影響，同時提出了進一步降低焦比的措施。
  7. It shows that with a metallization degree of burden more than 40 per cent, blast furnace can t be operated with oxygen enriched blast. combining lower burden metallization degree with oxygen enriched blast and coal injection, higher coal injection rate and higher productivity can be obtained. by use of higher burden metallization degree lower coke rate can be obtained than oxygen enriched blast and coal injection

    結果表明：爐料金屬化率達到40后，高爐不能富氧操作；較低的爐料金屬化率與富氧噴煤相結合，能夠獲得更大的噴煤比和更高的產量；使用金屬化率較高的爐料，能夠比富氧噴煤達到更低的焦比。
  8. Abstract : according to material and local heat balance in the blast furnace, refering to the result of oxygen enriched blast and coal injection into blast furnace and use of metallized burden, the influence of burden metallization degree on oxygen enriched - coal injection rate 、 coke rate and productivity is calculated

    文摘:根據高爐物料平衡和區域熱平衡理論，參照高爐富氧噴煤和使用金屬化爐料的冶煉結果，計算了爐料金屬化率對富氧噴煤率、焦比和產量的影響。
  9. An economic and technological comparison is made of methanol units based on anthracite, coke oven gas and bituminous coal, the conventional process is adopted, and the whole unit is optimized, thereby lowering the production cost of methanol, with remarkable competitive superiority on the market

    通過對以無煙煤、焦爐氣、煙煤為原料甲醇生產裝置的經濟技術對比，採用傳統工藝並對全裝置進行優化，可以降低甲醇生產成本，在市場中仍具有顯著的競爭優勢。
  10. Ruburning with coal has been proved a effective low nox emission combustion technology 。 in this ph. d thesis, the reaction mechanisms of reburning have been investigated, and the homogeneous and heterogeneous reduction of nox have been analyzed in details. a series of reburning experiments have been carried out on an entrained - flow reactor, in which two kinds of coals with different particle sizes have been used

    本文對煤粉再燃過程中，揮發分及煤焦的基元反應途徑和反應機理進行了詳細分析；在攜帶爐實驗臺上進行了神華煤、邢臺煤在1200與1300 、四種煤粉細度、三種再燃燃料比和三種再燃區初始氧量，共144個實驗工況下的再燃實驗。
  11. Tar content in the gas was influenced by the gasification conditions, such as the gasification temperature, residence time of feedstock in the gasifier and the type of feedstock, which can help us to investigate the mechanism of tar production in gasification process. catalytic cracking of tar was performed in a downstream secondary fixed - bed cracker with dolomite, limestone and alumina brick as catalysts. by comparison, thermal cracking of tar was also performed with silica carbide

    在固定床二級催化裂化反應器上，實驗了白雲石、石灰石、高鋁磚等幾種催化劑作用下的焦油催化裂化過程以及炭化硅作用下的熱裂化過程，並對裂化溫度（ 650 950 ） 、氣相停留時間（ 0 . 5 1s ）和催化劑類型等過程參數對焦油轉化效果和熱解煤氣的影響進行了分析，對各種催化劑材料的性能進行了比較，力爭開發出可適用於工業化生物質氣化系統的焦油催化裂化技術。
  12. The result indicated that the hydrotreated delayed coking naphtha was qualified for reforming feedstock, its blending ratio could be up to 35 %

    結果表明，焦化汽油加氫精製后可作重整原料，且摻煉比可達35 % 。
  13. Abstract : to find the way out for delayed coking naphtha and to solve the shortage of catalytic reforming feedstock, tests were conducted in the reformer at anqing general petrochemical works, with feedstock of deeply hydrotreated delayed coking naphtha blended with different proportion of straight - run naphtha

    文摘:為尋求焦化汽油出路和緩解催化重整裝置原料不足的矛盾，安慶石化總廠對焦化汽油深度加氫精製后以不同比例調入直餾油作重整原料進行工業試驗。
  14. 3. when table sugar was used as starting materials, it was used and pyrolyzed directly or was first mined with sulphuric acid after surface area of those materials is not larger than that of pas capacity is small in their electric double - layer capacitor, specific surface area has great effect on capacity, the larger specific surface area is, the higher capacity is, . but bulk density will decrease with increase of specific surface area

    當以食糖為熱裂解碳的原料時，採用直接焦化和酸洗焦化兩種方式。所制備的樣品比表面積沒有聚並苯材料的大，在以30 h _ 2so _ 4為電解質的雙電層電容器中，容量相對較小。電極活性物質的比表面積對雙電層電容器的容量有很大的影響。
  15. The main work lists as following : 1 on the condition that cfrc is an macroscopically isotropic material, the governing equations of electric and thermal conduction for the inspection were established ; the current density and joule heat distribution around several kinds of flaws were investigated 2 by fem, the process of inspection was simulated ; the current density, joule heat and temperature distribution were also investigated, and the simulation results were contrasted with experimental data

    主要工作為： 1 、將機敏混凝土合理假定為宏觀各向同性材料的基礎上，建立了檢測過程中的熱、電傳導相關的控制方程；並研究了幾種不同缺陷周圍檢測過程中的電流密度、焦耳熱分佈規律。 2 、通過有限元方法對機敏混凝土的電熱場進行了模擬分析，研究電流密度、焦耳熱分佈及試件表面溫度分佈變化規律並與實驗所得試件表面溫度場進行了對比分析研究。
  16. With the rapid progress of materials science, petroleum coke shows unique value in producing advanced materials, including high surface area activated carbon, nanometer sized carbide, advanced composite materials, electrorheological fluids, and electrodes for lithium ion batteries

    在快速發展的材料科學中，石油焦作為碳源材料顯示出獨特的作用，可以用來制備包括高比表面積活性炭、納米碳化物材料、先進復合材料、電流變材料和鋰離子電池負極材料等在內的新材料。
  17. As of dec. 1, 2004, 5. 0 - megapixel class dsc with built - in lens system, 8x zoom or greater

    與所有內置8倍或以上變焦功能的500萬像素數碼相機比較，資料截至2004年12月1日為止。
  18. Carbonaceous materials for the production of aluminium. calcined coke and calcined carbon products. determination of the density in xylene. pycnometric method

    鋁生產用碳質材料.煅燒焦炭和煅燒製品.二甲苯密度測定.比重瓶法
  19. The telephoto lens system consisted of only two pieces of optical elements made of fk1 glass has an equivalent optical performance to the traditional telephoto lens system made of five pieces of optical elements made of defferent kinds of glass

    給出了僅使用1種材料fk1 、 2片型的長焦物鏡系統設計結構，並將此設計結果與傳統的5片型、 5種材料的純折射長焦物鏡的光學性能進行了比較。
  20. Preparation of steel substrates before application of paints and related products. surface roughness characteristics of blast - cleaned steel substrates. part 3 : method for the calibration of iso surface profile comparators and for the determination of surface profile. focusing microscope procedure

    塗料和有關產品使用前鋼基片的制備.噴丸處理鋼基片的表面粗糙度特性.第3部分: iso表剖面比較儀的校準方法和表剖面的測定方法.顯微鏡的調焦程序
分享友人
分享到 Line

分享到臉書