熔鹽電解 的英文怎麼說

中文拼音 [róngyándiànjiě]
熔鹽電解 英文
electrolysis of molten salts
  • : 動詞(熔化) melt; fuse; smelt
  • : 名詞1. (食鹽; 鹽類) salt 2. (姓氏) a surname
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 解動詞(解送) send under guard
  • 電解 : electrolyze; electrolysis; electrolyzation; galvanolysis 電解銅 [冶金學] electrolytic [cathode] c...
  1. Study on recovery of scrapped molten salt in re electrolysis

    稀土的綜合利用研究
  2. Destroying mechanism of graphic anode in calcium molten salt electrolysis

    熔鹽電解石墨陽極破損機理探索
  3. Oxidation and protection of graphite anode in calcium molten salt electrolysis

    熔鹽電解中石墨陽極氧化及防護
  4. Study on oxidation and protection of graphite anode in calcium molten salt electrolysis

    熔鹽電解石墨陽極破損及防護研究
  5. In chapter 5, the principle of molten carbonate fuel cell power system is introduced. the development of the system, such as the improvement of cell components including electrodes and electrolyte, the fuel processing, the heat recovery, the power conditioning and grid interconnection, the control system and the combine generation

    第五章在簡要敘述了融碳酸燃料池發系統原理后,從以下幾個方面對系統的開發進行了論證:單體元件(極和質)性能的提高,燃料的處理,余熱利用,力調節和並網,燃料池/燃氣輪機/汽輪機聯合發以及系統控制與優化。
  6. Studying the heat - mass transfer and multi - spices electric - chemical reaction, a dynamic temperature model was deduced for molten - carbonate fuel cell stack. the thermal radiation, shift reaction, and the change of gas spices were considered in this model. establishing momentum equation, the paper has developed a 3d temperature and flow fields model for mcfc stack based on cfd technique

    建立了融碳酸燃料池堆內部單體的暫態溫度模型,並考慮了堆的輻射換熱、轉換反應、反應氣體組分變化對溫度場的影響;根據mcfc的微分控制方程組,考慮氣體組分的熱力學性質及動量變化的影響,利用數值分析方法求融碳酸燃料池堆的三維流場與溫度場,分析了各作用因素對融碳酸燃料池堆溫度分佈的影響機制。
  7. Abstract : study is made of the mechanism of carbon impurity in the nd metal during the production of metal nd by molen - salt electrolysis. the main technological factors determing the carbon content in the nd metal product are described

    文摘:在用氧化物熔鹽電解法生產金屬釹過程中,對雜質碳進入金屬釹中的機理及影響產品金屬釹中碳含量的主要工藝因素進行了分析研究。
  8. In conclusion, the application of wilson equation to the calculation of thermodynamic properties of al - based liquid alloys succeeds and a foundation for the theoretical analysis of both the electrolysis and electrorefming of aluminum metallurgy and the development and calculation of process design of al - based alloys is provided

    Wilson方程在鋁基液態合金熱力學性質計算中的應用取得了成功,為鋁冶金的熔鹽電解和原鋁凈化以及鋁基合金的研究開發和工藝設計計算提供了理論分析依據和指導。
  9. Bllt only a little progress has been made in mechanistic study of cathode process due to its compiication in mcfc condition. in general, it is verified and accepted th

    質不存在時,吸附的coz很難從m表面脫附;而當熔鹽電解質存在並且在含氧氣氛f ,強
  10. In the course of selecting oxide additives material in the nickel - ferric spinel based inert anode, both the solubility in the cryolite molted salt of oxide additives and the whole thermodynamics action in electrolyte of oxide additives are discussed in this article, thus to have a comparatively reasonable selection of the nickel - ferric spinel based inert anode material

    在選擇鎳鐵尖晶石基惰性陽極材料氧化物添加劑過程中,不僅探討了氧化物添加劑在冰晶石中的溶度,而且還探討了氧化物添加劑在液中的整個熱力學行為,從而對鎳鐵尖晶石基惰性陽極材料做出了較為合理的選擇。
分享友人