熔態的 的英文怎麼說

中文拼音 [róngtàide]
熔態的 英文
molten
  • 熔 : 動詞（熔化） melt; fuse; smelt
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 的 : 4次方是 The fourth power of 2 is direction
  1. The main results are shown as follows : 1. bt _ 4 doped with cuo could be sintered in a lower temperature, because cuo has a low melting point. there isn ’ t any other phase in the samples. the dielectric properties decreased because cuo was non - crystalloid

    本人工作的主要研究成果如下: 1 . bt _ 4摻雜低熔點的cuo能降低樣品的燒結溫度，沒有其他相生成，燒結后cuo以無定形態的形式存在，導致樣品介電性能降低。
  2. Protective clothing - footwear and gaiters for use in molten metal foundries - requirements and test methods

    防護服裝.熔態金屬鑄造車間中使用的鞋靴和護腿.要求和試驗方法
  3. Using the thermodynamic conditions describing the coexistence of two phases and the stability conditions of equilibrium state, we have calculated the normalized temperature and the normalized pressure of the triple point ( t1, p1 ), the melting curve, vapouring curve and the sublimation curve. the whole phase diagram of the 2d monatomic l - j system is obtained

    和杜宜瑾等人的方法類似，我們先給出了系統在相變點時的一些參數的數值，在此基礎上，考慮占據率q的因素，利用相平衡的熱力學條件及平衡態的穩定性條件，得到了二維單元l - j系統的熔化曲線、汽化曲線、升華曲線以及三相點的位置，從而給出了該系統的完整的三相圖。
  4. 5, both melting point ( tm ) and isotropization temperature ( tj ) of all the three series compounds change regularly with the carbon numbers of the end alkoxy group increased. there is a gradual increase in smectic phase length and in the smectic - nemetic transition temperature. at the same time there is a gradual decrease in nemetic phase length

    五，三個類型化合物16ia至16id 、 16ila至16lid 、 17ia至17id 、 17ila至17lid 、 18ia至18id和18ila至18lid的熔點和液晶態的清亮點均化合物分子中末端烷氧基增大逐漸降低；近晶相的溫度范圍和近晶相一向列相轉變溫度逐漸增大，而向列相的溫度范圍遞減。
  5. Glass wool is the glass molten state law centrifugal injection process fibrosis and spraying thermosetting resin made from filamentous material, through the thermal curing deep processing, multiple applications can be made with a series of products

    玻璃棉是將熔融狀態的玻璃用離心噴吹法工藝進行纖維化並噴塗熱固性樹脂製成的絲狀材料，再經過熱固化深加工處理，可製成具有多種用途的系列產品。
  6. Time - temperature superposition principle could bee applied to g " dependence on cd, and the dependence of shifted factor at on temperature demonstrated a linear relationship by a plot of in at vs. t - 1. the steady rheological measurements for nanocomposites melts were conducted. the results revealed that the melts of exfoliated nanocomposites with lower loading of org - mmt exhibited shear - thinning even at lower shear rate as compared with polymers filled with common particles, while the melts flow depended weakl

    研究結果表明仁復合體系g 『和動態損耗模量寧的對數關系性呀g 『一109夕， _印維乖溫動態模量滿足時溫疊加原理，頻率移動因子（ at ）的對數與塌度的倒攀即種馬與了一『有良好的線性關系?一_面，復合體系熔體的穩態剪切流變行為具有不同於普通粒子填充聚合性。
  7. Combine the digestive biscuits and melted butter

    把消化餅乾和熔化態的黃油攪和在一起。
  8. Moreover, the heredity of al and al alloys own structure morphologies has been discussed. block or flack - like tial and bar - like or particles tib2 can be obtained by means of fluoride salt method melting at 800 c ~ 1100c under the other same condition

    用氟鹽法制備中間合金時，在其它條件相同的情況下，改變熔煉溫度（ 800 1100 ）可以得到含有塊狀和針片狀形態的tial _ 3晶體和條狀與顆粒狀tib _ 2化合物的中間合金。
  9. But there are some technical difficults for the welding of aluminium alloy such as some broken bits being easily found, a large welding distortion can happen easily, hard to distinguish the difference between the solid metal and liquid metal colour, hard to control the temperature, a lot of air holes can be seen in the welding line and so on

    但是鋁合金熔化焊時的技術難點在於：焊接時易引起夾渣，焊接變形大，金屬的固態和液態的色澤不容易區別，焊接操作時控制溫度困難，容易產生氣孔等等。如果焊前清理工作不是很好，檢測氣孔往往超標。
  10. Being fine, homogeneous and free of melting, the powder prepared by mechanical alloying has applied to develop scattering strengthen - material, magnetic material, high - temperature material, superconductivity material, amorphous, and non - equilibrium material, compound material etc. as a high - tech technology to prepare alloying powder, ma has become a more and more important method for preparing new materials

    機械合金化法制備的粉末晶粒細小、成分均勻，且能避免熔化過程，已用於開發研製彌散強化材料、磁性材料、高溫材料、超導材料、非晶、準晶、納米晶等各種狀態的非平衡材料、復合材料、輕金屬高比強材料、儲氫材料、過飽和固溶體等。作為制備合金粉末的非平衡高新技術，越來越成為一種制備新材料的重要方法。
  11. Urea granules are coated with liquid sulfur under suspension and recycle conditions. the coating is well proportioned to achieve the even controlled release of the nutrients

