熔絲特性 的英文怎麼說

中文拼音 [róngsītèxìng]
熔絲特性 英文
fuse characteristics
  • 熔 : 動詞（熔化） melt; fuse; smelt
  • 特 : Ⅰ形容詞（特殊; 超出一般） particular; special; exceptional; unusual Ⅱ副詞1 （特別） especially; v...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 特性 : characteristic（s）; character; performance; features; properties; behaviour; response; character...
  1. Abstract : the formation technologies, the structure and properties of tcs microporous man - made yarn - kind new polyester fibre which was spinned in tcs with some micrometallic - oxide have been studied. the results indicate that the rheological behaviour and spinnability of commixed polyester melt, and the structure and properties of the fibre, are relative to the spinning temperature, melt pressure, microporpus size for spinning, formation conditions, thermo - vascellum temperature, thermo - vascellum position and rolling speed, besides the viscosity of polyester cuts, coacervation particles, adding amount and size of micrometallic - oxide

    研究表明， tcs微孔化共混聚酯熔體在成型加工中的流變行為和可紡性，及其纖維的結構性能除了與原料切片的特性粘度、凝聚粒子和共混聚酯中超細金屬氧化物微粒的添加量、粒徑等因素的影響有關外，還與紡絲溫度、紡絲熔體壓力、噴絲板微孔尺寸、冷卻成形條件、熱管溫度、熱管安裝位置以及卷繞速度等因素的影響密切有關。
  2. Using the traits of arc adjust itself of the co _ 2 welding, adopting slow - descending feature or even feature of electrical source equipping with system that delivering the welding rod at the invariable speed, then, the arc burning steadily is realized, and the quality of welding is improved

    利用co _ 2氣體保護焊電弧的自身調節特性，採用緩降或平硬特性的電源配等速送絲系統，通過改變電源空載電壓來調節電弧電壓，再利用電弧電壓和熔化速度之間的關系調節焊絲熔化速度使之等於送絲速度，最終實現電弧的穩定燃燒。
  3. Mainly made of super - fine three - dimensional staple fibers and mixed with some polyester staples of low melting point and finished products scarcely containing glue materials. after being calenderized and ironed, the product get smooth surface, silk - like glittering effect, light and exquisite hand feeling, softness, heat preservation, good washing endurance, no distortion and leaking. it feels like down but with fine tenacity and is the best among all spray bond padding products

    用超細三維中空短纖維為主要原料，配以部分低熔點滌綸短纖，成品含膠量極少，經過軋光燙平后，仿絲綿表面平整、有絲光、輕薄、手感細膩、柔軟、保溫好、耐水洗性極強、不易變形、不會跑毛、手感似羽絨，具有質地纖細、表面如蠶絲、有拉力、柔軟等特點，是噴膠棉中最高擋的產品。
  4. The dcep mig has the characteristic of deeper penetration which can reduce defective fusion and good arc stabilization. the dcen mig has the characteristic of shallow penetration of welding seam, and the welding wire has a high melting speed. so the variable polarity pulsed mig is a new technology for the welding of aluminium alloy sheet

    變極性脈沖mig焊是一種新的焊接工藝方法，其綜合了dcep脈沖mig焊熔深較大、可以減少焊縫的熔合不良、電弧穩定性好和dcenmig焊焊縫熔深淺、焊絲熔化速度較快的特點，減小了焊縫的熔深，增加了焊絲的熔化速度，是一種適合於薄板鋁合金焊接的新方法。
  5. The heating element is made by using the imported ni - cr alloy thread as the heating material and banded with the aluminum radiation slip outside which makes a very good radiation effect. using the temperature controller and heat fuser to make the product more safe and reliable. the heater has the good characteristic for using ptc material and so many air - conditioner enterprises adopt this kind of heaters as the secondary heating

    採用進口鎳鐵合金絲為發熱材料製作而成的發熱元件，發熱管外鑲鋁散熱片，其散熱效果非常好，加熱器配用溫度控制器和熱熔斷器，使產品使用更安全可靠，加熱器具有ptc材料的良好特性，一些空調器均採用此類加熱器作為輔助加熱。
分享友人
分享到 Line

分享到臉書