    全封閉狀態下，尿素顆粒在循環和懸浮的條件下完成熔硫的塗膜過程，保證每個尿素顆粒塗膜均勻，實現對氮元素的養分控制釋放。
  12. In this paper the formula, the technics, the dosage of the filler and the macromolecule coupling agent are studied which influence the technics condition, mechanical properties, structure configuration. also x - ray large angle diffraction, scan electron microscope, dta etc are used to analysis and test the properties of the pp / talc composites. conclusions as follows : 1

    本文系統地研究了復合體系配方、工藝方法、填料及偶聯劑用量對復合體系工藝條件、力學性能及結構形態的影響，同時利用廣角x射線衍射、掃描電鏡、 dta等對復合體系的性能進行了測試與分析，主要研究內容及結論如下： 1滑石粉的加入，雖然使pp的熔化時間增加，但是混煉能耗下降，有利於pp的加工；偶聯劑的加入，使pp的熔化時間增加，能耗略有降低，總體而言，對加工無不利影響。
  13. This is a superheated hyper - fluid

    這是一個完全熔化的超液態
  14. The tm and tj of the compounds 17 ii synthesized from the higher tm amdb15c5 is higher than those of compounds 171. it was found that the changes of the liquid crystal phase have corresponding relationship to the photos of all three series of compounds separately

    還發現由熔點高的二氨基二苯並15冠5合成的化合物17ii的熔點和液晶態的清亮點高於山熔點低的二氨基二苯並15冠5合成的化合物171的熔點和液晶態的清亮點。
  15. The adaptability of free - spraying alloy powder made by oneself on induction remelting process was investigated

    研究了自製免噴塗合金粉末對感應重熔方法的適應性，以及重熔工藝參數對重熔層組織狀態的影響。
  16. The integrated system of smelting reduction ironmaking - gasolinesynthesis - electric - ity generation, in which the coal gas produced inthe ironmaking module is first cleaned and then used as the fuel for theelectricity generation module or raw material of the gasoline synthesismodule, can resolve the problem of utilization of tail gas in thesmelting reduction ironmaking and the large investment of gasificationin the integrated gasification combined cycle and gasoline synthesis. taking efficiency, scale and product structure into consideration, the processes of the two - stage smelting reduction ironmaking - combined cycleelectricity generation with coal gas, the two - stage smeltingreduction ironmaking - steam cycle electricity generation with coal gas, the one - stage smelting reduction ironmaking - combined cycleelectricity generation with coal gas, and the one - stagesmelting reduction ironmaking - gasoline synthesis with coal gas - steamcycle electricity generation with tail gas are techno - economicallyfeasible and have the promise of being industrialized

    將熔態還原煉鐵產生的煤氣在凈化后發電或經改質后合成汽油的集成系統可以解決熔態還原煉鐵的尾氣利用問題及聯合循環發電和煤基汽油合成造氣投資成本高的問題.從效率、規模和產品結構各方面考慮，過程模擬結果顯示:二段法熔態還原煉鐵-煤氣聯合循環發電、二段法熔態還原煉鐵-煤氣蒸汽發電、一段法熔態還原煉鐵-煤氣聯合循環發電、一段法熔態還原煉鐵-煤氣合成汽油-尾氣蒸汽發電流程，有實現產業化的可能
  17. The specific heat on undercooled liquid state is linear with temperature, and it is the prolongation by extrapolating the curve of the specific heat on stable liquid to lower temperature. in the vicinity of the melting point, no uncontinuity is found

    過冷狀態下熔體的比熱與溫度呈線性關系，且為過熱熔體比熱曲線向低溫方向的延伸，在熔點附近未發現比熱的不連續性。
  18. Differential scanning calorimeter ( dsc ) combined with melt fluxing technique was used to realize undercooling of melt and its specific heat was measured at the same time, and its thermodynamics were calculated simultaneously and compared to four well - known models

    本文將差示掃描量熱法（ dsc ）和助熔劑處理技術相結合，研究了熔體的過冷現象，測量了過冷狀態下熔體的比熱，計算了過冷熔體凝固過程中的其它熱力學參數，並與四種近似模型進行了比較分析。
  19. The compounds with symmetric structure and different size crown ether rings, 16 and 18, have higher tm and tj than those of the compounds 17 with the asymmetric structure. the tm and ti of compounds 18 is higher than the compounds 16

    含有對稱結構和不同大小冠醚環的化合物， 16和18 ，它們的熔點和液晶態的清亮點高於含有不對稱冠醚環的化合物17 ，且化合物18的熔點和液晶態的清亮點也高於化合物16的熔點和清亮點。
  20. Following these two examples of two and three phases, regarding ternary and quarternary metallic melts involving eutectic as melts consisting of three and four non - homogeneuos solutions correspondingly, and using thermo - dynamic parameters of binary metallic melts involving eutectic, calculating models of mass action concentrations for ternary symmetrical melts formed from similar metastable compounds, ternary unsymmetrical melts formed from unsimilar metastable compounds and quarternary metallic melts involving eutectic have been formulated

    仿照這兩個二、三相熔體的例子，將含共晶體三、四元金屬熔體看作由3 ， 4個溶液組成的非均相熔體，並利用含共晶體二元金屬熔體的有關熱力學參數，針對由同類亞穩態化合物組成的對稱型三元系、不同類型亞穩態化合物組成的非對稱型三元系及四元系含共晶體金屬熔體，制定了相應的作用濃度計算模型。
分享友人
分享到 Line

分享到臉書